PubMed Health⌕ Search

Biomedical subjects

S Kodambaka

Publications and source records attributed to S Kodambaka.

7 recordsLinked to original sources

Real time observation of GeSi/Si(001) island shrinkage due to surface alloying during Si capping.

The Si capping of Ge/Si(001) islands was observed by in situ time-resolved transmission electron microscopy. During the initial stages of the Si deposition, islands were observed not only to flatten but also to shrink in volume. This unexpected shrinkage is explained by taking into account the intermixing of the deposited Si with the wetting layer and a consequently induced diffusion of Ge from the islands into the wetting layer. A model of the capping process which takes into account Ge diffusion is presented which is in good agreement with the experimental data.

Journal Article↗

Sublimation of atomic layers from a chromium surface.

We employ low-energy electron microscopy to study the kinetics of thermal etching, or sublimation, of Cr(001) at approximately 1100 K. Atomic layers are removed from the surface by spontaneous nucleation and growth of two-dimensional vacancy islands, by rotation of spiral steps, and by island decay. The growth rates of vacancy islands and the rotation frequencies of double spirals are measured as a function of temperature, and the results are correlated with activation barriers of surface processes. Mass transport between the surface and bulk is shown to be unimportant.

Journal Article↗

Diameter-independent kinetics in the vapor-liquid-solid growth of Si nanowires.

We examine individual Si nanowires grown by the vapor-liquid-solid mechanism, using real-time in situ ultra high vacuum transmission electron microscopy. By directly observing Au-catalyzed growth of Si wires from disilane, we show that the growth rate is independent of wire diameter, contrary to the expected behavior. Our measurements show that the unique rate-limiting step here is the irreversible, kinetically limited, dissociative adsorption of disilane directly on the catalyst surface. We also identify a novel dependence of growth rate on wire taper.

Journal Article↗

The influence of the surface migration of gold on the growth of silicon nanowires.

Interest in nanowires continues to grow, fuelled in part by applications in nanotechnology. The ability to engineer nanowire properties makes them especially promising in nanoelectronics. Most silicon nanowires are grown using the vapour-liquid-solid (VLS) mechanism, in which the nanowire grows from a gold/silicon catalyst droplet during silicon chemical vapour deposition. Despite over 40 years of study, many aspects of VLS growth are not well understood. For example, in the conventional picture the catalyst droplet does not change during growth, and the nanowire sidewalls consist of clean silicon facets. Here we demonstrate that these assumptions are false for silicon nanowires grown on Si(111) under conditions where all of the experimental parameters (surface structure, gas cleanliness, and background contaminants) are carefully controlled. We show that gold diffusion during growth determines the length, shape, and sidewall properties of the nanowires. Gold from the catalyst droplets wets the nanowire sidewalls, eventually consuming the droplets and terminating VLS growth. Gold diffusion from the smaller droplets to the larger ones (Ostwald ripening) leads to nanowire diameters that change during growth. These results show that the silicon nanowire growth is fundamentally limited by gold diffusion: smooth, arbitrarily long nanowires cannot be grown without eliminating gold migration.

Journal Article↗

Dislocation-driven surface dynamics on solids.

Dislocations are line defects that bound plastically deformed regions in crystalline solids. Dislocations terminating on the surface of materials can strongly influence nanostructural and interfacial stability, mechanical properties, chemical reactions, transport phenomena, and other surface processes. While most theoretical and experimental studies have focused on dislocation motion in bulk solids under applied stress and step formation due to dislocations at surfaces during crystal growth, very little is known about the effects of dislocations on surface dynamics and morphological evolution. Here we investigate the near-equilibrium dynamics of surface-terminated dislocations using low-energy electron microscopy. We observe, in real time, the thermally driven nucleation and shape-preserving growth of spiral steps rotating at constant temperature-dependent angular velocities around cores of dislocations terminating on the (111) surface of TiN in the absence of applied external stress or net mass change. We attribute this phenomenon to point-defect migration from the bulk to the surface along dislocation lines. Our results demonstrate that dislocation-mediated surface roughening can occur even in the absence of deposition or evaporation, and provide fundamental insights into mechanisms controlling nanostructural stability.

Journal Article↗

Size-dependent detachment-limited decay kinetics of two-dimensional TiN islands on TiN(111).

In situ high-temperature (T(a)=1050-1250 K) scanning tunneling microscopy was used to determine the coarsening and decay kinetics of two-dimensional TiN adatom and vacancy islands on atomically smooth TiN(111) terraces. We report the first observation of an abrupt decrease in decay rates, irrespective of T(a), of adatom islands with areas less than a critical value of 1600 A(2). However, no decay rate transition was observed for vacancy islands. We attribute the size-dependent island decay behavior, which is consistent with detachment-limited kinetics, to anisotropic attachment and detachment barriers.

Journal Article↗

Absolute TiN(111) step energies from analysis of anisotropic island shape fluctuations.

In situ high-temperature (1165-1248 K) scanning tunneling microscopy was used to measure fluctuations around the equilibrium shape of two-dimensional vacancy islands on TiN(111) terraces. From the equilibrium shape, the ratio of the two <110> step energies was found to be 0.72 +/- 0.02. Combining this with the results of an exact approach for analysis of shape fluctuations, applicable to highly anisotropic islands, we obtain absolute values for step energies and step stiffnesses as a function of orientation.

Journal Article↗