PubMed Health⌕ Search

Biomedical subjects

T Mascarenhas

Publications and source records attributed to T Mascarenhas.

4 recordsLinked to original sources
PubMed2005

A shell finite element model of the pelvic floor muscles.

The pelvic floor gives support to the organs in the abdominal cavity. Using the dataset made public in (Janda et al. J. Biomech. (2003) 36(6), pp. 749-757), we have reconstructed the geometry of one of the most important parts of the pelvic floor, the levator ani, using NURB surfaces. Once the surface is triangulated, the corresponding mesh is used in a finite element analysis with shell elements. Based on the 3D behavior of the muscle we have constructed a shell that takes into account the direction of the muscle fibers and the incompressibility of the tissue. The constitutive model for the isotropic strain energy and the passive strain energy stored in the fibers is adapted from Humphrey's model for cardiac muscles. To this the active behavior of the skeletal muscle is added. We present preliminary results of a simulation of the levator ani muscle under pressure and with active contraction. This research aims at helping simulate the damages to the pelvic floor that can occur after childbirth.

Computer Simulation↗
PubMed2002

Key parameters in sludge dewatering: testing for the shear sensitivity and EPS content.

The fraction of extractable extracellular polymeric substances (EPS) and the shear sensitivity (k(ss)) are key parameters with respect to sludge dewatering, affecting the dry matter content of dewatered sludge and the dewatering rate and conditioner demand, respectively. Methods are described for determination of the two key parameters by use of the same laboratory test reactor. The implications of such characterisation with respect to dewatering are discussed based on examples of application to sludge processing and novel process development for sludge minimisation.

Polymers↗
PubMedDate not supplied

Effects of chlorination on the adhesion strength and deflocculation of activated sludge flocs.

A side effect of the application of chlorine for controlling filamentous bulking is deflocculation of floc-forming bacteria, which may cause unacceptable effluent deterioration depending on dosing. It was assumed that chlorine may adversely affect the adhesion ability of floc bacteria, promoting their erosion in shear flow. The effect of chlorination on the strength of activated sludge flocs was investigated. The adhesion-erosion (AE) model developed by Mikkelsen and Keiding was used to interpret results from deflocculation tests with varying shear and solids concentration. The AE model yields the adhesion enthalpy (deltaHG/R) of cells in sludge flocs and parameters from the model were used to quantify the sludge in terms of floc strength. Two activated sludges with different initial characteristics were studied. The resulting model parameters showed that the AE model was suitable for quantifying the bond energy of particles to the activated sludge exposed to chlorine. For one activated sludge, adhesion of cells was largely unaffected by the applied chlorine doses. A second sludge showed reduced adhesion strength with chlorine, leading to increasing deflocculation. The simple batch test and AE model proved valuable for assessing the effect of chlorination on the flocs in activated sludge. By use of these procedures, it is possible to determine acceptable chlorine dosing to avoid excessive deflocculation and effluent deterioration.

Bacterial Adhesion↗