PubMed Health⌕ Search

Biomedical subjects

Sunao Yamada

Publications and source records attributed to Sunao Yamada.

10 recordsLinked to original sources
PubMed2006

Stabilizing of plasmid DNA in vivo by PEG-modified cationic gold nanoparticles and the gene expression assisted with electrical pulses.

This study aimed to investigate the benefits of combining the use of PEG-modified cationic gold nanoparticles with electroporation for in vivo gene delivery. PEG-modified cationic gold nanoparticles were prepared by NaBH(4) reduction of HAuCl(4) in the presence of 2-aminoethanethiol and mPEG-SH. Zeta-potential of the particles was nearly neutral (+0.1 mV). After forming complexes with plasmid DNA at a w/w ratio of 8.4, nanoparticle complexes were 90 nm for at least 60 min and showed a negative zeta-potential. After intravenous injection of DNA-nanoparticle complexes, 20% of gold were detected in blood at 120 min after injection and 5% of DNA were observed in blood after 5 min, suggesting that PEG-modified nanoparticles were stably circulating in the blood flow, but some of the DNA bound to particles degraded during circulation. When electroporation was applied to a lobe of the liver following injection of DNA-nanoparticle complexes, significant gene expression was specifically observed in the pulsed lobe. We concluded that PEG-modified nanoparticles maintained DNA more stably in the blood flow than in the case of naked DNA and electroporation assisted in restricted gene expression of circulating DNA in limited areas of the liver.

Animals↗
PubMed2006

Modification of gold nanorods using phosphatidylcholine to reduce cytotoxicity.

Hexadecyltrimethylammonium bromide (CTAB), which is necessary for the preparation of gold nanorods (NRs), was extracted from a NR solution into a chloroform phase containing phosphatidylcholine (PC). After three extractions, the zeta potential of the NRs remained positive, but its magnitude decreased from +67 +/- 1 to +15 +/- 1 mV. Transmission electron microscopy and energy-dispersive X-ray analysis indicated that the NRs were passivated with PC. The PC layer on the NR surface contributed to the prevention of NR aggregation. The PC-passivated NRs showed low cytotoxicity in comparison with twice-centrifuged NRs. It was shown that a negligible amount of CTAB was dispersed in the NR solution after the extraction. The extraction using a chloroform phase containing PC was found to be a convenient way of replacing the CTAB with alternative capping agents such as PC. This is a key technique for preparing functional NRs that can have practical applications.

Cell Survival↗
PubMed2005

A photoelectronic switching device using a mixed self-assembled monolayer.

A cathodic-anodic biway photoelectronic device has been successfully constructed using a self-assembled monolayer (SAM). The SAM consists of two kinds of photofunctional thiol derivatives, a ruthenium complex-viologen linked compound (RuVS) and a phthalocyanine derivative (PcS), on a gold electrode. Structural characterization of the SAM has been carried out by absorption spectroscopy, cyclic voltammetry, and differential pulse voltammetry. Photocurrent responses were measured in the presence of methyl viologen (MV2+) and oxygen as electron acceptors and triethanolamine (TEOA) as a sacrificial reagent. For the SAM of RuVS alone, intramolecular electron transfer (ET) was superior to intermolecular ET, resulting in anodic photocurrents even in the presence of MV2+ and oxygen at 0 V vs Ag/AgCl. On the contrary, only cathodic photocurrents were observed at 0 V for the SAM of PcS alone. Photocurrents from the mixed SAM of RuVS and PcS were roughly the sum of individual photocurrents from RuVS and PcS. In fact, photocurrents from the mixed SAM of RuVS and PcS were observed in the anodic direction below approximately 550 nm, and in the cathodic direction above approximately 550 nm at 0 V vs Ag/AgCl. In the case of the mixed SAM of RuS (ruthenium complex disulfide) and PcS, only cathodic photocurrents were observed at 0 V vs Ag/AgCl, due to the lack of an intramolecular ET pathway. The results indicate that in the mixed SAM of RuVS and PcS both dyes can individually function for opposite photocurrent generation. We have also applied the mixed SAM as a photoelectronic logic device by using two LEDs (470 and 640 nm). The system clearly operated as an XOR logic device.

Journal Article↗
PubMed2003

Proton-sensitive fluorescent organogels.

A 1,10-phenanthroline-appended cholesterol-based gelator (1) and its nongelling reference compound (2) were synthesized. Among 19 solvents tested herein, gelator 1 could gelate 11 solvents including alcohols, dipolar aprotic solvents, organic acids and a base (triethylamine), indicating that 1 acts as a versatile gelator. The TEM observation gave a visual image showing that fibrillar aggregates are entangled in the three-dimensional network structure. In the fluorescence measurements, most gels afforded an emission maximum at 394 nm (purple emission), whereas only the acetic acid gel afforded an emission maximum at 522 nm (yellow emission). Thus, the influence of protonation of the 1,10-phenanthroline nitrogens (by trifluoroacetic acid) on the fluorescence properties in the gel phase was investigated in detail. The results have established that the fluorescence intensity of 1 x H+ becomes particularly strong in the gel phase, presumably because of the energy transfer from neutral 1* to protonated 1 x H+ and the restriction of the 1 x H+ molecular motion. The finding suggests the possibility that the gel system would be useful not only as a new proton-sensitive fluorescence system but also as a new medium for designing efficient energy transfer systems.

Journal Article↗
PubMed2002

X-ray absorption spectral studies on the anion-selectivity of a ruthenium(II) polypyridine complex-impregnated polymer ultrathin film.

The anion-selectivity of the surface of a polymer ultrathin film incorporating an amphiphilic ruthenium(II) polypyridine complex with diperchlorate was examined using X-ray absorption spectroscopy with the total electron-yield method. The adsorbed species on the film surface were found to depend on the chemical composition in water where the film was prepared. By combining the X-ray absorption spectra with a molecular-orbital calculation, the molar ratio (MClO4/MRu) between the ClO4- ions and the Ru head group on the film surface could be semi-quantitatively analyzed; it was 0.88 for a film prepared on fresh water, and 1.4 for one prepared on old water.

Journal Article↗