Biomedical subjects

Seniz Karacay

Publications and source records attributed to Seniz Karacay.

8 recordsLinked to original sources

PubMed2007

Tumor necrosis factor-alpha levels during two different canine distalization techniques.

OBJECTIVES: To compare levels of tumor necrosis factor (TNF)-alpha while applying continuous and heavy interrupted forces. MATERIALS AND METHODS: A hybrid retractor was used in the first group. In the second group, rapid canine distalization through periodontal distraction was performed. Gingival crevicular fluid samples were collected from the distal sides of the canine teeth before attaching the appliances and at 1 hour, 24 hours, and 1 week after the force was applied. RESULTS: In the hybrid reactor group, concentration of TNF-alpha decreased at 1 week according to 24-hour measurements. In the rapid canine distalization group, it severely increased at 1 hour. In the evaluation of between-group differences, significantly higher values were determined in the rapid canine distalization group at 1 hour and 1 week. CONCLUSIONS: Heavy interrupted force induces a rapid release of TNF-alpha, and the tissue response continues for a longer time period. To avoid the harmful effects of heavy interrupted force, there might be feedback mechanisms that prevent the mediators from increasing excessively.

Adolescent↗

PubMed2006

Use of zygomatic anchors during rapid canine distalization: a preliminary case report.

Rapid canine distalization is a technique involving periodontal ligament distraction. The primary aim of this technique is to distalize the canines without anchorage loss and to shorten the duration of orthodontic treatment. After the rapid canine distalization, the healing process of the periodontal ligament is similar to rapid palatal expansion and requires a consolidation period. The long consolidation period of the technique conflicts with the second aim. Skeletal anchorage systems seem to compensate for this conflict because they can be also used for retraction of incisors during consolidation period. This case report presents the orthodontic treatment of a 16-year-old female, who had a bimaxillary retrusion and a dental Class II division I malocclusion. Upper first premolars were extracted and, while the canines were being distalized rapidly by periodontal ligament distraction, the incisors were retracted using a zygomatic anchorage system. The treatment of the patient was completed in five months without any anchorage loss.

Adolescent↗

PubMed2006

Forsus Nitinol Flat Spring and Jasper Jumper corrections of Class II division 1 malocclusions.

OBJECTIVE: To compare the effects of Forsus Nitinol Flat Spring (FNFS) and Jasper Jumper (JJ) in the correction of Class II division I malocclusions. MATERIALS AND METHODS: Our research was conducted on 48 adolescents, who had a normal or horizontal growth pattern and retrognathic mandible. The patients were divided into three equal groups randomly. First group was treated with FNFS, and the second group was treated with JJ appliances, whereas the third group was the control group. Lateral cephalograms and study models were obtained after the leveling phase and at time of the removal of the appliances. RESULTS: Cephalometric analysis revealed that both the appliances stimulated mandibular growth, increased the anterior face height because of the lower face, and elongated the posterior face height because of the growth of temporomandibular joint. Maxillary central incisors were extruded, retruded, and distally tipped. Contrarily, intrusion, protrusion, and labial tipping were observed in the mandibular central incisors. Distal movement and intrusion of the maxillary first molars and mesial movement and extrusion of the mandibular first molars were the other dental alterations. Overjet and overbite were decreased, and a Class I molar relationship and improvement in the profile were attained in both treatment groups. Cast model analysis showed expansion in the maxillary and mandibular dental arches. CONCLUSIONS: Both the appliances were effective in the treatment of Class II malocclusion and revealed nearly same alterations in the skeletal, dental, and soft tissue parameters.

Activator Appliances↗

PubMed2006

Dynamic MRI evaluation of tongue posture and deglutitive movements in a surgically corrected open bite.

Tongue thrust usually develops in the presence of anterior open bite in order to achieve anterior valve function. In the literature, tongue thrust is described both as the result and the cause of open bite. If it is an adaptation to malocclusion, then tongue posture and deglutitive tongue movements should change after treatment. In this case report, an adult who had skeletal open bite and Class II malocclusion caused by mandibular retrusion was treated surgically. The mandible was advanced in a forward and upward direction with a sagittal split osteotomy. The open bite and Class II malocclusion were corrected and an increase in the posterior airway space (PAS) was observed. Pretreatment and posttreatment dynamic magnetic resonance imaging (MRI) revealed that tongue tip was retruded behind the incisors and contact of the tongue with the palate increased. It was also determined that the anterior and middle portions descended, whereas the posterior portion was elevated at all stages. Advancement of the mandible, correction of open bite, and an increase in PAS affected not only the tongue posture and deglutitive movements, but also the breathing pattern of the patient.

Adult↗

PubMed2005

Dentofacial effects of asymmetric headgear and cervical headgear with removable plate on unilateral molar distalization.

Cervical headgear (CHG) is used widely in the treatment of Class II anomalies. Asymmetric headgear (AHG) is an alternative treatment for the correction of unilateral Class II dental relationships. The purpose of this investigation was to compare the effects of AHG with those of a CHG combined with a removable plate in unilateral first molar distalization. The study consisted of 20 patients with unilateral Class II molar relationship (12 girls and eight boys). One group of 10 patients was treated with an AHG, and a second group of 10 patients was treated with a CHG and a removable plate. Lateral cephalograms and basilar radiographs were taken before and after molar distalization. It was found that distalization and distal tipping of molar on the passive side was less in the CHG and removable plate (CHG-RP) group. Distalization and distal tipping of the second premolar on the distalization side was also reduced in this group. Incisors were retruded in both groups but were retruded more in the CHG-RP group.

Adolescent↗

PubMed2005

Mandibular distraction with MD-DOS device.

Distraction osteogenesis is an alternative treatment method for the correction of mandibular hypoplasia. In this case report, mandibular distraction with a dynamic osteosynthesis system (MD-DOS) was performed to gradually lengthen the mandible of a patient who had a severe hypoplastic mandible. The patient underwent intraoral bilateral mandibular distraction osteogenesis. The latency period after the operation was seven days. The distraction was performed three times daily for 14 days at the rate of 0.33 mm each time. Subsequent retention was nine weeks. The patient's mandible was elongated successfully and a satisfactory profile and occlusion was achieved.

Adult↗

PubMed2004

Initial intrusion of the molars in the treatment of anterior open bite malocclusions in growing patients.

The treatment of the hyperdivergent phenotype and/or anterior openbite is one of the common problems facing orthodontists. The purpose of this study is to present a new appliance (Molar Intruder) for molar intrusion and to determine its effects in the treatment of anterior openbite. The study group comprised 14 patients (eight girls and six boys), with a mean age of 10 years and 7 months. All presented anterior open bite malocclusions between the second premolars. The study was carried out on lateral head films taken before (T1) and after (T2) molar intrusion. Periapical radiographs, study models, and standard photographs of all the patients were also obtained before and after molar intrusion. The paired sample t-test was used to determine the differences between the parameters. The average treatment time with the Molar Intruder was five months. The mean intrusion of maxillary and mandibular molars was 1.86 mm and 1.04 mm, respectively. Maxillary incisors extruded 0.54 mm with a labial tipping of 1.46 degrees and overbite increased by 4.00 mm. The mandibular plane angle was decreased by 1.57 degrees, and the anterior face height was decreased by 1.86 mm on average. The mandible showed a counterclockwise rotation, the chin moved forward, and the posterior facial height/anterior facial height ratio was increased. Anterior openbites of the patients were significantly rehabilitated at the end of the intrusion period, simplifying further orthodontic treatment.

Cephalometry↗

PubMedDate not supplied

Management of a fused central incisor in association with a macrodont lateral incisor: a case report.

Fusion is developmental anomaly of the dental hard tissue and is defined as the joining of 2 developing tooth germs resulting in a single large tooth structure. Different treatment methods can be used according to the requirements of the situation. The purpose of this case report was to present the multidisciplinary treatment of a patient who had a permanent maxillary left central tooth fused with a supernumerary incisor and a macrodont permanent maxillary right lateral incisor. In the radiographic evaluation, it was determined that the fused tooth had 2 separate roots. The supernumerary tooth was extracted after hemisection, and endodontic treatment was performed on the remaining portion. The distal side of the macrodont lateral incisor was recontoured, and the right central incisor was reshaped with a strip crown to provide aesthetic appearance and to gain space for the alignment of teeth. Following the restoration of the incisors, orthodontic treatment was provided.

Adolescent↗