Shao-xiong Min | PubMed Health

PubMed2006

[Development of an anti-infection nano-hydroxypatite drug delivery microsphere and its drug-release in vitro].

OBJECTIVE: To develop an anti-infection nano-hydroxypatite (nano-HA) microsphere for local drug delivery for treating osteomyelitis. METHODS: The nano-HA was used as the core carrier to load gentamicin (GM) and coated with poly(-hydroxybutyrate-co- hydroxyvalerate)/polyethylene glycol (PHBV/PEG), which was degradable and biocompatible, to prepare nano-HA-PHBV/PEG-GM microsphere. The surface structure and in vitro drug-release of the microsphere were studied. RESULTS: The microsphere had good drug delivery capability. The samples weighing 90 mg each were soaked in PBS and gentamicin release within the first day was 165.2 microg/ml, which maintained a low release rate in the following days. After 28 days, gentamicin release declined to 8.5 microg/ml, which was higher than the minimal inhibitory concentration of gentamicin (2 microg/ml). CONCLUSION: The local drug delivery system has good drug-release performance in vitro and may possess potential value in clinical management of osteomyelitis.

Anti-Bacterial Agents↗

PubMed2003

Three-dimensional porous poly-DL-lactide/basic fibroblast growth factor composites for bone defect repair: an experimental study.

OBJECTIVE: To investigate the osteoinductive ability of the composites consisting of basic fibroblast growth factor (bFGF) and porous poly-DL-lactide (PDLLA) for the development of a new absorbable osteosynthesis material. METHODS: Highly porous foams of PDLLA with the pore size ranging from 150 to 300 microm were prepared by a solvent-casting, particulate-leaching technique with NaCl as the leachable component. Animal models of radial diaphyseal defects of 1.0 cm with complete removal of the periosteum were induced in 45 rabbits, which were randomly divided into 3 groups to receive the defect repair with PDLLA and PDLLA/bFGF respectively, leaving one group untreated to serve as the control group. The implant specimens were harvested at 2, 4, 8, and 12 weeks respectively after the surgery and X-ray, histological and scanning electron microscopic (SEM) examinations were performed to evaluate the effectiveness of defect repair. At 8 and 12 weeks after implantation, biomechanical test (for three-point bending strength) was employed to study the quality of bone formation. RESULTS: PDLLA/bFGF composite stimulated more bone formation and had higher bending strength than PDLLA (P<0.05), and the bone formation induced by both materials was significantly more than that observed in the control group in every postoperative stage (P<0.05). CONCLUSION: PDLLA possesses good biocompatibility and absorbability, and when prepared into a porous material, it exhibits good osteoconductibility. As a good bFGF carrier, the foam of PDLLA with three- dimensional structure shows good osteoinductive ability with regard to the rapidity, quantity and quality of the bone formation.

Animals↗