Biomedical subjects

Susan Q Li

Publications and source records attributed to Susan Q Li.

3 recordsLinked to original sources

PubMed2006

Comparison of cytochrome P450 inhibition assays for drug discovery using human liver microsomes with LC-MS, rhCYP450 isozymes with fluorescence, and double cocktail with LC-MS.

The disparity of IC(50)s from CYP450 inhibition assays used to assess drug-drug interaction potential was investigated, in order to have evidence for selecting a reliable in vitro CYP450 inhibition assay to support drug discovery. Three assays were studied: individual rhCYP isozymes and corresponding coumarin derivative-probe substrates with fluorescent detection, human liver microsomes (HLM) and cocktail drug-probe substrates with LC-MS detection, and double cocktail rhCYP isozymes mix and drug-probe mix with LC-MS detection. Data comparisons showed that the rhCYP-fluorescent assay and the cocktail assay with HLM-LC-MS had weak correlation. Detection method and probe substrates were shown to not be the major cause of the disparity in IC(50)s. However, the enzyme source and composition (HLM versus, rhCYP) caused disparity in IC(50)s. Specifically, the high concentrations of CYP isozymes often used with HLM-based assays produced high probe substrate conversion and test compound metabolism, which should both contribute to artificially higher IC(50)s. Non-specific binding of substrate to higher concentration proteins and lipids in the HLM-based assays should also contribute to higher IC(50)s. The modified double cocktail assay was found to overcome limitations of the other two assays. It uses an rhCYP isozymes mix, drug-probe substrate mix, low protein concentration, and LC-MS detection. The double cocktail assay is sensitive, selective, and high throughout for use in drug discovery to provide an early alert to potential toxicity with regard to drug-drug interaction, prioritize chemical series, and guide structural modification to circumvent CYP450 inhibition.

Aryl Hydrocarbon Hydroxylases↗

PubMed2006

High throughput microsomal stability assay for insoluble compounds.

High throughput metabolic stability assays are widely implemented in drug discovery to guide structural modification, predict in vivo performance, develop structure-metabolic stability relationships, and triage compounds for in vivo animal studies. However, these methods are often developed and validated using commercial drugs. Many drug discovery compounds differ from commercial drugs, with many having high lipophilicity, high molecular weight and low solubility. The impact of very low solubility on metabolic stability assay results was explored. Two metabolic stability assays, the 'aqueous dilution method' and the 'cosolvent method, were compared. For commercial drugs and most discovery compounds having reasonable drug-like properties, the two methods gave comparable results. For highly lipophilic, insoluble drug discovery compounds, the 'aqueous dilution method' gave artificially higher stability results. The cosolvent method performs compound dilutions in solutions with higher organic solvent content and adds solutions directly to microsomes to assist with solubilization, minimize precipitation and reduce non-specific binding to plastics. This method is more applicable in drug discovery where compounds of a wide range of solubility are studied.

Acetonitriles↗

PubMed2004

Experimental design on single-time-point high-throughput microsomal stability assay.

An experimental design for a single-time-point microsomal stability assay was evaluated as compared with multiple-time-point studies. Results obtained from single-time-point experiments are in excellent agreement with those from multiple time points. First-order reaction kinetics revealed rapid changes of predicted half-life from percent remaining of the parent compound at the inflection points, suggesting a maximum predictive limit for half-life. Selection of the incubation time in single-time-point assays is important to obtain balanced information for stable and unstable compounds. A short incubation time (e.g., 5 min) is most useful for differentiating between unstable compounds, which is beneficial to direct the synthetic efforts in projects with poor metabolic stability. A long incubation time (e.g., 30 min) is more applicable to a compound series with high metabolic stability. For screening purposes, a moderate incubation time (e.g., 15 min) is recommended to achieve good resolution and a sufficiently high maximum predictive limit for half-life. This study suggests that a single-time-point assay is sufficient for ranking compounds in early drug discovery. It increases throughput and reduces turnaround time and cost.

Animals↗