PubMed Health⌕ Search

Biomedical subjects

S Ransac

Publications and source records attributed to S Ransac.

27 records · Page 2Linked to original sources

A monolayer and bulk study on the kinetic behavior of Pseudomonas glumae lipase using synthetic pseudoglycerides.

A heat-stable lipase from Pseudomonas glumae was purified to homogeneity. Its positional and stereospecific properties were investigated and compared with those of the well-known porcine pancreatic lipase. The kinetic properties of both enzymes were determined by use of six isomeric synthetic pseudoglycerides all composed of a single hydrolyzable fatty acyl ester bond and two lipase-resistant groups: one acylamino and one ether function. Two enzyme assay techniques were applied: a detergent-free system, the monomolecular surface film technique, and the pH-stat technique using clear micellar solutions of substrate in the presence of Triton X-100. Regarding the cleavage of primary ester bonds, P. glumae lipase possesses no stereopreference. In contrast, a large stereopreference in favor of the R-isomer is found for the hydrolysis of secondary ester bonds. Secondary ester bonds are efficiently cleaved by the lipase, which makes it of potential interest for enzymatic synthetic purposes. For the hydrolysis of this R-isomer a correlation between the experimental catalytic turnover rate and the binding constant for micelles was observed. The kinetic data of P. glumae lipase have been analyzed in terms of the scooting and hopping models for the action of lipolytic enzymes [Upreti, G.C., & Jain, M.K. (1980) J. Membr. Biol. 55, 113-121]. The results presented in this study are best explained by assuming that glumae lipase leaves the interface after a limited number of catalytic cycles.

Animals↗

Inactivation of pancreatic and gastric lipases by THL and C12:0-TNB: a kinetic study with emulsified tributyrin.

THL is a potent inhibitor of pancreatic (PPL) and gastric (HGL, RGL) lipases. Inactivation occurs preferentially at the oil/water interface (method B, C). In the aqueous phase (method A), the inhibition of HGL was accelerated by the presence of bile salts. C12:0-TNB, a disulfide reagent, specifically inactivates gastric lipases and had no effect on the pancreatic lipase (in the presence of bile salts) whatever the method used. The capacity of THL and C12:0-TNB to inactivate lipases using Methods B and C was found to depend directly upon the interfacial area of the system used. Consequently, inactivation can be reduced or prevented by further addition of a water-insoluble substrate which reduces the surface density of inactivator molecules. With a heterogeneous system of this kind, typical of lipolysis, the use of a classical Michaelis-Menten model is irrelevant and hence the traditional kinetic parameters (Km, KI, Vmax) are only apparent values.

Animals↗

Activation of protein kinase C in lipid monolayers.

The potential of lipid monolayers spread at an air-water interface was investigated as a well defined membrane model able to support protein kinase C (PKC) association and activation. PKC association to a mixed phospholipid film (phosphatidylcholine, phosphatidylserine) could be detected by an increase of the monolayer surface pressure. This association was strikingly dependent upon the presence of submicromolar concentrations of Ca2+. The effect of Ca2+ resulted in an increase of the PKC penetration into the lipid core at a given permissive surface pressure as well as in a marked increase of the critical surface pressure (29-38 dynes/cm) above which the enzyme was excluded from the membrane. Inclusion of diacylglycerol or tetradecanoate phorbol acetate (TPA) did not modify the PKC-monolayer association in a detectable manner. PKC associated to the lipid layer exhibited the expected catalytic property and was fully activated when diacylglycerol or TPA was included in the membrane. PKC activity was highly dependent upon the surface pressure of the lipid monolayer, being optimal between 30 and 35 dynes/cm. Study of the compression isotherm of various diacylglycerol structures revealed that all potent PKC agonists exhibited an expanded liquid phase behavior with collapse pressure below 40 dynes/cm, in contrast to weak activators which showed condensed isotherms with high collapse pressure (approximately equal to 60 dynes/cm). These observations showed that the lipid monolayer system is well adapted to the study of the molecular mechanisms involved in the regulation of PKC activity at a model membrane interface. They are in line with the suggestion of a major role of Ca2+ in the association (translocation) of PKC to membrane in living cell and suggest that diacylglycerol (and TPA) might activate membrane-associated PKC through local change in the surrounding lipid phase organization.

Animals↗

Stereoselectivity of lipases. I. Hydrolysis of enantiomeric glyceride analogues by gastric and pancreatic lipases, a kinetic study using the monomolecular film technique.

In the present study, porcine pancreatic lipase, rabbit gastric lipase, and human gastric lipase stereospecificity toward enantiomeric glyceride derivatives was kinetically investigated using the monomolecular film technique. Pseudoglycerides such as enantiomeric 1(3)-alkyl-2,3(1,2)-diacyl-sn-glycerol, enantiomeric 1(3)-alkyl-2-acyl-sn-glycerol, or enantiomeric 1(3)-acyl-2-acylamino-2-deoxy-sn-glycerol were synthesized in order to assess the lipase stereoselectivity during the hydrolysis of either the primary or the secondary ester position of these glycerides analogues. The cleaved acyl moiety was the same in both enantiomers, thereby excluding the possibility of effects occurring due to fatty acid specificity. We observed a porcine pancreatic lipase sn-3 stereoselectivity when using the enantiomeric 1(3)-alkyl-2-acylamino-2-deoxy-sn-glycerol (diglyceride analogue) which contrasted with the lack of stereoselectivity observed when using the enantiomeric 1(3)-alkyl-2,3(1,2)-diacyl-sn-glycerol (triglyceride analogue). The gastric lipases, in contrast to the pancreatic lipase, preferentially catalyze the hydrolysis of the primary sn-3 ester bond of the enantiomeric monoakyl-diacyl pair tested. From these kinetic data, high hydrolysis rates and no chiral discrimination were observed in the case of rabbit gastric lipase, whereas low rates and a clear chiral discrimination was noticed in the case of human gastric lipase during hydrolysis of the acyl chain from the secondary ester bond of 1(3)-alkyl-2-acyl enantiomers. It is particularly obvious that in the case of human gastric lipase decreasing the lipid packing increases the lipase sn-3 stereopreference during hydrolysis of the primary ester bond of the enantiomeric 2-acylamino derivatives (diglyceride analogue).

Animals↗

Stereoselectivity of lipases. II. Stereoselective hydrolysis of triglycerides by gastric and pancreatic lipases.

In the present study, porcine pancreatic lipase, rabbit gastric lipase, and human gastric lipase stereospecificity toward chemically alike, but sterically nonequivalent ester groups within one single triglyceride molecule was investigated. Lipolysis reactions were carried out on synthetic trioctanoin or triolein, which are homogenous, prochiral triglycerides, chosen as models for physiological lipase substrates. Diglyceride mixtures resulting from lipolysis were derivatized with optically active R-(+)-1-phenylethylisocyanate, to give diastereomeric carbamate mixtures, which were further separated by high performance liquid chromatography. Resolution of diastereomeric carbamates gave enantiomeric excess values, which reflect the lipases stereobias and clearly demonstrate the existence of a stereopreference by both gastric lipases for the sn-3 position. The stereoselectivity of human and rabbit gastric lipases, expressed as the enantiomeric excess percentage, was 54% and 70% for trioctanoin and 74% and 47% for triolein, respectively. The corresponding values with porcine pancreatic lipase were 3% in the case of trioctanoin and 8% in that of triolein. It is worth noting that rabbit gastric lipase, unlike human gastric lipase, became more stereoselective for the triglyceride with shorter acyl chains (trioctanoin). This is one of the most striking catalytic differences observed between these two gastric lipases.

Animals↗

Competitive inhibition of lipolytic enzymes. IV. Structural details of acylamino phospholipid analogues important for the potent inhibitory effects on pancreatic phospholipase A2.

1-Acyl-2(R)-acylamino phospholipids are effective competitive inhibitors of porcine pancreatic phospholipase A2 (EC 3.1.1.4, Bonsen et al. (1972) Biochim. Biophys. Acta 270, 364-382). By systematically varying the substituent at C-1 and the acyl chain length at C-2, a series of phospholipid analogues was obtained for which the inhibitory power was determined in a detergent-containing and occasionally also in a detergent-free micellar substrate system. The recently proposed kinetic model applicable to water-insoluble inhibitors (Ransac et al. (1990) Biochim. Biophys. Acta 1043, 57-66) allowed a quantitative comparison of the inhibitory power Z of the various substrate analogues. The most powerful inhibitors of the enzyme were found to possess the general 2-(R)-structure: (formula; see text) Using as substrate (R)-1,2-didodecanoylglycero-3-phosphocholine in mixed micelles with sodium taurodeoxycholate, the inhibitor molecule with m = 4 and n = 11 showed a Z-value of 15,000. This implies an affinity of the inhibitor for the active site of the enzyme higher than 4 orders of magnitude stronger as compared with the substrate molecule. Slightly higher and lower m-values resulted in a sharp drop of the inhibitory power, which suggests that the enzyme must possess a rather short, but well-defined hydrophobic binding pocket for the C-1 alkyl chain. Variation of n (keeping m = 2 constant) resulted in inhibitors with nearly equal Z-values for n = 11, 13 and 15. Most probably the binding cleft on the enzyme for the C-2 acylamino chain is longer, more losely constructed and contributing less to the overall binding energy. Several members of the 2-acylamino phospholipids are water-soluble and possess relatively high critical micelle concentrations. Their inhibitory power could be tested not only in micellar substrate dispersions but also in assay systems where both the inhibitor and substrate are molecularly dispersed. It appeared that these water-soluble phospholipid analogues are effective inhibitors of the enzyme only after incorporation into an organized substrate/water interface. In contrast, in molecularly dispersed substrate solutions the same molecules have completely lost their inhibitory power. These observations support our kinetic model of lipolysis and interfacial inhibition.

Animals↗

Competitive inhibition of lipolytic enzymes. I. A kinetic model applicable to water-insoluble competitive inhibitors.

It is now becoming clear from the abundant lipolytic enzyme literature that any meaningful interpretation of inhibition data has to take into account the kinetics of enzyme action at the lipid/water interface. We attempt in the present paper to provide a kinetic model applicable to water-insoluble competitive inhibitors, in order to quantitatively compare the results obtained at several laboratories. We derived kinetic equations applicable to the pre-steady state as well as steady state. By measuring the inhibitory power, as described in the present paper, it is possible to obtain a normalized estimation of the relative efficiency of various potential inhibitors. Furthermore, with the kinetic treatment developed here, it is possible to make quantitative comparisons with the same inhibitor placed under various physico-chemical situations, i.e., micellar or monolayer states.

Binding, Competitive↗

Crystallization and preliminary X-ray analysis of a lipase from Staphylococcus hyicus.

Single cyrstals of a lipase from Staphylococcus hyicus have been obtained using a combination of 18 to 24% dimethylsulfoxide and 10% isopropanol as a precipitant. The crystals grow at 4 degrees C in 2-3 months. They belong to the orthorhombic space group P212121 with a = 73.31 A, b = 77.96 A, and c = 169.81 A, with two protein molecules per asymmetrical unit. The crystals diffract to at least 2.8 A resolution and are suitable for an X-ray structure analysis.

Crystallization↗