PubMed Health⌕ Search

Biomedical subjects

R F Curl

Publications and source records attributed to R F Curl.

9 recordsLinked to original sources
PubMed2005

IR kinetic spectroscopy investigation of the CH4 + O(1D) reaction.

The branching of the title reaction into several product channels has been investigated quantitatively by laser infrared kinetic spectroscopy for CH(4) and CD(4). It is found that OH (OD) is produced in 67 +/- 5% (60 +/- 5%) yield compared to the initial O((1)D) concentration. H (D) product is produced in 30 +/- 10%(35 +/- 10%). H(2)CO is produced in 5% yield in the CH(4) system (it was not possible to measure the CD(2)O yield in the CD(4) case). D(2)O is produced in 8% yield in the CD(4) system (it was not feasible to measure the H(2)O yield). The ratio of the overall rate constant of the CD(4) reaction to the overall rate constant of the O((1)D) + N(2)O reaction was determined to be 1.2(5) +/- 0.1. A measurement of the reaction of O((1)D) with NO(2) gave 1.3 x 10(-10) cm(3) molecule(-1) s(-1) relative to the literature values for the rate constants of O((1)D) with H(2) and CH(4). Hot atom effects in O((1)D) reactions were observed.

Journal Article↗
PubMed2002

Chemical sensing with pulsed QC-DFB lasers operating at 15.6 micrometers.

Pulsed thermoelectrically cooled QC-DFB lasers operating at 15.6 micrometers were characterized for spectroscopic gas sensing applications. A new method for wavelength scanning based on repetition rate modulation was developed. A non-wavelength-selective pyroelectric detector was incorporated in the sensor configuration giving the advantage of room-temperature operation and low cost. Absorption lines of CO2 and H2O were observed in ambient air, providing information about the concentration of these species.

Atmosphere↗
PubMed2001

Spectroscopic detection of biological NO with a quantum cascade laser.

Two configurations of a continuous wave quantum cascade distributed feedback laser-based gas sensor for the detection of NO at a parts per billion (ppb) concentration level, typical of biomedical applications, have been investigated. The laser was operated at liquid nitrogen temperature near lambda = 5.2 microns. In the first configuration, a 100 m optical path length multi-pass cell was employed to enhance the NO absorption. In the second configuration, a technique based on cavity-enhanced spectroscopy (CES) was utilized, with an effective path length of 670 m. Both sensors enabled simultaneous analysis of NO and CO2 concentrations in exhaled air. The minimum detectable NO concentration was found to be 3 ppb with a multi-pass cell and 16 ppb when using CES. The two techniques are compared, and potential future developments are discussed.

Breath Tests↗
PubMed2001

Absorption spectroscopy with quantum cascade lasers.

Novel pulsed and cw quantum cascade distributed feedback (QC-DFB) lasers operating near lambda=8 micrometers were used for detection and quantification of trace gases in ambient air by means of sensitive absorption spectroscopy. N2O, 12CH4, 13CH4, and different isotopic species of H2O were detected. Also, a highly selective detection of ethanol vapor in air with a sensitivity of 125 parts per billion by volume (ppb) was demonstrated.

Air Pollution, Indoor↗
PubMed2000

Effective utilization of quantum-cascade distributed-feedback lasers in absorption spectroscopy.

A variable duty cycle quasi-cw frequency scanning technique was applied to reduce thermal effects resulting from the high heat dissipation of type I quantum-cascade lasers. This technique was combined with a 100-m path-length multipass cell and a zero-air background-subtraction technique to enhance detection sensitivity to a parts-in-10(9) (ppb) concentration level for spectroscopic trace-gas detection of CH4, N2O, H2O, and C2H5OH in ambient air at 7.9 micrometers. A new technique for analysis of dense high resolution absorption spectra was applied to detection of ethanol in ambient air, yielding a 125-ppb detection limit.

Air Pollution, Indoor↗
PubMed1999

High-power continuous-wave mid-infrared radiation generated by difference frequency mixing of diode-laser-seeded fiber amplifiers and its application to dual-beam spectroscopy.

We report the generation of up to 0.7 mW of narrow-linewidth (<60-MHz) radiation at 3.3 micrometers by difference frequency mixing of a Nd:YAG-seeded 1.6-W Yb fiber amplifier and a 1.5-micrometers diode-laser-seeded 0.6-W Er/Yb fiber amplifier in periodically poled LiNbO3. A conversion efficiency of 0.09%/W (0.47 mWW-2 cm-1) was achieved. A room-air CH4 spectrum acquired with a compact 80-m multipass cell and a dual-beam spectroscopic configuration indicates an absorption sensitivity of +/-2.8 x 10(-5) (+/-1 sigma), corresponding to a sub-parts-in-10(9) (ppb) CH4 sensitivity (0.8 ppb).

Air Pollution, Indoor↗
PubMed1999

Methane concentration and isotopic composition measurements with a mid-infrared quantum-cascade laser.

A quantum-cascade laser operating at a wavelength of 8.1 micrometers was used for high-sensitivity absorption spectroscopy of methane (CH4). The laser frequency was continuously scanned with current over more than 3 cm-1, and absorption spectra of the CH4 nu 4 P branch were recorded. The measured laser linewidth was 50 MHz. A CH4 concentration of 15.6 parts in 10(6) ( ppm) in 50 Torr of air was measured in a 43-cm path length with +/- 0.5-ppm accuracy when the signal was averaged over 400 scans. The minimum detectable absorption in such direct absorption measurements is estimated to be 1.1 x 10(-4). The content of 13CH4 and CH3D species in a CH4 sample was determined.

Atmosphere↗
PubMed1998

Mid-infrared difference-frequency generation source pumped by 1.1-1.5 micrometer dual-wavelength fiber amplifier for trace-gas detection.

Continuous-wave mid-infrared radiation near 3.5 micrometers is generated by difference-frequency mixing of the output of a compact 1.1-1.5 micrometer dual-wavelength fiber amplifier in periodically poled LiNbO3. The diode side-pumped amplifier is constructed with double-cladding Yb-doped fiber followed by single-mode Er/Yb codoped fiber. Output powers of as much as 11 microW at 3.4 micrometers are obtained, and spectroscopic detection of CH4 and H2CO is demonstrated.

Environmental Monitoring↗