PubMed Health⌕ Search

Biomedical subjects

Rajni Singh

Publications and source records attributed to Rajni Singh.

6 recordsLinked to original sources
PubMed2005

A simple activity staining protocol for lipases and esterases.

A simple activity staining protocol for rapid detection and differentiation of lipases and esterases was developed based on pH drop due to fatty acids released following lipolysis. Though the detection of lipolysis as a function of drop in pH is not new, the present method has been made more sensitive by the judicious selection of the initial pH of the chromogenic substrate, which has been set near the end point of the dye so that even a slight drop in pH results in immediate color change. In the present case, the dye phenol red was taken, which has the end point at pH 7.3-7.4 where the color is pink. A slight drop due to fatty acid release results in yellow coloration. The assay has high reproducibility and can detect as low as 0.5 p-NPP enzyme units within 15 min. In addition, this method can be used for various lipidic substrates such as oils and tributyrin, making it suitable for both lipases and esterases.

Burkholderia↗
PubMed2005

A solvent tolerant isolate of Enterobacter aerogenes.

A solvent tolerant strain of Enterobacter aerogenes was isolated from soil by cyclohexane enrichment. Presence of cyclohexane (20%) in culture media prolonged the lag phase and caused reduction in biomass. Transmission electron micrographs showed convoluted cell membrane and accumulation of solvent in case of the cells grown in cyclohexane. The Enterobacter isolate was able to grow in the range of organic solvents having log P above 3.2 and also in presence of mercury, thus showing potential for treatment of solvent rich wastes.

Cyclohexanes↗
PubMed2005

Single-step purification of lipase from Burkholderia multivorans using polypropylene matrix.

Lipase from Burkholderia multivorans was purified with high yields directly from fermentation broth by a single-step purification protocol involving adsorption and desorption. The crude enzyme (lyophilized powder) from B. multivorans was loaded on Accurel (Membrana, Germany), a polypropylene matrix, using butanol as the solvent in a buffer at pH 9.0 and ambient temperature for a period of 12 h. The enzyme adsorbed onto the matrix with high specific activity (33 units mg(-1) protein). This was followed by desorption of the enzyme from the matrix using Triton X-100 as the eluent. The enzyme was finally recovered by precipitation with acetone (50%, v/v). Thus, an overall enzyme yield of 66% with a 3.0-fold purification was obtained. The purity of the enzyme was ascertained by SDS-PAGE. The phenomenon of adsorption and desorption on Accurel was studied for three more lipases, viz. Mucor meihei lipase (Sigma-Aldrich Co.), Lipolase (Novo Nordisk, Denmark) and Pseudomonas aeruginosa lipase (laboratory isolate).

1-Butanol↗
PubMed2005

Keratinolytic potential of Bacillus licheniformis RG1: structural and biochemical mechanism of feather degradation.

Keratinolytic Bacillus licheniformis RG1 was used to study the mechanism of keratinolysis. Scanning electron microscopy studies revealed that bacterial cells grew closely adhered to the barbules of feathers, completely degrading them within 24 h. Biochemical studies indicated that the Bacillus strain produced an extracellular protease, which had keratinolytic potential. The extracellular keratinolytic activity (425 U) was synergistically enhanced by the addition of intracellular disulfide reductases (1712 U). However, these enzymes alone (keratinase and disulfide reductase), without live bacterial cells, failed to degrade the feather. Complete feather degradation was obtained only when living bacterial cells were present, emphasizing that bacterial adhesion plays a key role during the degradation process. The bacterial cells probably provide a continuous supply of reductant to break disulfide bridges. In addition, sulfite detected in the extracellular broth during feather degradation indicated that sulfitolysis may also play a role in feather degradation by the bacterium.

Animals↗
PubMed2004

Purification of recombinant green fluorescent protein by three-phase partitioning.

The technique of three-phase partitioning (TPP) was used to purify the green fluorescent protein (GFP) in a single step. TPP uses a combination of ammonium sulphate and tert-butanol to precipitate proteins from their crude extracts. In the first round of TPP with 20% ammonium sulphate saturation at the ratio of crude to tert-butanol 1:1 (v/v), most of the GFP remains in the lower aqueous phase. When subjected to a second round of TPP with 60% ammonium sulphate saturation at the ratio of crude to tert-butanol 1:2 (v/v) gives 78% recovery of GFP with a 20-fold purification. The sodium dodecyl sulphate-polyacrylamide gel electrophoretic (SDS-PAGE) analysis of purified preparation shows single band. The fluorescence excitation and emission spectra agreed with values reported in literature.

Electrophoresis, Polyacrylamide Gel↗