Biomedical subjects

Polymnia Galiatsatou

Publications and source records attributed to Polymnia Galiatsatou.

4 recordsLinked to original sources

PubMed2006

Comprehensive time-lag measurement as a diagnostic and analytical tool for non-Fickian transport studies: a salient porous barrier-gaseous permeant test case.

Concentration-independent permeation of He, Ne and N2 through a porous barrier, specially constructed by multistep compaction of fine "Carbolac" carbon powder, has been studied. Emphasis was placed on measuring a variety of time lags, supplemented with transient permeation and sorption kinetics. Previous time-lag data, restricted to values of a single time-lag parameter, were instrumental in revealing deviations from Fick's law in similar solid barrier-penetrant systems; however, they could only provide indirect evidence as to the nature of the underlying causes, namely, time- or spatial dependence of the relevant transport parameters. Thus, an interpretation in terms of time-dependence (induced by the presence of blind pores) was proposed, predicated on calculations indicating that, in theory, spatial dependence (induced by non-uniform compaction) could be reduced to insignificance by adoption of a suitable multistep powder compaction technique. The comprehensive time-lag analysis approach applied here is a general diagnostic and analytical tool, previously successfully tested on graphite barriers, that can discriminate rigorously between the aforementioned non-Fickian functional dependences, as well as provide additional substantial information in either case. This capability is well illustrated by the results obtained in the system under study here, which provide unequivocal evidence of substantial spatial dependence. Furthermore, it is shown that the predicted functional form of the detected spatial dependence (i) can, in conjunction with an adequate physical model and with the results of a previous theoretical parametric study, account fully for all aspects of the observed non-Fickian time-lag behaviour and (ii) correlates satisfactorily with variation of local porosity across the barrier, detected by a suitable X-ray imaging technique. On the other hand, there is no evidence, from time lags or transient kinetics, of any significant time-dependence attributable to slow filling or emptying of blind pores or to other causes.

Journal Article↗

PubMed2003

Thorium removal by different adsorbents.

The removal of radiotoxic Th(4+) from aqueous solutions has been explored using two different groups of adsorptive materials (e.g. two activated carbons and four zeolites-two natural and two synthetic). The activated carbons were prepared from solvent extracted olive pulp (SEOP) and olive stone (OS) by a two-step physical activation method with steam. They were characterized by N(2) at 77K adsorption, Hg porosimetry and by determination of their iodine number. All carbons prepared are of the H-type (e.g. contain mainly basic surface oxides) confirmed by the results of the Boehm's method. The natural zeolites, clinoptilolite (NaCLI) and mordenite (NaMOR), were pretreated with Na(+) before the adsorption experiments, while the synthetic ones, NaX and NaA, were provided in their commercial sodium form. The natural zeolites, NaCLI and NaMOR, utilized 11.5 and 38.6% of the theoretical ion-exchange capacity, based on Al content, respectively, while NaX and NaA utilized 41.5 and 45.9%, respectively. The activated carbons showed better removal capability than NaCLI. NaMOR, showed comparable results to the carbon originated from OS, but lower removal capability than the carbon originated from SEOP. The synthetic zeolites showed the highest removal ability for thorium ions due to their increased ion-exchange capacity because of their cleaner and larger framework channels and their higher number of ion-exchange sites. The carbons adsorption capacity mainly depends on the content and nature of functional surface groups. The adsorption data were fitted to Langmuir and Freundlich models. The former achieved best fits and was further applied to obtain the respective Langmuir constant and maximum adsorption capacity for each system.

Adsorption↗

PubMed2002

Adsorption of zinc by activated carbons prepared from solvent extracted olive pulp.

Activated carbons have been prepared by a two-step physical activation with steam at different burn-off levels to study the porosity development and its effect in zinc adsorption from aqueous solutions. The main material used was the residual from the extraction with solvent of the kernel-oil [solvent extracted olive pulp (SEOP)]. Olive, apricot and peach stone have been also used as different precursors. The products were characterized by N2 at 77K adsorption, Hg porosimetry and iodine number determination. The influence of surface complexes and pH has been investigated in an attempt to elucidate the adsorption phenomena. The effect of different treatments [demineralization with H2SO4 and oxidation with (NH4)2S2O8] was also evaluated for the adsorption of zinc species. Both basic and acidic carbons, originated from SEOP, show remarkable adsorption ability at solution pH=7. Their adsorption ability mainly depends on the content and nature of functional surface groups, the ash content of the precursors and the pH of the solution. These activated carbons were proved to be efficient adsorbents for the removal of water pollutants and contaminants.

Adsorption↗

PubMed2002

Treatment of olive mill waste water with activated carbons from agricultural by-products.

A series of activated carbons prepared by a two-step steam activation of olive stone and solvent extracted olive pulp (SEOP) have been used in an attempt to investigate the total phenol removal and chemical oxygen demand (COD) decrease in olive mill waste water (OMWW). The temperature of carbonization and activation were kept constant at 850 and 800 degrees C, respectively. One of the carbons was prepared by a single-step process at 800 degrees C. Activated carbons have been characterized by adsorption of N2 at 77 K and mercury porosimetry. Their iodine values were also determined. Surface oxides of activated carbons were determined using the Boehm's method. The porosity development and the surface chemistry of carbons were correlated to increasing removal ability of organic molecules. Kinetics of adsorption was evaluated by applying the Lagegren model while adsorption isotherm data were fitted to Langmuir model. Mesoporosity seems to be the key factor for total phenol removal while micoporosity controls the adsorption of total organics as expressed by the COD decrease in OMWW. For carbons with similar structure, the adsorption of phenols or total organics might be affected by the presence of carbonyls.

Adsorption↗