PubMed Health⌕ Search

Biomedical subjects

T Nagataki

Publications and source records attributed to T Nagataki.

3 recordsLinked to original sources
PubMed1991

Patterns of initial tooth displacements associated with various root lengths and alveolar bone heights.

The present study was designed to investigate the nature of initial tooth displacements associated with varying root lengths and alveolar bone heights. A three-dimensional model of the upper central incisor was developed for the finite element analysis. Tooth displacements were determined at various levels of the tooth and the apicogingival levels of the center of resistance and centers of rotation were calculated. The results showed that moment-to-force values at the bracket level for translation of a tooth decreased with shorter root length and increased with lower alveolar bone height. In addition, apicogingival levels of the center of resistance shifted more gingivally to the cervix, or the alveolar crest with a shorter root. Alveolar bone loss also shifted the center of resistance toward the alveolar crest, whereas its position was more apical relative to the alveolar bone heights exhibited very slight changes in both cases. The centers of rotation from a single force varied substantially with a short root and alveolar bone loss. However, the relative distances of the centers of rotation from the alveolar crest in comparison with the alveolar bone heights were constant at 0.4 mm, with variations in the root length and alveolar bone height. Because this study showed that root length and alveolar bone height affect the patterns of initial tooth displacements both in the center of resistance and the centers of rotation and also in the amount of displacement, forces applied during orthodontic treatment should take into consideration the anatomic variations in the root length and alveolar bone height so as to produce optimal and desired tooth movement.

Alveolar Process↗
PubMed1990

Association between mechanical stress and bone remodeling.

Stress patterns and levels were analyzed by use of the three-dimensional finite element method. Three-dimensional models were constructed for the human upper central incisor (1205 nodes and 920 elements) and the sheep metacarpus (240 nodes and 128 elements). Orthodontic and orthopedic forces were applied to the tooth and the bone, simulating orthodontic tooth movement and experimental loading test for the bone. Three principal stresses were determined in the alveolar bone and the sheep long bone. The following results were obtained. 1. Stress distributions in the lateral alveolar bone were similar to those with bone deformation from cantilever bending mode. On the medial surface of the alveolar bone, a bending stress was observed, however, remaining stresses exhibited changes corresponding to those in the PDL produced by tipping displacement of the tooth. 2. In the sheep long bone, tensile and compressive stresses were induced on the dorsal and volar sides, respectively. The magnitude of stresses was greatest at the mid-diaphyseal region. Compressive and tensile stresses were related with bone resorption and apposition. The magnitude of principal stresses was almost proportional to dimensional changes of the bone at the mid-diaphyseal region. Bone remodeling in the long bone is related with mechanical stress, principal stress in particular, indicating that remodeling of the alveolar bone may be induced by application of orthodontic force in addition to conventional change of the bone adjacent to the PDL. Thus, it is shown that mechanical stress in living structures may be a trigger to induce biological remodeling of bones.

Alveolar Process↗