Biomedical subjects

S M Ratusznei

Publications and source records attributed to S M Ratusznei.

6 recordsLinked to original sources

PubMed2006

Effects of solid-phase mass transfer on the performance of a stirred anaerobic sequencing batch reactor containing immobilized biomass.

This work reports on experiments for an anaerobic sequencing batch reactor containing immobilized biomass which aimed at verifying the effects of solid-phase mass transfer on the reactor's overall performance. Four experiments were carried out at 30 degrees C with cubic polyurethane foam particles previously inoculated with anaerobic biomass. Different solid-phase mass transfer conditions were reached in each experiment by varying the size of the bioparticle from 0.5 to 3.0 cm. The reactor was fed with a low-strength synthetic wastewater containing protein, carbohydrates and lipid and the effects of mass transfer were evaluated through dynamic substrate concentration profiles during 8-hour batch cycles. A modified first-order kinetic model provided a good representation of the behavior of the dynamic concentration profiles. The solid-phase mass transfer was found to slightly affect the concentration of effluent organic matter expressed as chemical oxygen demand (COD). The concentration of residual effluent substrate increased as the size of the bioparticle was increased. The cycle time was not affected as the size of the bioparticle was increased from 0.5 to 2.0 cm. However, it was found that the cycle time in a reactor with 3.0-cm cubic particles should be higher than that required in systems with smaller particles. The apparent first-order kinetic parameter was estimated as 0.59+/-0.01 h(-1) for experiments with bioparticle sizes ranging from 0.5 to 2.0 cm, while a value of 0.48 h(-1) was obtained in the experiment with 3.0-cm bioparticles.

Bacteria, Anaerobic↗

PubMed2004

Effects of feeding strategies on the performance of an anaerobic discontinuous reactor containing immobilized biomass with circulation system for liquid-phase mixing.

Data on the influence of feeding strategy on the performance of a fed-batch anaerobic sequencing reactor containing biomass immobilized on polyurethane foam and subjected to liquid phase circulation are presented and discussed. Six-hour cycles, temperature of 30 degrees C and circulation flow rate of 6 L/h were used. During each cycle 890 mL of synthetic domestic wastewater, with organic matter concentration of 500 mgCOD/L were fed to the reactor. The feeding strategies were implemented using fill times of 6 min (batch mode), 60, 120, 240 (fed-batch/batch mode) and 360 min (fed-batch mode). The system attained high efficiency and stability for all the operating conditions, and the substrate removal efficiency based on filtered samples presented a slight decrease from 85% to 81% when fill time was increased from 6 min to 360 min. A model considering a first-order kinetic equation was fitted to the experimental data. The apparent kinetic parameters for both batch and fed-batch phases were estimated, thus permitting evaluation of the influence of the feeding strategy on the reactor performance. The current system may be considered flexible in terms of the operating conditions it is subjected to.

Bacteria, Anaerobic↗

PubMed2004

Stirred anaerobic sequencing batch reactor containing immobilized biomass: a behavior study when submitted to different fill times.

The effect of the filling stage on the behavior of a mechanically stirred anaerobic sequencing batch reactor containing biomass immobilized on 1 cm polyurethane foam cubes was investigated. The reactor was made of acrylic with a capacity of 6.3 L, treating per cycle 2.5 L synthetic low-strength wastewater with a concentration of 500 mgCOD/L, at 30+/-1 degrees C. Eight-hour cycles (tC) and agitation of 500 rpm were utilized. At the beginning of each cycle 60% of the wastewater volume was treated, sufficient to completely cover the bed. The remaining volume was added at different fill times (tF) of 10, 120, 240, 260 and 480 min. The results obtained showed that ratios of tF/tC < or = 0.5 enabled organic matter removal higher than 75% and 70% for filtered and non-filtered samples, respectively. Ratios of tF/tC > 0.5, despite operation stability, resulted in loss of efficiency and formation of viscous material, similar to extra-cellular polymeric substances.

Bacteria, Anaerobic↗

PubMed2003

Operating feasibility of anaerobic whey treatment in a stirred sequencing batch reactor containing immobilized biomass.

The scope of this work was to evaluate the operating feasibility of anaerobic whey treatment in a stirred sequencing batch reactor (ASBR) containing biomass immobilized on inert support. Assays were performed using 8-hour cycles and agitation rate of 200 rpm at 30 +/- 1 degrees C, for treating cheese whey containing 500 to 4,000 mgCOD/L, which corresponded to a volumetric organic load (VOL) of 0.81 to 5.7 gCOD/L x d. Stability and high organic matter removal of about 96% were achieved at effluent concentration below 160 mgCOD/L for non filtered samples. Operating stability of the reactor was shown to be strongly dependent on the alkalinity supplementing strategy during the assay, especially during the startup period, where NaHCO3 supplementation was approximately 20-30% of the chemical oxygen demand (mgNaHCO3/mgCOD). After startup, alkalinity supplementation could be reduced down to 10% maintaining efficiency and stability. Moreover, proper homogenization of the system through mechanical agitation was also shown to be indispensable, especially with increasing organic load.

Animals↗

PubMed2001

Anaerobic sequencing batch reactors for wastewater treatment: a developing technology.

This paper describes and discusses the main problems related to anaerobic batch and fed-batch processes for wastewater treatment. A critical analysis of the literature evaluated the industrial application viability and proposed alternatives to improve operation and control of this system. Two approaches were presented in order to make this anaerobic discontinuous process feasible for industrial application: (1) optimization of the operating procedures in reactors containing self-immobilized sludge as granules, and (2) design of bioreactors with inert support media for biomass immobilization.

Anaerobiosis↗

PubMed2001

Influence of agitation rate on the performance of a stirred anaerobic sequencing batch reactor containing immobilized biomass.

The present work reports on the influence of the mechanical agitation rates on the performance of a stirred anaerobic sequencing batch reactor containing immobilized biomass on polyurethane foam, as inert support, treating synthetic domestic wastewater. The reactor was operated at 30 degrees C and an 8-hour cycle was used to treat approximately 0.5 L of the synthetic substrate with a COD concentration of nearly 500 mg/L. The studied agitation rates ranged from no agitation to 750 rpm. The system attained non-filtered substrate removal efficiency greater than 83% when agitation was employed. A very short start-up period and good solid retention could be observed. The use of agitation increased the efficiency of the reactor and enabled reduction of the total cycle time. An empirical equation and a first-order kinetic model are proposed to analyze the influence of agitation rates on the reactor's performance.

Bacteria, Anaerobic↗