Biomedical subjects

T J Kippenberg

Publications and source records attributed to T J Kippenberg.

7 recordsLinked to original sources

PubMed2006

Observation of strong coupling between one atom and a monolithic microresonator.

Over the past decade, strong interactions of light and matter at the single-photon level have enabled a wide set of scientific advances in quantum optics and quantum information science. This work has been performed principally within the setting of cavity quantum electrodynamics with diverse physical systems, including single atoms in Fabry-Perot resonators, quantum dots coupled to micropillars and photonic bandgap cavities and Cooper pairs interacting with superconducting resonators. Experiments with single, localized atoms have been at the forefront of these advances with the use of optical resonators in high-finesse Fabry-Perot configurations. As a result of the extreme technical challenges involved in further improving the multilayer dielectric mirror coatings of these resonators and in scaling to large numbers of devices, there has been increased interest in the development of alternative microcavity systems. Here we show strong coupling between individual caesium atoms and the fields of a high-quality toroidal microresonator. From observations of transit events for single atoms falling through the resonator's evanescent field, we determine the coherent coupling rate for interactions near the surface of the resonator. We develop a theoretical model to quantify our observations, demonstrating that strong coupling is achieved, with the rate of coherent coupling exceeding the dissipative rates of the atom and the cavity. Our work opens the way for investigations of optical processes with single atoms and photons in lithographically fabricated microresonators. Applications include the implementation of quantum networks, scalable quantum logic with photons, and quantum information processing on atom chips.

Journal Article↗

PubMed2005

Analysis of radiation-pressure induced mechanical oscillation of an optical microcavity.

The theoretical work of Braginsky predicted that radiation pressure can couple the mechanical, mirror eigenmodes of a Fabry-Pérot resonator to its optical modes, leading to a parametric oscillation instability. This regime is characterized by regenerative mechanical oscillation of the mechanical mirror eigenmodes. We have recently observed the excitation of mechanical modes in an ultrahigh Q optical microcavity. Here, we present a detailed experimental analysis of this effect and demonstrate that radiation pressure is the excitation mechanism of the observed mechanical oscillations.

Journal Article↗

PubMed2004

Kerr-nonlinearity optical parametric oscillation in an ultrahigh-Q toroid microcavity.

Kerr-nonlinearity induced optical parametric oscillation in a microcavity is reported for the first time. Geometrical control of toroid microcavities enables a transition from stimulated Raman to optical parametric-oscillation regimes. Optical parametric oscillation is observed at record low threshold levels (174 micro-Watts of launched power) more than 2 orders of magnitude lower than for optical-fiber-based optical parametric oscillation. In addition to their microscopic size (typically tens of microns), these oscillators are wafer based, exhibit high conversion efficiency (36%), and are operating in a highly ideal "two photon" emission regime, with near-unity (0.97+/-0.03) idler-to-signal ratio.

Journal Article↗

PubMed2004

Ultralow-threshold microcavity Raman laser on a microelectronic chip.

Using ultrahigh-Q toroid microcavities on a chip, we demonstrate a monolithic microcavity Raman laser. Cavity photon lifetimes in excess of 100 ns combined with mode volumes typically of less than 1000 (microm)3 significantly reduce the threshold for stimulated Raman scattering. In conjunction with the high ideality of a tapered optical fiber coupling junction, stimulated Raman lasing is observed at an ultralow threshold (as low as 74 microW of fiber-launched power at 1550 nm) with high efficiency (up to 45% at the critical coupling point) in good agreement with theoretical modeling. Equally important, the wafer-scale nature of these devices should permit integration with other photonic, mechanical, or electrical functionality on a chip.

Journal Article↗

PubMed2003

Ideality in a fiber-taper-coupled microresonator system for application to cavity quantum electrodynamics.

The ability to achieve near lossless coupling between a waveguide and a resonator is fundamental to many quantum-optical studies as well as to practical applications of such structures. The nature of loss at the junction is described by a figure of merit called ideality. It is shown here that under appropriate conditions ideality in excess of 99.97% is possible using fiber-taper coupling to high-Q silica microspheres. To verify this level of coupling, a technique is introduced that can both measure ideality over a range of coupling strengths and provide a practical diagnostic of parasitic coupling within the fiber-taper-waveguide junction.

Journal Article↗

PubMed2003

Ultra-high-Q toroid microcavity on a chip.

The circulation of light within dielectric volumes enables storage of optical power near specific resonant frequencies and is important in a wide range of fields including cavity quantum electrodynamics, photonics, biosensing and nonlinear optics. Optical trajectories occur near the interface of the volume with its surroundings, making their performance strongly dependent upon interface quality. With a nearly atomic-scale surface finish, surface-tension-induced microcavities such as liquid droplets or spheres are superior to all other dielectric microresonant structures when comparing photon lifetime or, equivalently, cavity Q factor. Despite these advantageous properties, the physical characteristics of such systems are not easily controlled during fabrication. It is known that wafer-based processing of resonators can achieve parallel processing and control, as well as integration with other functions. However, such resonators-on-a-chip suffer from Q factors that are many orders of magnitude lower than for surface-tension-induced microcavities, making them unsuitable for ultra-high-Q experiments. Here we demonstrate a process for producing silica toroid-shaped microresonators-on-a-chip with Q factors in excess of 100 million using a combination of lithography, dry etching and a selective reflow process. Such a high Q value was previously attainable only by droplets or microspheres and represents an improvement of nearly four orders of magnitude over previous chip-based resonators.

Journal Article↗

PubMed2002

Ultralow-threshold Raman laser using a spherical dielectric microcavity.

The ability to confine and store optical energy in small volumes has implications in fields ranging from cavity quantum electrodynamics to photonics. Of all cavity geometries, micrometre-sized dielectric spherical resonators are the best in terms of their ability to store energy for long periods of time within small volumes. In the sphere, light orbits near the surface, where long confinement times (high Q) effectively wrap a large interaction distance into a tiny volume. This characteristic makes such resonators uniquely suited for studies of nonlinear coupling of light with matter. Early work recognized these attributes through Raman excitation in microdroplets-but microdroplets have not been used in practical applications. Here we demonstrate a micrometre-scale, nonlinear Raman source that has a highly efficient pump-signal conversion (higher than 35%) and pump thresholds nearly 1,000 times lower than shown before. This represents a route to compact, ultralow-threshold sources for numerous wavelength bands that are usually difficult to access. Equally important, this system can provide a compact and simple building block for studying nonlinear optical effects and the quantum aspects of light.

Fiber Optic Technology↗