Biomedical subjects

Robert A Walker

Publications and source records attributed to Robert A Walker.

11 recordsLinked to original sources

PubMed2006

Surface vibrational structure at alkane liquid/vapor interfaces.

Broadband vibrational sum frequency spectroscopy (VSFS) has been used to examine the surface structure of alkane liquid/vapor interfaces. The alkanes range in length from n-nonane (C(9)H(20)) to n-heptadecane (C(17)H(36)), and all liquids except heptadecane are studied at temperatures well above their bulk (and surface) freezing temperatures. Intensities of vibrational bands in the CH stretching region acquired under different polarization conditions show systematic, chain length dependent changes. Data provide clear evidence of methyl group segregation at the liquid/vapor interface, but two different models of alkane chain structure can predict chain length dependent changes in band intensities. Each model leads to a different interpretation of the extent to which different chain segments contribute to the anisotropic interfacial region. One model postulates that changes in vibrational band intensities arise solely from a reduced surface coverage of methyl groups as alkane chain length increases. The additional methylene groups at the surface must be randomly distributed and make no net contribution to the observed VSF spectra. The second model considers a simple statistical distribution of methyl and methylene groups populating a three dimensional, interfacial lattice. This statistical picture implies that the VSF signal arises from a region extending several functional groups into the bulk liquid, and that the growing fraction of methylene groups in longer chain alkanes bears responsibility for the observed spectral changes. The data and resulting interpretations provide clear benchmarks for emerging theories of molecular structure and organization at liquid surfaces, especially for liquids lacking strong polar ordering.

Journal Article↗

PubMed2006

Structure and organization of hexadecanol isomers adsorbed to the air/water interface.

The structure and 2D phase behavior of hexadecanol isomers adsorbed to the air/water interface have been studied using surface tension methods and vibrational sum frequency spectroscopy. Isomers include the linear 1-hexadecanol as well isomers with the alcohol functional group in the 2, 3, and 4 positions. Surface-pressure isotherms highlight how the 2D phase behavior of these monolayers depends sensitively on registry and packing efficiency between the alkyl chains whereas vibrational sum frequency spectroscopy, which is vibrational spectroscopy with surface specificity, reveals details about the molecular structure and orientation of molecules within the monolayer films at their equilibrium spreading pressures. At their equilibrium spreading pressures, both 1- and 2-hexadecanol form compact films having a high degree of conformational order and molecular areas of 18.9 and 21.5 A(2)/molecule, respectively. This result for 2-hexadecanol implies that the isomer remains primarily in an all-trans conformation with the methyl group in the C(1) position buried in the water subphase. This conformation leads to significantly reduced intensity in specific vibrational transitions due to partial destructive interference. In contrast, 3-hexadecanol and 4-hexadecanol form more expanded monolayers at their equilibrium spreading pressures, having areas of 28.7 and 40.3 A(2)/molecule, respectively. In these monolayers, the intensities of selected vibrational bands show less evidence of destructive interference, implying that methyl groups on opposite ends of the adsorbates do not adopt strongly correlated orientations.

Adsorption↗

PubMed2006

High-temperature Raman spectroscopy of solid oxide fuel cell materials and processes.

Chemical and material processes occurring in high temperature environments are difficult to quantify due to a lack of experimental methods that can probe directly the species present. In this letter, Raman spectroscopy is shown to be capable of identifying in-situ and noninvasively changes in material properties as well as the formation and disappearance of molecular species on surfaces at temperatures of 715 degrees C. The material, yttria-stabilized zirconia or YSZ, and the molecular species, Ni/NiO and nanocrystalline graphite, factor prominently in the chemistry of solid oxide fuel cells (SOFCs). Experiments demonstrate the ability of Raman spectroscopy to follow reversible oxidation/reduction kinetics of Ni/NiO as well as the rate of carbon disappearance when graphite, formed in-situ, is exposed to a weakly oxidizing atmosphere. In addition, the Raman active phonon mode of YSZ shows a temperature dependent shift that correlates closely with the expansion of the lattice parameter, thus providing a convenient internal diagnostic for identifying thermal gradients in high temperature systems. These findings provide direct insight into processes likely to occur in operational SOFCs and motivate the use of in-situ Raman spectroscopy to follow chemical processes in these high-temperature, electrochemically active environments.

Letter↗

PubMed2006

Fuel oxidation efficiencies and exhaust composition in solid oxide fuel cells.

Solid oxide fuel cells (SOFCs) are electrochemical devices that rely on ion migration through a solid-state electrolyte to oxidize fuel and produce electricity. The present study employs Fourier transform infrared spectroscopy to quantify the exhaust of an SOFC operating with fuel flows of methane over Ni/YSZ cermet anodes and butane over Ni/YSZ and Cu/CeO2/YSZ cermet anodes. Data show that hydrocarbon fuels can participate in a variety of different reactions including direct electrochemical oxidation, various reforming processes, and surface-catalyzed carbon deposition. These findings have direct consequences for assessing the environmental impact of SOFCs in terms of the exhaust discharged from devices operating with common hydrocarbon fuel feeds. In the work presented below, a measure of fuel oxidation efficiency is found by comparing the partial pressure of CO2 (P(CO2)) in the SOFC exhaust to the partial pressure of CO (P(CO)). The fuel anode combination with the largest P(CO2)/P(CO) ratio is the C4H10 over Cu/CeO2 combination (0.628 +/- 0.016). The CH4 over Ni cell type has the second highest ratio (0.486 +/- 0.023). The C4H10 over Ni cell type gives a ratio of 0.224 +/- 0.001. Attempts to balance the carbon content of the fuel feed and exhaust lead to predictions of SOFC fuel oxidation mechanisms.

Hydrocarbons↗

PubMed2005

Solvation of p-nitrophenol at a water/alkane interface: the role of ionic strength and salt identity.

Second harmonic generation (SHG), a surface specific, nonlinear optical spectroscopy, was used to study the interfacial solvation of a neutral surfactant, p-nitrophenol (PNP), adsorbed to the water/cyclohexane interface in the presence of simple salts at varying salt concentrations. The purpose of this work was to determine what relationship (if any) exists between interfacial polarity and bulk solution ionic strength. Data show an apparent red shift in SHG spectra with an increase in salt anion size from fluoride to chloride to bromide at 1 M salt concentrations. A spectral red shift of the PNP electronic excitation implies an increase in local polarity. Within experimental limits, however, these observed interfacial spectral shifts mimic shifts in absorbance spectra observed for PNP in bulk electrolyte solutions. Given the similarities between bulk and surface behavior, we conclude that observed shifts in SHG spectra may be attributed to effects similar to those found in bulk solution. Additionally, the surface adsorption of PNP to the water/cyclohexane interface was studied to determine the surface distribution of PNP and the conjugate base, p-nitrophenoxide (PNP(-)), for a 10 mM PNP solution. PNP adsorption is favored over PNP(-) adsorption by a factor of 10, giving rise to an equilibrium surface distribution that is an order of magnitude greater than that found in bulk solution. These findings indicate that the amount of PNP(-) at the surface in an aqueous solution of 10 mM PNP is negligible.

Alkanes↗

PubMed2005

Structural and compositional characterization of yttria-stabilized zirconia: evidence of surface-stabilized, low-valence metal species.

The structural properties of polycrystalline yttria-stabilized zirconia (YSZ) have been studied using FT-Raman spectroscopy, X-ray diffraction, and X-ray photoelectron spectroscopy (XPS). Yttria content was varied between 8 and 15% (by mole fraction) to determine compositional effects on YSZ phonon structure, lattice parameter, and oxidation state. The dominant feature in the low-frequency Raman spectrum correlates quite closely with the material's sole (cubic) lattice parameter. XPS measurements of typical YSZ samples show only a single species of both Y and Zr. After exposing YSZ to a reducing environment (H2) at elevated temperatures (1000 degrees C), however, the XPS spectra of YSZ show new features at lower binding energy for both Y and Zr. Angle-resolved XPS measurements suggest that these reduced forms of Y and Zr exist only within the first few molecular layers of the sample. This treatment does not effect the XRD pattern, nor does it change the low-frequency phonon structure observed in the Raman spectrum, although the Raman spectrum does experience approximately 50% reduction in overall signal intensity. These disparities are reconciled with each other based on differences in each technique's sampling depth. The impact that surface-reduced YSZ may have on the chemistry occurring within solid oxide fuel cells is discussed briefly.

Journal Article↗

PubMed2005

Global protein expression analysis in apicomplexan parasites: current status.

Members of the phylum Apicomplexa are important protozoan parasites that cause some of the most serious, and in some cases, deadly diseases in humans and animals. They include species from the genus Plasmodium, Toxoplasma, Eimeria, Neospora, Cryptosporidium, Babesia and Theileria. The medical, veterinary and economic impact of these pathogens on a global scale is enormous. Although chemo- and immuno-prophylactic strategies are available to control some of these parasites, they are inadequate. Currently, there is an urgent need to design new vaccines or chemotherapeutics for apicomplexan diseases. High-throughput global protein expression analyses using gel or non-gel based protein separation technologies coupled with mass spectrometry and bioinformatics provide a means to identify new drug and vaccine targets in these pathogens. Protein identification based proteomic projects in apicomplexan parasites is currently underway, with the most significant progress made in the malaria parasite, Plasmodium falciparum. More recently, preliminary two-dimensional gel electrophoresis maps of Toxoplasma gondii and Neospora caninum tachyzoites and Eimeria tenella sporozoites, have been produced, as well as for micronemes in E. tenella. In this review, the status of proteomics in the analysis of global protein expression in apicomplexan parasites will be compared and the challenges associated with these investigations discussed.

Animals↗

PubMed2004

Variability in the human m. spinalis capitis and cervicis: frequencies and definitions.

The spinalis muscle is defined as the medial component of the erector spinae muscle group, and is typically subdivided into three regional components: m. spinalis thoracis, m. spinalis cervicis and m. spinalis capitis. Modern authorities, however, differ on the morphology of the cervicis and capitis portions and many claim that these regional distinctions do not commonly exist. This article reports on the validity of that claim. Three morphological conditions are identified for both m. spinalis capitis and m. spinalis cervicis. The distinct condition has the muscle persisting as an independent muscular unit. The blended condition occurs when the spinalis muscle fibers blend with those of the semispinalis muscle. Finally, there are occasions in which no evidence of spinalis muscle fibers can be found. Frequency estimates are provided for each of these morphological conditions. Results of statistical analyses indicate that there are no relationships among muscle varieties and the sex of the individual or the side of the body where the muscle was found.

Adult↗

PubMed2003

Measuring dipolar width across liquid-liquid interfaces with 'molecular rulers'.

Molecular dynamics simulations have previously described how the physical properties across immiscible liquid-liquid interfaces should converge from aqueous to organic limits, but these predictions have largely gone untested, owing to difficulties associated with probing buried interfaces. X-ray and neutron scattering experiments have created detailed pictures of molecular structure at these boundaries, but such scattering studies cannot probe how surface-altered solvent structures affect interfacial solvating properties. Given that surface-mediated solvent properties control interfacial solute concentrations and reactivities, identifying the characteristic dimensions of interfacial solvation is essential for formulating predictive models of solution phase surface chemistry. Here we use specially synthesized solvatochromic surfactants that act as 'molecular rulers' and resonance-enhanced second-harmonic generation to measure the dipolar width of weakly and strongly associating liquid-liquid interfaces. Dipolar width describes the distance required for a dielectric environment to change from one phase to another. Our results show that polarity converges to a nonpolar limit on subnanometre length scales across a water-cyclohexane interface. However, polarity across the strongly associating, water-1-octanol interface is dominated by a nonpolar, alkane-like region. These data call into question the use of continuum descriptions of liquids to characterize interfacial solvation, and demonstrate that interfacial environments can vary in a non-additive manner from bulk solution limits.

Journal Article↗

PubMed2003

Solvent polarity at an aqueous/alkane interface: the effect of solute identity.

Resonance-enhanced second harmonic generation (SHG) has been used to probe the solvatochromic behavior of two small, aromatic chromophores adsorbed to the aqueous/cyclohexane, liquid/liquid interface. SHG spectra of p-nitrophenol (PNP) and 2,6-dimethyl-PNP (dmPNP) indicate that these two chromophores sample markedly different environments. PNP sees a polar, waterlike environment, whereas solvent polarity surrounding dmPNP is dominated by the nonpolar, organic phase. Results suggest that subtle changes in solute structure can change the distribution of solutes across an interface and thus change a solute's local solvation environment.

Journal Article↗

PubMed2002

Molecular rulers: new families of molecules for measuring interfacial widths.

Homologous series of solvatochromic neutral alcohols and ionic sulfates are synthesized and characterized. Each surfactant series consists of hydrophobic, p-nitroanisole-based chromophores attached to polar or ionic headgroups by n-alkyl spacers. UV absorption measurements show that the optical properties of surfactant chromophores closely track those of the parent chromophore. Interfacial tension measurements are used to calculate surface excess concentrations of ionic surfactants adsorbed to an aqueous-cyclohexane interface. With a hydrophobic chromophore, a hydrophilic headgroup, and a variable-length, alkyl spacer, these surfactants have the potential to function as molecular rulers: probes of molecular-scale variation in solvation forces across condensed-phase interfaces. Changing the separation between the hydrophobic, solvatochromic probe and the hydrophilic headgroup should enable different members of a homologous series to span different interfacial widths, thus exposing the chromophore to different chemical environments. This idea is explored by using surface-specific, nonlinear optical spectroscopy. Resonant second harmonic spectra of p-nitroanisole and the surfactant product 4a adsorbed to an aqueous-cyclohexane interface show the surfactant spectrum blue-shifted 9 nm relative to the spectrum of adsorbed p-nitroanisole. On the basis of chromophore solvatochromism, these results are consistent with a less polar environment surrounding the surfactant chromophore. Significant differences in interfacial solvation resulting from a approximately 5 A separation between the surfactant headgroup and chromophore support recently proposed models of molecularly sharp, microscopically flat aqueous-alkane interfaces.

Journal Article↗