PubMed Health⌕ Search

Biomedical subjects

S Bernstorff

Publications and source records attributed to S Bernstorff.

9 recordsLinked to original sources

Frequency-dependent distortion of meridional intensity changes during sinusoidal length oscillations of activated skeletal muscle.

Bundles of intact, tetanized skeletal muscle fibers from Rana temporaria were subjected to sinusoidal length oscillations in the frequency domain 100 Hz to 3 kHz while measuring force and sarcomere length. Simultaneously, intensity of the third-order x-ray reflection of the axial myosin unit cell (I(M3)) was measured using synchrotron radiation. At oscillation frequencies <1 kHz, I(M3) was distorted during the shortening phase of the sinusoid (i.e., where bundle length was less than rest length). Otherwise, during the stretch phase of oscillations at all frequencies, during the shortening phase of oscillations above 1 kHz, and for bundles in the rigor state, I(M3) was approximately sinusoidal in form. Mean I(M3) during oscillations was reduced by 20% compared to the isometric value, suggesting a possible change in S1 disposition during oscillations. However, the amplitude of length change required to produce distortion (estimated from the phase angle at which distortion was first evident) corresponded to that of a step release sufficient to reach the maximum I(M3), indicating a mean S1 disposition during oscillations close to that during an isometric tetanus. The mechanical properties of the bundle during oscillations were also consistent with an unaltered S1 disposition during oscillations.

Actins↗

Collagen fibrils are differently organized in weight-bearing and not-weight-bearing regions of pig articular cartilage.

The magnetic resonance (MR) appearance of the weight-bearing ("loaded") and not-weight-bearing ("unloaded") regions in T(2)-weighted images of pig articular cartilage is different. On the hypothesis that this difference may be ascribed, at least in part, to a different collagen fibre organization in the two regions, this organization was studied using biochemical, histological, and X-ray diffraction methods. While the mean concentrations of collagen and of its cross-links were the same in the two regions, a regular small angle X-ray diffraction pattern was observed only for the habitually "loaded" tissue. It was also seen by light microscopy that the four typical functional zones were well displayed in the "loaded" cartilage whereas they were not clearly depicted in the "unloaded" tissue. Collagen presented a high concentration of fibrils forming an intricate and dense meshwork at the surface of both "loaded" and "unloaded" cartilage. A second zone of high collagen concentration was present at the upper layer of the deep zone of "loaded" cartilage. By contrast, this lamina of highly concentrated fibrils was lacking in "unloaded" cartilage and collagen fibrils appear thinner. Our study proves that the organization of collagen fibres is different for the "loaded" and "unloaded" regions of articular cartilage. It also suggests that this different organization may influence the MR appearance of the tissue. J. Exp. Zool. 287:346-352, 2000.

Animals↗

A combined mechanical and X-ray diffraction study of stretch potentiation in single frog muscle fibres.

The nature of the force (T) response during and after steady lengthening has been investigated in tetanized single muscle fibres from Rana temporaria (4 C; 2.15 micrometer sarcomere length) by determining both the intensity of the third order myosin meridional X-ray reflection (IM3) and the stiffness (e) of a selected population of sarcomeres within the fibre. With respect to the value at the isometric tetanus plateau (To), IM3 was depressed to 0.67 +/- 0.04 during steady lengthening at approximately 160 nm s(-1) (T approximately 1.7) and recovered to 0.86 +/- 0.05 during the 250 ms period of after-stretch potentiation following the rapid decay of force at the end of lengthening (T approximately 1.3); under the same conditions stiffness increased to 1.25 +/- 0.02 and to 1.12 +/- 0.03, respectively. After subtraction of the contribution of myofilaments to the half-sarcomere compliance, stiffness measurements indicated that (1) during lengthening the cross-bridge number rises to 1.8 times the original isometric value and the average degree of cross-bridge strain is similar to that induced by the force-generating process in isometric conditions (2.3 nm), and (2) after-stretch potentiation is explained by a residual larger cross-bridge number. Structural data are compatible with mechanical data if the axial dispersion of attached heads is doubled during steady lengthening and recovers half-way towards the original isometric value during after-stretch potentiation.

Animals↗

New evidence for gel-liquid crystalline phase coexistence in the ripple phase of phosphatidylcholines.

Experimental evidence supporting the hypothesis of gel-liquid crystalline phase coexistence in the stable ripple phase of diacylphosphatidylcholines has been obtained from time-resolved X-ray small- (SAXS) and wide-angle diffraction (WAXS) in the millisecond to second time domain. The pretransition of 1,2-dipalmitoyl-sn-glycero-3-phosphocholine (DPPC) exhibits a thin lamellar liquid crystalline intermediate phase (designated Lalpha) if driven far away from equilibrium by an infrared temperature jump (T-jump) technique. The findings can be described by a two-step model. (1) Instantaneously with the T-jump, an anomalously thin lamellar liquid crystalline intermediate phase (d = 5.6-5.8 nm) forms, coexisting with the original gel-phase Lbeta'. Within the first seconds, the lamellar repeat distance of the intermediate increases to a value of about 6.7 nm. A closer examination of these kinetics reveals two relaxation components: a fast process, proceeding within tenths of a second, and a slow process, on the time scale of a few seconds. (2) Finally, both the liquid crystalline and the gel-phase relax into the stable ripple phase Pbeta'. The total process time of the transition is nearly independent of the addition of NaCl, but varies strongly with the chain length of the lecithin species.

1,2-Dipalmitoylphosphatidylcholine↗

Fibrillar structure and mechanical properties of collagen.

Collagen type I is among the most important stress-carrying protein structures in mammals. Despite their importance for the outstanding mechanical properties of this tissue, there is still a lack of understanding of the processes that lead to the specific shape of the stress-strain curve of collagen. Recent in situ synchrotron X-ray scattering experiments suggest that several different processes could dominate depending on the amount of strain. While at small strains there is a straightening of kinks in the collagen structure, first at the fibrillar then at the molecular level, higher strains lead to molecular gliding within the fibrils and ultimately to a disruption of the fibril structure. Moreover, it was observed that the strain within collagen fibrils is always considerably smaller than in the whole tendon. This phenomenon is still very poorly understood but points toward the existence of additional gliding processes occurring at the interfibrillar level.

Animals↗

Studies on the 14.5 nm meridional X-ray diffraction reflection during length changes of intact frog muscle fibres.

The intensity of the 14.5 nm meridional reflection (M3) from activated skeletal muscle fibres was studied in both single fibres and fibre bundles during the imposition of length changes. During shortening at small load, the intensity of the reflection decreased within 2 ms to less than 20% of isometric intensity, then recovered partially during the remainder of the shortening. When shortening was terminated, recovery of intensity was delayed. Small shortening steps (0.5% fibre length) produced a fall in M3 intensity (IM3) delayed by ca. 250 microseconds compared to the fall in tension. For larger step releases (1% fibre length), the fall in IM3 was not delayed. The fall in IM3 could be almost completely reversed by a subsequent restretch applied within 1.5 ms. Beyond 10 ms after the initial release, the restretch caused a further fall in intensity. A rapid step stretch (0.5% fibre length) also caused a fall in IM3 without delay, which was partially reversed by a release applied within 10 ms. A second small release applied 3 ms (or less) after the first caused a second fall in M3 intensity, but without delay and with faster time course. Small amplitude sinusoidal length oscillations (0.15-0.2% sarcomere; 1 kHz) caused a sinusoidal change in M3 intensity, which was 180 degrees out of phase with the force oscillations, and lacked distortion during its release phase.

Animals↗