Biomedical subjects

Shin-Ichi Yasueda

Publications and source records attributed to Shin-Ichi Yasueda.

3 recordsLinked to original sources

PubMed2005

Stability of latanoprost in an ophthalmic lipid emulsion using polyvinyl alcohol.

Latanoprost in water is not stable against heat stress due to hydrolysis of the isopropyl ester in the latanoprost molecule. Therefore, the storage condition of latanoprost ophthalmic solution, Xalatan brand, was in a low temperature (2-8 degrees C). We formulated a favorable ophthalmic lipid emulsion of latanoprost using polyvinyl alcohol as emulsifier which showed a good heat stability. The assays of the latanoprost ophthalmic lipid emulsions adjusted to pH 5.0, 6.0 and 7.0 were 100.4%, 100.7% and 99.2% after storage for 4 weeks at 60 degrees C, respectively. The possibility of room temperature storage for the latanoprost ophthalmic lipid emulsion was demonstrated.

Drug Stability↗

PubMed2004

Capturing of acidic macromolecules from biological samples using a temperature-responsive polymer modified with poly-l-lysine.

We synthesized a temperature-responsive polymer, N-(isopropylacrylamide)-methacrylic acid copolymer, to which poly-l-lysine was introduced. The synthesized polymer as well as the parent polymer showed reversible soluble-insoluble changes in response to temperature changes across the lower critical solution temperature at 32 degree C in an aqueous solution. We found that the polymer efficiently captured acidic bio-macromolecules such as RNA, glycosaminoglycans and mucin-type glycoproteins in biological samples, and the captured molecules were recovered using aqueous NaCl solutions at high concentration. The target acidic molecules thus obtained will be employed for further studies such as structural analysis after brief desalting procedure. The proposed method does not require any chromatographic separations, but only needs a small volume of an aqueous salt solution for releasing captured molecules. Overall procedures are quite easy and simple, and are completed at least within 1 h. We show a few examples for capturing RNA and glycosaminoglycans from cultured cells using the polymer.

Acrylamides↗

PubMed2004

Evaluation of ophthalmic suspensions using surface tension.

Uniformity and precision of single dose are required for ophthalmic suspensions including water-insoluble ingredients. Solid sediments formed after standing still must be immediately re-dispersible and distributed homogeneously before use. However, selection of an appropriate water-soluble polymer as suspending agent is a challenging problem. In this report, the relationship between the surface tension and the re-dispersibility of suspensions was investigated. The surface tension of 0.1 w/v% fluorometholone suspensions began to decline from 74 mN/m at 0.0001 w/v% of hydroxypropylmethylcellulose (HPMC) and became almost constant at 52 mN/m at 0.01 w/v% of HPMC. Re-dispersion time was less than 4 s when HPMC was present at concentrations between 0.0001 w/v% and 0.01 w/v%. At these concentrations, aggregation of suspended particles was not observed. When indomethacin suspensions at 1.0 w/v% concentration were used, the surface tension began to decline from 73 mN/m at 0.0005 w/v% HPMC and became constant at 50 mN/m at 0.005 w/v% HPMC. The suspension also showed good re-dispersibility, and a uniform suspension was obtained between 0.0005 w/v% and 0.005 w/v% of HPMC. The time required for re-dispersion was less than 17 s. The change of surface tension showed a good correlation with the concentration of HPMC in ophthalmic suspensions having good re-dispersibility. Measurement of the surface tension of suspensions provided the optimal concentration of the water-soluble polymers for the suspensions of well re-dispersible characteristics. Evaluation of ophthalmic suspension using surface tension is a good strategy for formulation of suspending pharmaceutical products in the ophthalmic area.

Dose-Response Relationship, Drug↗