Biomedical subjects

Savvas Stafilidis

Publications and source records attributed to Savvas Stafilidis.

8 recordsLinked to original sources

PubMed2006

Mechanical properties of the triceps surae tendon and aponeurosis in relation to intensity of sport activity.

The purpose of the present study was to investigate whether the mechanical properties (i.e. force strain relationship) of the triceps surae tendon and aponeurosis relate to the performed sport activity in an intensity-dependent manner. This was done by comparing sprinters with endurance runners and subjects not active in sports. Sixty-six young male subjects (26+/-5 yr; 183+/-6 cm; 77.6+/-6.7 kg) participated in the study. Ten of these subjects were adults not active in sports, 28 were endurance runners and 28 sprinters. All subjects performed isometric maximal voluntary plantar flexion contractions (MVC) on a dynamometer. The distal aponeuroses of the gastrocnemius medialis (GM) was visualised by ultrasound during the MVC. The results showed that only the sprinters had higher normalised stiffness (relationship between tendon force and tendon strain) of the triceps surae tendon and aponeurosis and maximal calculated tendon forces than the endurance runners and the subjects not active in sports. Furthermore, including the data of all 66 examined participants tendon stiffness correlated significantly (r=0.817, P<0.001) with the maximal tendon force achieved during the MVC. It has been concluded that the mechanical properties of the triceps surae tendon and aponeurosis do not show a graded response to the intensity of the performed sport activity but rather remain at control level in a wide range of applied strains and that strain amplitude and/or frequency should exceed a given threshold in order to trigger additional adaptation effects. The results further indicate that subjects with higher muscle strength possibly increase the margin of tolerated mechanical loading of the tendon due to the greater stiffness of their triceps surae tendon and aponeurosis.

Adaptation, Physiological↗

PubMed2006

Influence of the muscle-tendon unit's mechanical and morphological properties on running economy.

The purpose of this study was to test the hypothesis that runners having different running economies show differences in the mechanical and morphological properties of their muscle-tendon units (MTU) in the lower extremities. Twenty eight long-distance runners (body mass: 76.8+/-6.7 kg, height: 182+/-6 cm, age: 28.1+/-4.5 years) participated in the study. The subjects ran on a treadmill at three velocities (3.0, 3.5 and 4.0 m s(-1)) for 15 min each. The V(O(2)) consumption was measured by spirometry. At all three examined velocities the kinematics of the left leg were captured whilst running on the treadmill using a high-speed digital video camera operating at 250 Hz. Furthermore the runners performed isometric maximal voluntary plantarflexion and knee extension contractions at eleven different MTU lengths with their left leg on a dynamometer. The distal aponeuroses of the gastrocnemius medialis (GM) and vastus lateralis (VL) were visualised by ultrasound during plantarflexion and knee extension, respectively. The morphological properties of the GM and VL (fascicle length, angle of pennation, and thickness) were determined at three different lengths for each MTU. A cluster analysis was used to classify the subjects into three groups according to their V(O(2)) consumption at all three velocities (high running economy, N=10; moderate running economy, N=12; low running economy, N=6). Neither the kinematic parameters nor the morphological properties of the GM and VL showed significant differences between groups. The most economical runners showed a higher contractile strength and a higher normalised tendon stiffness (relationship between tendon force and tendon strain) in the triceps surae MTU and a higher compliance of the quadriceps tendon and aponeurosis at low level tendon forces. It is suggested that at low level forces the more compliant quadriceps tendon and aponeurosis will increase the force potential of the muscle while running and therefore the volume of active muscle at a given force generation will decrease.

Adult↗

PubMed2005

Effect of different ankle- and knee-joint positions on gastrocnemius medialis fascicle length and EMG activity during isometric plantar flexion.

The purpose of this study was to provide evidence on the fact that the observed decrease in EMG activity of the gastrocnemius medialis (GM) at pronounced knee flexed positions is not only due to GM insufficiency, by examining muscle fascicle lengths during maximal voluntary contractions at different positions. Twenty-two male long distance runners (body mass: 78.5+/-6.7 kg, height: 183+/-6 cm) participated in the study. The subjects performed isometric maximal voluntary plantar flexion contractions (MVC) of their left leg at six ankle-knee angle combinations. To examine the resultant ankle joint moments the kinematics of the left leg were recorded using a Vicon 624 system with 8 cameras operating at 120 Hz. The EMG activity of GM, gastrocnemius lateralis (GL), soleus (SOL) and tibialis anterior (TA) were measured using surface electromyography. Synchronously, fascicle length and pennation angle values of the GM were obtained at rest and at the plateau of the maximal plantar flexion using ultrasonography. The main findings were: (a) identifiable differences in fascicle length of the GM at rest do not necessarily imply that these differences would also exist during a maximal isometric plantar flexion contraction and (b) the EMG activity of the biarticular GM during the MVC decreased at a pronounced flexed knee-joint position (up to 110 degrees ) despite of no differences in GM fascicle length. It is suggested that the decrease in EMG activity of the GM at pronounced knee flexed positions is due to a critical force-length potential of all three muscles of the triceps surae.

Ankle Joint↗

PubMed2005

Inevitable joint angular rotation affects muscle architecture during isometric contraction.

The purpose of this study was to quantify the influence of inevitable ankle joint motion during an isometric contraction on the measured change of the gastrocnemius medialis muscle (GM) architecture in vivo during the loading and the unloading phase. Sitting on a dynamometer subjects performed isometric maximal voluntary contractions as well as contractions induced by electrostimulation. Synchronous joint angular motion, plantarflexion moment, foot's centre of pressure and real-time ultrasonography of muscle architecture changes of the GM were obtained. During the contraction the ankle joint position altered and significantly affected the change in muscle architecture. At maximal tendon force (1094+/-323 N), the measured fascicle length overestimated the change in fascicle length due to the tendon force by 1.53 cm, while the measured pennation angle overestimated the change in pennation angle due to the tendon force by 5.5 degrees . At the same tendon force the measured fascicle length and pennation angle were significantly different between loading and unloading conditions. After correcting the values for the change in ankle joint angle no differences between the loading and the unloading phase at the same tendon force were found. Concerning the estimation of GM fascicle length-force and pennation angle-force curves during the loading and unloading phase of an isometric contraction, these findings indicate that not accounting for ankle joint motion will produce unreliable results.

Ankle Joint↗

PubMed2005

Strain and elongation of the vastus lateralis aponeurosis and tendon in vivo during maximal isometric contraction.

The strain and elongation of the vastus lateralis (VL) tendon, tendon plus aponeurosis, and aponeurosis were examined during maximal voluntary contractions on a Biodex-dynamometer (knee angle 115 degrees , hip angle 140 degrees ) in 12 sprinters. Following a warm-up phase, the subjects were instructed to perform a gradual maximal knee extension and hold it for about 3 s. The kinematics of the leg were recorded using a Vicon 512 system with eight cameras operating at 120 Hz. Ultrasonography images were taken simultaneously from the VL myotendinous junction and the mid lateral part of the VL muscle belly. During the maximal isometric knee extensions, the knee joint rotated (13.6+/-5.9 degrees ), leading to an overestimation of the elongation of the tendinous tissues. After correcting for this, the maximal elongation of the VL tendon examined at the myotendinous junction was lower (P<0.05) than the maximal elongation of the VL tendon plus aponeurosis examined at the muscle belly (15 vs. 27 mm, respectively). The maximal estimated strains of the tendon, tendon plus aponeurosis, and aponeurosis showed no statistical differences (8+/-2%, 8+/-1%, and 7+/-2%, respectively, P>0.05). It is concluded that the strains of the human VL tendon, VL tendon plus aponeurosis, and VL aponeurosis, as estimated in vivo by two dimensional ultrasound during maximal isometric contractions, do not differ from each other. The displacement measured at a cross point in the VL muscle belly is significantly greater than that measured at the VL myotendinous junction.

Adult↗

PubMed2005

Differences between measured and resultant joint moments during isometric contractions at the ankle joint.

The purpose of this study was to examine two hypotheses: (a) during voluntary and electrically induced isometric contractions the moments measured at the dynamometer are different from the resultant moments in the same plane around the ankle joint and (b) at a given resultant moment during electrically induced isometric contractions the ankle angle while loading is different from the ankle angle while unloading. Twenty-seven long distance runners participated in the study. All subjects performed isometric maximal voluntary contractions (MVC) and contractions induced by electrostimulation at four different ankle-knee angle combinations on a Biodex-dynamometer. The kinematics of the leg were recorded using the vicon 624 system with eight cameras operating at 120 Hz. The main findings were: (a) the resultant moment at the ankle joint and the moment measured by the Biodex-dynamometer during isometric contractions are different, (b) during a plantar flexion effort the ankle angle changes significantly, whereas the knee angle shows only small and in most cases not significant changes, and (c) at identical resultant ankle joint moments the ankle angles are different between the loading and the unloading phases. The observed differences may lead to erroneous conclusions concerning the following: (a) diagnostic of muscle architecture, (b) estimation of the moment-ankle angle relationship and (c) estimation of the strain and hysteresis of tendons and aponeuroses.

Ankle Joint↗

PubMed2004

Differences between measured and resultant joint moments during voluntary and artificially elicited isometric knee extension contractions.

OBJECTIVE: Examine two hypotheses: (a) during isometric knee extension contractions the moment measured at the dynamometer is different from the resultant moment in the same plane around the knee joint and (b) during isometric contractions, at the same given resultant moment the knee angle while loading is different from the knee angle while unloading. DESIGN: Comparative study in which the geometrical and the kinetic differences between joint and dynamometer were determined. BACKGROUND: It is usually assumed that the moment measured by the dynamometer is equivalent to the resultant joint moment. The non-rigidity of the dynamometer-leg system can influence the equivalence of these two moments. METHOD: Twenty seven subjects performed isometric maximal knee extension contractions and contractions induced by electrostimulation on a dynamometer. The kinematics of the leg were recorded using 8 cameras (120 Hz). RESULTS: The resultant moment at the knee joint and the moment measured by the dynamometer are different. During a knee extension effort the knee angle changes significantly. At identical resultant knee joint moments the knee angles are different when comparing the loading and the unloading phases. CONCLUSIONS: The differences between the measured and the resultant joint moments might influence the estimation of parameters as: muscle forces, moment-angle relationship and strain and hysteresis of tendons and aponeuroses. RELEVANCE: Torque dynamometers have been often used to estimate muscle forces, to examine neuromuscular processes and to determine the mechanical properties of tendons and aponeuroses.

Biomechanical Phenomena↗

PubMed2004

Interaction of the human body and surfaces of different stiffness during drop jumps.

PURPOSE: The purpose of this study was to examine two hypotheses: (a) the stiffness of the surface influences the leg stiffness of the subjects during drop jumps, and (b) drop jumping performance (jumping height and energy rates of the subject's center of mass during the contact phase) increases when decreasing surface stiffness due to a greater energy storage capacity of the surface for a given acting force. METHODS: Ten female subjects performed a series of drop jumps from 40-cm height onto two sprung surfaces with different stiffness. Those trials of each subject displaying the maximal mechanical power during the upward phase were analyzed. The ground reaction forces were measured using a force plate. Sagittal kinematics of the subject's body positions and the deformation of the surface were recorded using two high-speed video cameras. RESULTS: On the soft surface, the jumping height and the energy rates of the subjects during the contact phase were greater than on the hard one. The energy delivered by the subjects during the upward phase, the leg and joint stiffness, as well as the range of motion of the subjects remained unchanged for both surfaces. CONCLUSIONS: The absolute energy loss is lower for the hard surface, but the jumping performance is greater for the soft one. The reason is a higher ratio of positive to negative mechanical work done by the subjects during the contact phase. The adjustment of the subjects to different surfaces is not only dependent on the stiffness of the surface but also on the intensity of the movement.

Algorithms↗