Biomedical subjects

Rosa M Marcé

Publications and source records attributed to Rosa M Marcé.

9 recordsLinked to original sources

PubMed2006

Direct determination of ciprofloxacin by mass spectrometry after a two-step solid-phase extraction using a molecularly imprinted polymer.

A molecularly imprinted polymer (MIP) has been prepared for the first time with ciprofloxacin (CIPRO) as the template molecule, via a noncovalent synthetic procedure. Prior to its use as a sorbent in SPE, the MIP was evaluated chromatographically to confirm that it was indeed molecularly imprinted. The MIP was then used to extract CIPRO selectively from urine samples by means of a two-step SPE procedure in which a commercial Oasis cartridge and a molecularly imprinted SPE cartridge were combined in series. This approach allowed the matrix compounds present in the samples to be removed effectively. The urine extracts obtained after this two-step SPE procedure was applied were relatively clean compared to the original samples, and this made it possible to inject directly the extracts into a mass spectrometer and thus quantify CIPRO in urine samples at low levels and reduce the time of analysis.

Evaluation Study↗

PubMed2005

Selective enrichment of anti-inflammatory drugs from river water samples by solid-phase extraction with a molecularly imprinted polymer.

A molecularly imprinted polymer (MIP) is synthesised by a noncovalent protocol in which ibuprofen was used as a template molecule. The polymer was evaluated chromatographically and it was seen that the MIP showed cross-reactivity. Subsequently, when this polymer was used as sorbent in SPE it was possible to selectively extract a mixture of nonsteroidal anti-inflammatory drugs from aqueous samples when a cleanup step with dichloromethane was performed. The performance of the MIP was evaluated with river water and water from a wastewater treatment plant, and compared with the performance of a commercial Isolute ENV+ sorbent.

Anti-Inflammatory Agents↗

PubMed2005

Occurrence of twenty-six endocrine-disrupting compounds in environmental water samples from Catalonia, Spain.

We monitored 26 compounds known or suspected to be endocrine disruptors in several environmental water samples from a river, the sea, and an irrigation canal. Because of the various chemical properties of the compounds monitored, analyses were carried out by using two different methods. One method is based on solid-phase extraction (SPE) on-line coupled to gas chromatography-mass spectrometry through an on-column interface. Another is based on high-performance liquid chromatography-(electrospray) mass spectrometry working in negative ionization mode and using off-line SPE. The limits of detection for the two methods were at levels of low microg/L. Phthalates and bis-(2-ethylhexyl) adipate were found at levels between 0.05 and 13 microg/L in all of the water samples analyzed. Some pesticides, alkylphenols, and estrogens were determined in a few samples at levels below 0.1 microg/L.

Adipates↗

PubMed2004

A new molecularly imprinted polymer for the selective extraction of naproxen from urine samples by solid-phase extraction.

A non-covalent molecularly imprinted polymer (MIP) was synthesised using naproxen (a non-steroidal, anti-inflammatory drug (NSAID)) as a template molecule. The MIP was chromatographically evaluated to confirm the imprinting effect, and was then applied as a selective sorbent in solid-phase extraction (SPE) to selectively extract naproxen. After this study, the MIP was used to extract naproxen from urine samples; it was demonstrated that by applying a selective washing step with acetonitrile (ACN) the compounds in the sample that were structurally related to naproxen could be eliminated.

Anti-Inflammatory Agents, Non-Steroidal↗

PubMed2004

Molecularly imprinted solid-phase extraction of naphthalene sulfonates from water.

A new polymeric sorbent synthesised by exploiting molecular imprinting technology has been used to selectively extract naphthalene sulfonates (NSs) directly from aqueous samples. In the non-covalent molecular imprinting approach used to prepare this polymer, 1-naphthalene sulfonic acid (1-NS) and 4-vinylpyridine (4-VP) were used as a template molecule and functional monomer, respectively, and both dissolved in a mixture of methanol/water (4:1) as porogen together with the cross-linker ethylene glycol dimethacrylate. The new non-covalent molecularly imprinted polymer (MIP) prepared in aqueous environment was used as a sorbent in solid-phase extraction (SPE) to selectively extract a group of naphthalene mono- and disulfonates. When one litre of a standard aqueous solution, which contained a mixture of eight NSs, was percolated through the SPE cartridge, all the NSs were retained on the MIP because of the cross-reactivity of the polymer. Recoveries were higher than 80% for all the compounds even after a clean-up step with methanol (MeOH). The MIP was also used to analyse water from the Ebro river.

Naphthalenesulfonates↗

PubMed2004

Quantification from highly drifted and overlapped chromatographic peaks using second-order calibration methods.

For determining low levels of pesticides and phenolic compounds in river and wastewater samples by high performance liquid chromatography (HPLC), solid phase extraction (SPE) is commonly used before the chromatographic separation. This preconcentration step is not necessarily selective for the analytes of interest and it may retain other compounds of similar characteristics as well. In this case, we present, humic and fulvic acids caused a large baseline drift and overlapped the analytes to be quantified. The inaccurate determinations of the area of the peaks of these analytes made it difficult to quantify them with univariate calibration. Here we compare three second-order calibration algorithms (generalized rank annihilation method (GRAM), parallel factor analysis (PARAFAC) and multivariate curve resolution-alternating least squares (MCR-ALS)) which efficiently solve this problem. These methods use second-order data, i.e., a matrix of responses for each peak, which is easily obtained with a high performance liquid chromatography-diode array detector (HPLC-DAD). With these methods, the area does not need to be directly measured and predictions are more accurate. They also save time and resources because they can quantify analytes even if the peaks are not resolved. GRAM and PARAFAC require trilinear data. Biased and imprecise concentrations (relative standard deviation, %R.S.D. = 34) were obtained without correcting the time-shift. Hence, a time-shift correction algorithm to align the peaks was needed to obtain accurate predictions. MCR-ALS was the most robust to the time-shift. All three algorithms provided similar mean predictions, which were comparable to those obtained when sulfite was added to the samples. However, the predictions for the different replicates were more similar for the second-order algorithms (%R.S.D. = 3) than the ones obtained by univariate calibration after the sulfite addition (%R.S.D. = 13).

Calibration↗

PubMed2003

On-line solid-phase extraction with molecularly imprinted polymers to selectively extract substituted 4-chlorophenols and 4-nitrophenol from water.

Three polymers have been synthesised using 4-chlorophenol (4-CP) as the template, following different protocols (non-covalent and semi-covalent) and using different functional co-monomers, 4-vinylpyridine (4-VP) and methacrylic acid (MAA). The polymers were evaluated to check their selectivity as molecularly imprinted polymers (MIPs) in solid-phase extraction (SPE) coupled on-line to liquid chromatography. The solid-phase extraction procedure using MIPs (MISPE), including the clean-up step to remove any interferences, was optimised. The 4-VP non-covalent polymer was the only one which showed a clear imprint effect. This MIP also showed cross-reactivity for the 4-chloro-substituted phenols and for 4-nitrophenol (4-NP) from a mixture containing the 11 priority EPA (Environmental Protection Agency) phenolic compounds and 4-chlorophenol. The MIP was applied to selectively extract the 4-chloro-substituted compounds and 4-NP from river water samples.

Chlorophenols↗

PubMed2003

Using second-order calibration to identify and quantify aromatic sulfonates in water by high-performance liquid chromatography in the presence of coeluting interferences.

We used the Generalized Rank Annihilation Method (GRAM), a second-order calibration method, to quantify aromatic sulfonates in water with high-performance liquid chromatography (HPLC) when interferences coeluted with the analytes of interest. With GRAM, we can quantify in only two chromatographic analyses, one for a calibration sample and one for the unknown sample. The calculated concentrations were not statistically different to those obtained when the chromatographic separation of the unknown sample was modified in order to completely separate the analyte from the interferences before univariate calibration. With GRAM, the concentrations are determined much more quickly because a complete resolution is not required.

Calibration↗

PubMed2002

Non-covalent and semi-covalent molecularly imprinted polymers for selective on-line solid-phase extraction of 4-nitrophenol from water samples.

Two molecularly imprinted polymers (MIPs) have been synthesised for the selective extraction of 4-nitrophenol (4-NP) from water samples. One polymer was synthesised via a non-covalent approach and the other via a semi-covalent approach. The selectivity of the polymers for 4-NP was evaluated when these polymers were applied in on-line solid-phase extraction (MISPE) coupled to reversed-phase HPLC. The MISPE conditions for both MIPs were optimised and a clean-up step was included to eliminate non-specific interactions. Differences between the two MIPs were observed with the non-covalent MIP being the more selective of the two, whereas the recoveries were slightly higher for the semi-covalent MIP. The performance of the imprinted polymers in the MISPE of real water samples was also evaluated.

Chromatography, Liquid↗