Biomedical subjects

R Koeber

Publications and source records attributed to R Koeber.

3 recordsLinked to original sources

PubMed2001

Evaluation of a multidimensional solid-phase extraction platform for highly selective on-line cleanup and high-throughput LC-MS analysis of triazines in river water samples using molecularly imprinted polymers.

A novel highly selective sample cleanup procedure based on the use of molecularly imprinted polymers (MIPs) as solid-phase extraction materials has been evaluated with respect to its applicability and routine use in environmental analysis. The method comprises the combination of a restricted access material (RAM) and a MIP allowing a selective sample preparation to be achieved in the online mode. This combination is called the size-selective sample separation and solvent switch (six-SPE). The RAM column combines size exclusion and adsorption chromatography, reducing the concentration of matrix molecules by a cutoff of 15 kDa. The MIP column selectively retains the triazine analytes whereas the residual matrix is not retained and separated completely. Thus, the automated RAM-MIP is capable of excluding all matrix and nontarget compounds. The cleaned and enriched extract is subsequently eluted to an HPLC column and analyzed by LC-MS. A complete on-line analysis cycle including multidimensional solid-phase extraction, separation, and detection takes less than 15 min. Terbuthylazine, atrazine, propazine, simazine, ametryn, prometryn, irgarol, and also the metabolites deethylatrazine and deisopropylatrazine can be determined without any matrix interferences, e.g., by humic acids. The whole setup is fully automated and may be continuously operated. Nonspecific interactions with the polymer are below 1% in all cases. The accuracy of the LC-MIP-LC-MS system was controlled using a certified reference material (Aquacheck). The applicability of the method to the cleanup of real samples was demonstrated by injection of contaminated river water samples. The stability of different polymers was tested by consecutive injections, and it was shown that the performance of the materials did not vary even after more than 300 enrichment and desorption cycles.

Journal Article↗

PubMed2000

Isocyanate-specific hemoglobin adduct in rats exposed to 4, 4'-methylenediphenyl diisocyanate.

4,4'-Methylenediphenyl diisocyanate (MDI) is the most important of the isocyanates used as intermediates in the chemical industry. Among the main types of damage after exposure to low levels of MDI are lung sensitization and asthma. Protein adducts of MDI might be involved in the etiology of sensitization reactions. It is therefore necessary to have sensitive and specific methods for monitoring the isocyanate exposure of workers. To date, urine metabolites or protein adducts have been used as biomarkers in workers exposed to MDI. However, with these methods it is not possible to determine if the biomarkers result from exposure to MDI or to the parent aromatic amine 4,4'-methylenedianiline (MDA). This work presents a procedure for quantitating isocyanate-specific hemoglobin adducts. Blood proteins are used as markers of exposure and possibly as markers of dose size for the modifications of macromolecules in the target organs where the disease develops. For the quantitation of hemoglobin adducts, N(1)-[4-(4-isocyanatobenzyl)phenyl]acetamide (AcMDI) was reacted with the tripeptide valyl-glycyl-glycine and with valine yielding N-[4-(4-acetylaminobenzyl)phenyl]carbamoyl]valyl-glycyl-glycine and N-[4-[4-(acetylaminobenzyl)phenyl]carbamoyl]valine, respectively. N-[4-[4-(Acetylamino-3,5-dideuteriobenzyl)-2, 6-dideuteriophenyl]carbamoyl]valine was synthesized from valine, as was N(1)-[4-(4-isocyanato-3,5-dideuteriobenzyl)-2, 6-dideuteriophenyl]acetamide, for use as an internal standard. These adducts were cleaved in 2 M HCl to yield the corresponding hydantoins, 3-[4-(4-aminobenzyl)phenyl]-5-isopropyl-1, 3-imidazoline-2,4-dione (MDA-Val-Hyd) and 3-[4-(4-amino-3, 5-dideuteriobenzyl)-2,6-dideuteriophenyl]-5-isopropyl-1, 3-imidazoline-2,4-dione, respectively. In globin of rats exposed to MDI, MDA-Val-Hyd could be found in a dose-dependent manner. The adduct was identified by HPLC/MS/MS and quantified by GC/MS after derivatization with heptafluorobutyric anhydride. The amount of MDA-Val-Hyd found after acid hydrolysis of globin at 100 degrees C is about 12 times larger than the sum of N-acetyl-4, 4'-methylenedianiline (AcMDA) and MDA obtained from mild base hydrolysis of hemoglobin. The MDA-Val-Hyd is an isocyanate-specific adduct. MDA and AcMDA released after mild base hydrolyses result most likely from a sulfinamide adduct which is a typical adduct of arylamines. According to these results, higher amounts of isocyanate adducts than arylamine adducts should be expected in workers exposed to isocyanates.

Acetanilides↗

PubMed1996

Screening of pesticide-contaminated soil by supercritical fluid extraction (SFE) and high-performance thin-layer chromatography with automated multiple development (HPTLC/AMD).

A method for screening of pesticide-contaminated soil was developed. The extraction is carried out by supercritical carbon dioxide (CO(2)) with methanol as a modifier. The different components of the extracts are separated by high-performance thin-layer chromatography with automated multiple development (HPTLC/AMD) and evaluated densitometrically. The technique can be carried out without any previous clean-up step. Compared with other extraction techniques, SFE has the advantages of reducing the amount of co-extracted soil contents, which can seriously deteriorate the results. A 35-step development of the TLC-plate with gradient elution offers an application over a wide range of polarity. Migration data for 107 pesticides, recoveries and detection limits for 20 pesticides were determined.

Journal Article↗