Biomedical subjects

Steven L Krill

Publications and source records attributed to Steven L Krill.

6 recordsLinked to original sources

PubMed2007

Factors affecting the formation of eutectic solid dispersions and their dissolution behavior.

The objective of this work was to obtain a fundamental understanding of the factors, specifically the properties of poorly water-soluble drugs and water-soluble carriers, which influence predominantly, the formation of eutectic or monotectic crystalline solid dispersion and their dissolution behavior. A theoretical model was applied on five poorly water-soluble drugs (fenofibrate, flurbiprofen, griseofulvin, naproxen, and ibuprofen) having diverse physicochemical properties and water-soluble carrier (polyethylene glycol (PEG) 8000) for the evaluation of these factors. Of these, two drugs, fenofibrate and flurbiprofen, and PEG of different molecular weights (3350, 8000, and 20000), were chosen as model drugs and carriers for further investigation. Experimental phase diagrams were constructed and dissolution testing was performed to assess the performance of the systems. The theoretical model predicted the formation of eutectic or monotectic solid dispersions of fenofibrate, griseofulvin, ibuprofen, and naproxen with PEG, holding the contribution of specific intermolecular interactions between compound and carrier to zero. In the case of the flurbiprofen-PEG eutectic system, intermolecular interactions between drug and polymer needed to be taken into consideration to predict the experimental phase diagram. The results of the current work suggest that the thermodynamic function of melting point and heat of fusion (as a measure of crystal energy of drug) plays a significant role in the formation of a eutectic system. Lipophilicity of the compound (as represented by cLog P) was also demonstrated to have an effect. Specific interactions between drug and carrier play a significant role in influencing the eutectic composition. Molar volume of the drug did not seem to have an impact on eutectic formation. The polymer molecular weight appeared to have an impact on the eutectic composition for flurbiprofen, which exhibits specific interactions with PEG, whereas no such impact of polymer molecular weight on eutectic composition was observed for fenofibrate, which does not exhibit specific interactions with PEG. The impact of polymer molecular weight on dissolution of systems where specific drug-polymer interactions are exhibited was also observed. The current work provides valuable insight into factors affecting formation and dissolution of eutectic systems, which can facilitate the rational selection of suitable water-soluble carriers.

Drug Carriers↗

PubMed2006

Predictions of onset of crystallization from experimental relaxation times I-correlation of molecular mobility from temperatures above the glass transition to temperatures below the glass transition.

PURPOSE: Predicting onsets of crystallization at temperatures below T (g), from data above T (g), would require that the correlation between crystallization onset and mobility is same above and below T (g), and the techniques being used to measure mobility above and below T (g) are measuring essentially the same kind of mobility. The aim of this work is to determine if the relaxation times obtained using different techniques (DSC, TAM) below T (g) correlate with relaxation time obtained above T (g) using dielectric spectroscopy. METHODS: Model compounds for this work were chosen based on their varied DeltaH (f), DeltaC (p)(T (g)) and H-bonding in crystalline state vs. amorphous state. Relaxation times above T (g) were determined by the simultaneous fit of real and imaginary permittivity to the Cole-Davidson model. Tau and beta below T (g) were determined using isothermal microcalorimetry (TAM) or MDSC. MDSC was used to calculate Kauzmann temperature and strength of the glass using established relationships. RESULTS: Indomethacin, nifedipine and flopropione showed Arrhenius temperature dependence throughout the entire temperature range and extrapolation of tau ( beta ) measured above T (g) by dielectric relaxation agreed with tau ( beta ) measured below T (g) by TAM/MDSC. Ketoconazole, however, showed the expected VTF behavior. For at least two compounds compared (indomethacin and ketoconazole), relaxation times measured by TAM and MDSC did not agree, with TAM giving significantly lower values of tau ( beta ), but TAM and MDSC relaxation times appeared to extrapolate to a common value at T (g). CONCLUSIONS: It was found that, for all cases studied, relaxation time constants determined above and below T (g) did appear to extrapolate to the same value around T (g) indicating that molecular mobility measured above and below T (g) using different techniques is highly correlated.

Calorimetry↗

PubMed2004

Ritonavir-PEG 8000 amorphous solid dispersions: in vitro and in vivo evaluations.

Ritonavir is a large, lipophilic molecule that is practically insoluble in aqueous media and exhibits an exceedingly slow intrinsic dissolution rate. Although it has favorable lipophilicity, in vitro permeability studies have shown that ritonavir is a substrate of P-glycoprotein. Thus, the oral absorption of ritonavir could be limited by both dissolution and permeability, thereby making it a Class IV compound in the Biopharmaceutics Classification System. Because formulations rarely exert direct influence on local intestinal permeability, the effect of enhanced dissolution rate on oral absorption was explored. More specifically, poly(ethylene glycol) (PEG)-amorphous ritonavir solid dispersions were prepared with different drug loadings, and the in vitro and in vivo performances of the dispersions were evaluated. In vitro dissolution was conducted in 0.1N HCl with a USP Apparatus I. A crossover design was used to evaluate the oral bioavailability of amorphous dispersions relative to crystalline drug in beagle dogs. Intrinsic dissolution measurements of the two solid phases indicated a 10-fold improvement in intrinsic dissolution rate for amorphous ritonavir compared with the crystalline counterpart. In vitro dissolution of ritonavir depended on the solid phase as well as drug loading of the dispersion. In vivo study results indicate that amorphous solid dispersions containing 10-30% drug exhibited significant increases in area under the curve of concentration versus time (AUC) and maximum concentration (C(max)) over crystalline drug. For example, 10% amorphous dispersion exhibited increases of 22- and 13.7-fold in AUC and C(max), respectively. However, both in vitro dissolution and bioavailability decreased with increasing drug load, which led to the construction of a multiple Level C in vitro-in vivo relationship for this Class IV compound. The established relationship between in vitro dissolution and in vivo absorption can help guide formulation development.

Absorption↗

PubMed2004

A mechanistic investigation of an amorphous pharmaceutical and its solid dispersions, part I: a comparative analysis by thermally stimulated depolarization current and differential scanning calorimetry.

PURPOSE: To explore using thermally stimulated depolarization current (TSDC), in comparison to differential scanning calorimetry (DSC), for the characterization of molecular mobility of an amorphous pharmaceutical new chemical entity (LAB687), an amorphous polymer (PVPK-30), and their combination as solid dispersions at different % drug loadings. METHODS: Amorphous drug was prepared by quenching from the melt. Solid dispersions containing 10-60% of drug in polymer were prepared by solvent evaporation method. Glass transition temperatures (Tg) were determined by DSC and TSDC. RESULTS: In comparison to a single T. obtained from DSC for the drug substance, TSDC shows two overlapping relaxations. Both peaks correspond to a-relaxations that are associated with the glass transition, with the second peak corresponding to the rigid fraction that is difficult to be detected by DSC because it is associated with only small changes in heat capacity. Two overlapping relaxations were also observed for the polymer vs. one Tg by DSC. The lower temperature relaxation is believed to be a beta-relaxation, whereas the higher temperature transition corresponds to an alpha-relaxation. For the solid dispersions, one single peak was obtained for each of the 20% and 30% dispersions in excellent agreement with the DSC results. However, at the 40% drug load, a small shoulder was observed by TSDC at the low temperature of the main peak. This shoulder becomes more pronounced and overlaps with the main peak as the drug load increases to 50% and 60%. Agreement between the Tg values calculated by the Gordon-Taylor equation and the DSC and TSDC experimental data, especially for the 20% and 30% drug loading, indicate ideal miscibility. At higher drug loads, only by TSDC was it possible to detect the saturation level of the drug in the polymer. CONCLUSIONS: TSDC proved to be very sensitive in detecting small reorientational motions in solids and in separating overlapping events with only slight differences in molecular motion exhibited as broad events in DSC. This allowed for detection of the rigid fraction of the amorphous drug, the sub-glass transition beta- relaxation in the polymer, and the limit of miscibility between the drug and the polymer in the solid dispersions.

Calorimetry, Differential Scanning↗

PubMed2004

A mechanistic investigation of an amorphous pharmaceutical and its solid dispersions, part II: molecular mobility and activation thermodynamic parameters.

PURPOSE: The ability of TSDC to characterize further amorphous materials beyond that possible with DSC was presented in part I (16) of this work. The purpose of part II presented here is to detect and quantitatively characterize time-scales of molecular motions (relaxation times) in amorphous solids at and below the glass transition temperature, to determine distributions of relaxation times associated with different modes of molecular mobility and their temperature dependence, and to determine experimentally the impact upon these parameters of combining the drug with excipients (i.e., solid dispersions at different drug to polymer ratios). The knowledge gleaned may be applied toward a more realistic correlation with physical stability of an amorphous drug within a formulation during storage. METHODS: Preparation of amorphous drug and its solid dispersions with PVPK-30 was described in part I (16). Molecular mobility and dynamics of glass transition for these systems were studied using TSDC in the thermal windowing mode. RESULTS: Relaxation maps and thermodynamic activation parameters show the effect of formulating the drug in a solid dispersion on converting the system (drug alone) from one with a wide distribution of motional processes extending over a wide temperature range at and below Tg to one that is homogeneous with very few modes of motion (20% dispersion) that becomes increasingly less homogeneous as the drug load increases (40% dispersion). This is confirmed by the high activation enthalpy (due to extensive intra- and intermolecular interactions) as well as high activation entropy (due to higher extent of freedom) for the drug alone vs. a close to an ideal system (lower enthalpy), with less extent of freedom (low entropy) especially for the 20% dispersion. The polymer PVPK-30 exhibited two distinct modes of motion, one with higher values of activation enthalpies and entropy corresponding to alpha-relaxations, the other with lower values corresponding to beta-relaxations characterized by local noncooperative motional processes. CONCLUSIONS: Using thermal windowing, a distribution of temperature-dependent relaxation times encountered in real systems was obtained as opposed to a single average value routinely acquired by other techniques. Relevant kinetic parameters were obtained and used in mechanistically delineating the effects on molecular mobility of temperature and incorporating the drug in a polymer. This allows for appropriate choices to be made regarding drug loading, storage temperature, and type of polymer that would realistically correlate to physical stability.

Algorithms↗

PubMed2003

Properties of rapidly dissolving eutectic mixtures of poly(ethylene glycol) and fenofibrate: the eutectic microstructure.

Poly(ethylene glycol) or PEG is an ideal inactive component for preparing simple binary eutectic mixtures because of its low entropy of fusion ( approximately 0.0076 J/mol-K), lower melting point (approximately 62 degrees C) compared to most pharmaceuticals, miscibility with drugs at elevated temperatures, and its covalent crystalline lattice. Implication of these physicochemical properties on eutectic crystallization and size reduction of the drug is discussed. Enhancement of the dissolution rate of a poorly soluble compound through the formation of PEG-drug eutectics was investigated using fenofibrate. Solid dispersions of PEG-fenofibrate when characterized, revealed that PEG and fenofibrate form a simple eutectic mixture containing 20-25%(w/w) fenofibrate at the eutectic point. Eutectic crystallization led to the formation of an irregular microstructure in which fenofibrate crystals were found to be less than 10 microm in size. Dissolution rate improvement of fenofibrate correlated with the phase diagram, and the amount of fenofibrate released from the dispersions that contained fenofibrate as a eutectic mixture was at least 10-fold higher compared to untreated fenofibrate. On aging, the dissolution rate of the dispersion containing 15%(w/w) fenofibrate in PEG remained unaltered. The results indicate that PEG-drug eutectic formation is a valuable option for particle size reduction and subsequent dissolution rate improvement.

Chemistry, Pharmaceutical↗