Biomedical subjects

T W Chung

Publications and source records attributed to T W Chung.

38 records · Page 3Linked to original sources

PubMedDate not supplied

Microencapsulation of gentamicin in biodegradable PLA and/or PLA/PEG copolymer.

Biodegradable carriers containing gentamicin for local treatment of bone infection were developed. This paper describes the preparation and in vitro evaluation of these biodegradable implants. Poly-L-lactic acid (PLA) and poly-L-lactic acid:polyethylene glycol (PLA/PEG) disk implants containing gentamicin sulphate were obtained by compression of microspheres prepared by a double emulsion process. The mean particle size distribution of the microspheres, based on volume, ranged from 95-270 microm. The gentamicin sulphate loading of the microspheres, after a methylene chloride-water extraction procedure, exceeded 90% of the theoretical value. In vitro dissolution studies on the microspheres and implants with drug loadings 10-40% w/w indicated that the rate of drug release from both PLA and PLA/PEG implants increased, with an increase in drug loading. The release of gentamicin from microspheres was dependent on the properties of PLA and/or PLA/PEG. The PLA/PEG copolymer was more hydrophilic than the PLA homopolymer, and with a smaller pH change in the microenvironment with polymer being degraded. In comparison, the PLA/PEG implant released antibiotic faster and had a larger inhibitory zone based on the Bauer-Kirby experiments used to test the inhibitory activity of antimicrobial devices. Experimental results showed that the biodegradable PLA/PEG gentamicin delivery system had a potential for prophylaxis of post-operative infection.

Anti-Bacterial Agents↗

PubMedDate not supplied

Effects of the characteristics of chitosan on controlling drug release of chitosan coated PLLA microspheres.

Chitosan has been shown to be a biomaterial with good biocompatibility, and is highly biodegradable. This study investigated the effect of post-coating PLLA microspheres with different chitosans on the initial burst and controlling the drug release of the microspheres. Without chitosan, 19.2% of encapsulated lidocaine would release from PLLA microspheres within the first hour (R1), and the time of 50% release (T50) was 25 h. After the microspheres were coated with chitosan of viscosity (eta) 384 +/- 10cp, R1 and T50 could be reduced and prolonged to 14.6% and 90 h, respectively, for all tested molecular weights (Mw) of chitosan. In the case of the same Mw of chitosan being applied, the efficacy of reducing the initial burst of drug release was higher for a lower degree of deacetylation (D.D.). With chitosan in acetic acid solution, coating the microspheres with high Mw and high viscosity could most effectively reduce the initial burst and control drug release of PLLA microspheres. For example, the microspheres coated with chitosan solution of Mw 800 kDa and eta of 1479 cp, R1 and T50 could be reduced and prolonged to 7.4% and 245 h, respectively. The study indicated that manipulating the viscosity of the chitosan solution was the most important factor in contributing to controlling the drug release of chitosan post-coated PLLA microspheres.

Chitin↗