Biomedical subjects

S K Maier

Publications and source records attributed to S K Maier.

4 recordsLinked to original sources

PubMed1999

Long-chain polyphosphate causes cell lysis and inhibits Bacillus cereus septum formation, which is dependent on divalent cations.

We investigated the cellular mechanisms that led to growth inhibition, morphological changes, and lysis of Bacillus cereus WSBC 10030 when it was challenged with a long-chain polyphosphate (polyP). At a concentration of 0.1% or higher, polyP had a bacteriocidal effect on log-phase cells, in which it induced rapid lysis and reductions in viable cell counts of up to 3 log units. The cellular debris consisted of empty cell wall cylinders and polar caps, suggesting that polyP-induced lysis was spatially specific. This activity was strictly dependent on active growth and cell division, since polyP failed to induce lysis in cells treated with chloramphenicol and in stationary-phase cells, which were, however, bacteriostatically inhibited by polyP. Similar observations were made with B. cereus spores; 0.1% polyP inhibited spore germination and outgrowth, and a higher concentration (1.0%) was even sporocidal. Supplemental divalent metal ions (Mg(2+) and Ca(2+)) could almost completely block and reverse the antimicrobial activity of polyP; i. e., they could immediately stop lysis and reinitiate rapid cell division and multiplication. Interestingly, a sublethal polyP concentration (0.05%) led to the formation of elongated cells (average length, 70 microm) after 4 h of incubation. While DNA replication and chromosome segregation were undisturbed, electron microscopy revealed a complete lack of septum formation within the filaments. Exposure to divalent cations resulted in instantaneous formation and growth of ring-shaped edges of invaginating septal walls. After approximately 30 min, septation was complete, and cell division resumed. We frequently observed a minicell-like phenotype and other septation defects, which were probably due to hyperdivision activity after cation supplementation. We propose that polyP may have an effect on the ubiquitous bacterial cell division protein FtsZ, whose GTPase activity is known to be strictly dependent on divalent metal ions. It is tempting to speculate that polyP, because of its metal ion-chelating nature, indirectly blocks the dynamic formation (polymerization) of the Z ring, which would explain the aseptate phenotype.

Bacillus cereus↗

PubMed1998

The two-component lysis system of Staphylococcus aureus bacteriophage Twort: a large TTG-start holin and an associated amidase endolysin.

The lysis genes of the virulent Staphylococcus aureus bacteriophage Twort were cloned and their nucleotide sequences determined. The endolysin gene plyTW encodes a 53.3-kDa protein, whose catalytic site is located in the amino-terminal domain. An enzymatically active fragment (N-terminal 271 amino acids) was overexpressed in Escherichia coli and partially purified. The enzyme rapidly cleaves staphylococcal peptidoglycan, and was shown to act as N-acetylmuramoyl-L-alanine amidase (EC 3.5.1.28). Significant sequence homology to the specific cell wall targeting domain of lysostaphin was observed in a 101-amino acid C-terminal overlap. However, we found that the large C-terminal portion (63%, 295 aa) of PlyTW is not required for staphylolytic activity. Located upstream of and overlapping plyTW by 35 bp in a different reading frame (+1), we identified holTW, which starts with a single TTG triplet. The gene specifies a 185-amino acid (20.5 kDa) holin protein, which features two potential hydrophobic, antiparallel transmembrane domains, and a highly charged, acidic C-terminus. HolTW is the largest class II holin described to date. It can substitute for the defective allele in phase lambda S' amber mutants, both in trans from an expression plasmid, and from within gt11::holTW. The proposed function is the formation of unspecific membrane lesions to promote access of the endolysin to the bacterial peptidoglycan.

Amino Acid Sequence↗

PubMed1997

Three Bacillus cereus bacteriophage endolysins are unrelated but reveal high homology to cell wall hydrolases from different bacilli.

The ply genes encoding the endolysin proteins from Bacillus cereus phages Bastille, TP21, and 12826 were identified, cloned, and sequenced. The endolysins could be overproduced in Escherichia coli (up to 20% of total cellular protein), and the recombinant proteins were purified by a two-step chromatographical procedure. All three enzymes induced rapid and specific lysis of viable cells of several Bacillus species, with highest activity on B. cereus and B. thuringiensis. Ply12 and Ply21 were experimentally shown to be N-acetylmuramoyl-L-alanine amidases (EC 3.5.1.28). No apparent holin genes were found adjacent to the ply genes. However, Ply21 may be endowed with a signal peptide which could play a role in timing of cell lysis by the cytoplasmic phage endolysin. The individual lytic enzymes (PlyBa, 41.1 kDa; Ply21, 29.5 kDa, Ply12, 27.7 kDa) show remarkable heterogeneity, i.e., their amino acid sequences reveal only little homology. The N-terminal part of Ply21 was found to be almost identical to the catalytic domains of a Bacillus sp. cell wall hydrolase (CwlSP) and an autolysin of B. subtilis (CwlA). The C terminus of PlyBa contains a 77-amino-acid sequence repeat which is also homologous to the binding domain of CwlSP. Ply12 shows homology to the major autolysins from B. subtilis and E. coli. Comparison with database sequences indicated a modular organization of the phage lysis proteins where the enzymatic activity is located in the N-terminal region and the C-termini are responsible for specific recognition and binding of Bacillus peptidoglycan. We speculate that the close relationship of the phage enzymes and cell wall autolysins is based upon horizontal gene transfer among different Bacillus phages and their hosts.

Amino Acid Sequence↗

PubMed1990

Compositional analysis of Biomer.

Biomer, a segmented polyether polyurethane, has been analyzed via hydrolysis/gas chromatography to determine its composition. In addition to the previously reported 4,4'-methylene bis(phenyl isocyanate) (MDI), polytetramethylene glycol (PTMO), and ethylenediamine, we now report the presence of diethylamine, 1,3-diaminocyclohexane and poly(diisopropylaminoethyl methacrylate-co-decyl methacrylate), Biomer's cloudy insoluble phase. In addition, a method is presented to characterize the methacrylate additive by molecular weight based on GPC. Also found by chromatography were the antioxidants Santowhite Powder and BHT. XPS shows no Si (silicone) on the Biomer surface, and a total chloride analysis reports no chloride (less than 0.03%). Time-of-flight SIMS data suggest evidence for the methacrylate additive at the surface, and mass spectroscopy can be interpreted as evidence for a diaminocyclohexane.

Antioxidants↗