PubMed Health⌕ Search

Biomedical subjects

Serge Ravaine

Publications and source records attributed to Serge Ravaine.

7 recordsLinked to original sources
PubMed2007

Macroporous ultramicroelectrodes for improved electroanalytical measurements.

Recent work on the preparation of highly organized macroporous electrodes and nanoporous ultramicroelectrodes has been combined and extended to elaborate macroporous ultramicroelectrodes (UMEs) by template synthesis using colloidal crystals and following two different and complementary methods. On the one hand, arched porous UMEs were prepared, and on the other hand, cylindrical porous UMEs were obtained by using cavity UMEs. These macroporous UMEs have an active surface area which is up to 2 orders of magnitude higher compared to that of a classical disk UME as characterized by cyclic voltammetry. To study their analytical performance, the macroporous UMEs have been modified with a redox-active thiol and also a model bioelectrocatalytical system containing a redox mediator, a cofactor, and glucose-dehydrogenase. In both cases the electrochemical signal is amplified by up to 2 orders of magnitude, which increases significantly the analytical performance of such electrodes and therefore opens up new applications for this kind of miniaturized electrochemical system.

Journal Article↗
PubMed2006

Three-dimensional opal-like silica foams.

The synthesis of novel meso-/macroporous SiO2 monoliths by combining a nano-building-blocks-based approach with the confined geometry of a tailored air-liquid foam structure is described. The resulting macrostructure in which ordered close-packed colloidal silica nanoparticles constitute the monolith's scaffolds very closely resembles the tailored periodic air-liquid foam template. The void spaces between adjacent particles create textural mesoporosity; therefore, the as-prepared silica networks are characterized by hierarchical porosity at the macroscopic and mesoscopic length scales. The fine-tuning of both the liquid foam's fraction and the bubble size allows a rational design over the macroscopic cell morphologies (shape, Plateau border's length, and width). Striking results of this approach are the weak shrinkage of the as-synthesized opal-like scaffolds during the thermally induced sintering process and, in contrast with previous studies, the formation of closed-cell structures. Particle organization and the foam film surface roughness are investigated by atomic force microscopy (AFM), showing the influence of the liquid flow, within the foams' Plateau borders and films, on the final assemblies.

Journal Article↗
PubMed2006

Nucleation of polystyrene latex particles in the presence of gamma-methacryloxypropyltrimethoxysilane: functionalized silica particles.

Silica/polystyrene nanocomposite particles with different morphologies were synthesized through emulsion polymerization of styrene in the presence of silica particles previously modified by gamma-methacryloxypropyltrimethoxysilane (MPS). Grafting of the silane molecule was performed by direct addition of MPS to the aqueous silica suspension in the presence of an anionic surfactant under basic conditions. The MPS grafting density on the silica surface was determined using the depletion method and plotted against the initial MPS concentration. The influence of the MPS grafting density, the silica particles size and concentration and the nature of the surfactant on the polymerization kinetics and the particles morphology was investigated. When the polymerization was performed in the presence of an anionic surfactant, transmission electron microscopy images showed the formation of polymer spheres around silica for MPS grafting densities lower than typically 1 micromole x m(-2) while the conversion versus time curves indicated a strong acceleration effect under such conditions. In contrast, polymerizations performed in the presence of a larger amount of MPS moieties or in the presence of a non ionic emulsifier resulted in the formation of "excentered" core-shell morphologies and lower polymerization rates. The paper identifies the parameters that allow to control particles morphology and polymerization kinetics and describes the mechanism of formation of the nanocomposite colloids.

Kinetics↗
PubMed2005

Polyoxometalate monolayers in Langmuir-Blodgett films.

Langmuir and Langmuir-Blodgett (LB) films of a variety of polyoxometalates of different shapes, sizes, and charges were prepared by taking advantage of the adsorption properties of these polyanions on a positively charged monolayer of an organic surfactant spread on water. Three different aspects were investigated. 1) The electrochemical and electrochromic properties of LB films containing the easily reducible polyoxoanion [P2Mo18O62]6-. Absorbance changes of these LB films deposited onto an ITO substrate have been induced by repeated switching of the applied potential. These changes are due to the formation of the colored reduced forms of the polyanion. Coloration and bleaching of the LB film occur very quickly and are reversible. 2) The preparation of LB films based on magnetic polyoxometalates, such as the Keggin anions, [CoW12O40]6- and [SiMn(OH2)W11O39]6-, or containing magnetic clusters of increasing nuclearities such as [Co4(H2O)2(PW9O34)2]10- and [Co4(H2O)2(P2W15O62)2]16- based on a Co4O16 ferromagnetic cluster, and the polyoxometalates [Co9(OH)3(H2O)6(HPO4)2(PW9O34)3]16- and [Ni9(OH)3-(H2O)6(HPO4)2(PW9O34)3]16- based on a nonanuclear M9O36 cluster. 3) The preparation of LB films of the giant heteropolyoxomolybdate, [Na3(NH4)12][Mo57Fe6(NO)6O174(OH)3-(H2O)24]76 H2O.

Electrochemistry↗
PubMed2004

Three-dimensional colloidal crystals with a well-defined architecture.

Monodisperse silica spheres with diameters of 220-1100 nm were prepared by hydrolysis of tetraethyl orthosilicate (TEOS) in an alcoholic medium in the presence of water and ammonia. By grafting vinyl or amino groups onto silica surfaces using the coupling agents allyltrimethoxysilane and aminopropyltriethoxysilane, respectively, amphiphilic silica spheres were obtained and could be organized to form a stable Langmuir film at the air-water interface. The controlled transfer of this monolayer of particles onto a solid substrate gave us the ability to build three-dimensional regular crystals with a well-defined thickness and organization. These colloidal crystals diffract light in the UV, the visible, and the near-infrared (NIR) spectral regions, depending on the size of the silica spheres and according to Bragg's law. The depth of the photonic stop band can be tuned by varying the number of deposited layers of particles. By using successive depositions, we could prepare multilayered films with silica spheres of different sizes. The thickness of each slab in the binary crystals can be tuned at the layer level, while the crystalline order of each layer is well preserved.

Colloids↗