PubMed Health⌕ Search

Biomedical subjects

Qingbo Meng

Publications and source records attributed to Qingbo Meng.

6 recordsLinked to original sources
PubMed2006

Cheap and environmentally benign electrochemical energy storage and conversion devices based on AlI3 electrolytes.

Cheap and environmentally benign electrochemical energy conversion and storage devices, including a dye-sensitized solar cell (DSSC) using an AlI3-ethanol electrolyte and a new Al/I2 primary battery, are reported. The AlI3-ethanol electrolyte can be prepared simply by adding aluminum powder and iodine into ethanol at ambient conditions. The DSSC using this AlI3-ethanol electrolyte achieved an energy conversion efficiency of 5.9% at AM 1.5 (100 mW/cm-2). In the Al/I2 battery, AlI3 is formed spontaneously when aluminum and iodine electrodes are brought into contact at room temperature. Then I- anions transport across the AlI3 solid electrolyte for further electrochemical reactions.

Journal Article↗
PubMed2006

Effect of iodine addition on solid-state electrolyte LiI/3-hydroxypropionitrile (1:4) for dye-sensitized solar cells.

It was observed that the ionic conductivity of the solid-state electrolyte LiI/3-hydroxypropionitrile (HPN) = 1:4 (molar ratio) decreased dramatically with increasing iodine (I(2)) concentration, which differs from the conduction behavior of the Grotthuss transport mechanism observed in liquid or gel electrolytes. The short-circuit photocurrent density (J(sc)) of the dye-sensitized solar cell (DSSC) based on this electrolyte system increases with increasing I(2) concentration until LiI/I(2) is 1:0.05 (molar ratio). Beyond this limitation, the J(sc) decreases. At low I(2) concentrations (I(2)/LiI < or = 0.05), the J(sc) is mainly affected by the diffusion of I(3)(-). An increase of the I(2) concentration leads to the enhancement of the diffusion of I(3)(-) and an increase of the J(sc). At high I(2) concentrations (I(2)/LiI > 0.05), the factors, including the increased light absorption by the I(3)(-), the increased recombination of electrons at the photoanode with I(3)(-), and the reduced ionic conductivity of the electrolyte, lead to a decrease of J(sc). At the same time, the open-circuit voltage (V(oc)) of the DSSC decreases monotonically with the ratio of I(2)/LiI due to increased dark current in the DSSC. The increased absorption of visible light by the electrolyte, the enhanced dark current, and the reduced ionic conductivity of the electrolyte contribute to the performance variation of the corresponding solid-state DSSC with increasing I(2) concentration.

Journal Article↗
PubMed2005

Solid-state composite electrolyte LiI/3-hydroxypropionitrile/SiO2 for dye-sensitized solar cells.

A new compound, LiI(3-hydroxypropionitrile)(2), is reported here. According to its single-crystal structure (C2/c), this compound has 3-D transporting paths for iodine. Further ab initio calculation shows that the activation energy for diffusion of iodine (0.73 eV) is much lower than that of lithium ion (8.39 eV) within the lattice. Such a mono-ion transport feature is favorable as solid electrolyte to replace conventional volatile organic liquid electrolytes used in dye-sensitized solar cells (DSSC). LiI and 3-hydroxypropionitrile (HPN) can form a series of solid electrolytes. The highest ambient conductivity is 1.4 x 10(-)(3) S/cm achieved for LiI(HPN)(4). However, it tends to form large crystallites and leads to poor filling and contact within porous TiO(2) electrodes in DSSC. Such a drawback can be greatly improved by introducing micrometer-sized and nanosized SiO(2) particles into the solid electrolyte. It is helpful not only in enhancing the conductivity but also in improving the interfacial contact greatly. Consequently, the light-to-electricity conversion efficiency of 5.4% of a DSSC using LiI(HPN)(4)/15 wt % nano-SiO(2) was achieved under AM 1.5 simulated solar light illumination. Due to the low cost, easy fabrication, and relatively high conversion efficiency, the DSSC based on this new solid-state composite electrolyte is promising for practical applications.

Journal Article↗
PubMed2004

Property influence of polyanilines on photovoltaic behaviors of dye-sensitized solar cells.

The influence of polyanilines (PANIs) as hole conductors on the photovoltaic behaviors of dye-sensitized solar cells is studied. The current-voltage (I-V) characteristics and the incident photon to current conversion efficiency (IPCE) curves of the devices are determined as the function of different conductivities and morphologies of PANIs. The results show that the conductivity of PANIs affects the performance of the devices greatly, and PANI with the intermediate conductivity value (3.5 S/cm) is optimum. In addition, the effects of both the film formation property and the cluster size of polyanilines on the photovoltaic behaviors of the devices are also discussed.

Aniline Compounds↗