PubMed Health⌕ Search

Biomedical subjects

Taeghwan Hyeon

Publications and source records attributed to Taeghwan Hyeon.

At least 19 recordsLinked to original sources
PubMed2007

Crosslinked enzyme aggregates in hierarchically-ordered mesoporous silica: a simple and effective method for enzyme stabilization.

alpha-chymotrypsin (CT) and lipase (LP) were immobilized in hierarchically-ordered mesocellular mesoporous silica (HMMS) in a simple but effective way for the enzyme stabilization, which was achieved by the enzyme adsorption followed by glutaraldehyde (GA) crosslinking. This resulted in the formation of nanometer scale crosslinked enzyme aggregates (CLEAs) entrapped in the mesocellular pores of HMMS (37 nm), which did not leach out of HMMS through narrow mesoporous channels (13 nm). CLEA of alpha-chymotrypsin (CLEA-CT) in HMMS showed a high enzyme loading capacity and significantly increased enzyme stability. No activity decrease of CLEA-CT was observed for 2 weeks under even rigorously shaking condition, while adsorbed CT in HMMS and free CT showed a rapid inactivation due to the enzyme leaching and presumably autolysis, respectively. With the CLEA-CT in HMMS, however, there was no tryptic digestion observed suggesting that the CLEA-CT is not susceptible to autolysis. Moreover, CLEA of lipase (CLEA-LP) in HMMS retained 30% specific activity of free lipase with greatly enhanced stability. This work demonstrates that HMMS can be efficiently employed as host materials for enzyme immobilization leading to highly enhanced stability of the immobilized enzymes with high enzyme loading and activity.

Chymotrypsin↗
PubMed2006

Simultaneous phase- and size-controlled synthesis of TiO(2) nanorods via non-hydrolytic sol-gel reaction of syringe pump delivered precursors.

The simultaneous phase- and size-controlled synthesis of TiO(2) nanorods was achieved via the non-hydrolytic sol-gel reaction of continuously delivered two titanium precursors using two separate syringe pumps. As the injection rate was decreased, the length of the TiO(2) nanorods was increased and their crystalline phase was simultaneously transformed from anatase to rutile. When the reaction was performed by injecting titanium precursors contained in two separate syringes into a hot oleylamine surfactant solution with an injection rate of 30 mL/h, anatase TiO(2) nanorods with dimensions of 6 nm (thickness) x 50 nm (length) were produced. When the injection rate was decreased to 2.5 mL/h, star-shaped rutile TiO(2) nanorods with dimensions of 25 nm x 200 nm and a small fraction of rod-shaped anatase TiO(2) nanorods with dimensions of 9 nm x 100 nm were synthesized. Pure star-shaped rutile TiO(2) nanorods with dimensions of 25 nm x 450 nm were synthesized when the injection rate was further decreased to 1.25 mL/h. The simultaneous phase transformation and length elongation of the TiO(2) nanorods were achieved. Under optimized reaction conditions, as much as 3.5 g of TiO(2) nanorods were produced. The TiO(2) nanorods were used to produce dye-sensitized solar cells, and the photoconversion efficiency of the mixture composed of star-shaped rutile TiO(2) nanorods and a small fraction of anatase nanorods were comparable to that of Degussa P-25.

Crystallization↗
PubMed2006

Ni/NiO core/shell nanoparticles for selective binding and magnetic separation of histidine-tagged proteins.

Ni/NiO core/shell nanoparticles having high affinity with polyhistidine were synthesized by decomposition of a Ni surfactant complex followed by air oxidation. Ni/NiO nanoparticles showed selective and efficient binding to histidine-tagged proteins and easy separation by using a magnet. These provided a more convenient way to efficient purification of histidine-tagged proteins compared with the conventional Ni-NTA complex-bound resins and microbeads.

Histidine↗
PubMed2006

Synthesis, characterization, and self-assembly of pencil-shaped CoO nanorods.

We synthesized uniformly sized, pencil-shaped CoO nanorods by the thermal decomposition of a cobalt-oleate complex, which was prepared from the reaction of cobalt chloride and sodium oleate. The diameters and lengths of the CoO nanorods were easily controlled by varying the experimental conditions, such as the heating rate and the amount of Co-oleate complex. The X-ray diffraction pattern revealed that the CoO nanorods have an extraordinary wurtzite ZnO crystal structure. These uniformly sized nanorods self-assembled to form both horizontal parallel arrangements and perpendicular hexagonal honeycomb superlattice structures. Reduction of the nanorods by heating under a hydrogen atmosphere generated either hcp Co or Co(2)C nanorods. Characterization of the CoO nanorods using X-ray absorption spectroscopy, X-ray magnetic circular dichroism spectroscopy, and magnetic measurements showed that they contain a small fraction of ferromagnetic Co impurities.

Journal Article↗
PubMed2006

Single unit cell thick samaria nanowires and nanoplates.

We report on the synthesis of samaria nanowires and nanoplates with a thickness of 1.1 nm. The cross-section of the nanowires is a rectangular shape with dimensions of 1.1 nm x 2.2 nm, which corresponded to the size of two unit cells of samaria. Under optimized conditions, we were able to synthesize as much as 10 g of the nanowires.

Journal Article↗
PubMed2006

Effect of the casting solvent on the morphology of poly(styrene-b-isoprene) diblock copolymer/magnetic nanoparticle mixtures.

We investigate the effect of the casting solvent on the phase behavior of a cylinder-forming poly(styrene-b-isoprene) (PS-b-PI) diblock copolymer mixed with marginally selective gamma-Fe2O3 nanoparticles. Notably, for the mixtures of PS-b-PI/gamma-Fe2O3 nanoparticles cast with toluene, which is a neutral solvent for both PS and PI blocks, the latticelike aggregates of gamma-Fe2O3 nanoparticles, originating from magnetic dipole interactions, induce an intriguing transition from hexagonal cylinders to body-centered cubic spheres via undulated cylinders whereas the neat block copolymer does not show such an order-order transition. In contrast, when PI-selective hexane is used, the nanoparticles are selectively incorporated into the PI domains, and the microphase-separated hexagonal cylinder morphology gradually loses its long-range order upon increasing the nanoparticle concentration. The structural information obtained from small-angle X-ray scattering is also in good agreement with transmission electron microscopy images and differential scanning calorimetry results.

Journal Article↗
PubMed2005

Large-scale synthesis of TiO2 nanorods via nonhydrolytic sol-gel ester elimination reaction and their application to photocatalytic inactivation of E. coli.

A simple method of synthesizing a large quantity of TiO(2) nanorods was developed. A nonhydrolytic sol-gel reaction between titanium(IV) isopropoxide and oleic acid at 270 degrees C generated 3.4 nm (diameter) x 38 nm (length) sized TiO(2) nanocrystals. The transmission electron microscopic image showed that the particles have a uniform diameter distribution. X-ray diffraction and selected-area electron diffraction patterns combined with high-resolution transmission electron microscopic image showed that the TiO(2) nanorods are highly crystalline anatase crystal structure grown along the [001] direction. The diameters of the TiO(2) nanorods were controlled by adding 1-hexadecylamine to the reaction mixture as a cosurfactant. TiO(2) nanorods with average sizes of 2.7 nm x 28 nm, 2.2 nm x 32 nm, and 2.0 nm x 39 nm were obtained using 1, 5, and 10 mmol of 1-hexadecylamine, respectively. The optical absorption spectrum of the TiO(2) nanorods exhibited that the band gap of the nanorods was 3.33 eV at room temperature, which is 130 meV larger than that of bulk anatase (3.2 eV), demonstrating the quantum confinement effect. Oleic acid coordinated on the nanorod surface was removed by the reduction of the carboxyl group of oleic acid, and the Brunauer-Emmett-Teller surface area of the resulting naked TiO(2) nanorods was 198 m(2)/g. The naked TiO(2) nanorods exhibited higher photocatalytic activity than the P-25 photocatalyst for the photocatalytic inactivation of E. coli.

Catalysis↗
PubMed2005

Large-scale synthesis of hexagonal pyramid-shaped ZnO nanocrystals from thermolysis of Zn-oleate complex.

We report the large-scale synthesis of uniform-sized hexagonal pyramid-shaped ZnO nanocrystals by the thermolysis of Zn-oleate complex, which was prepared from the reaction of inexpensive and environmentally friendly reagents such as zinc chloride and sodium oleate. Under optimized reaction conditions, we were able to synthesize as much as 2.83 g using 300 mL of oleylamine and 90 mL (284 mmol) of oleic acid (OA) as both solvents and stabilizing surfactants. The UV-vis spectrum showed the absorption onset of 380 nm, and the photoluminescence spectrum showed a near band-edge emission at 387 nm and a broad blue-green emission band above 468 nm.

Letter↗
PubMed2005

Generalized synthesis of metal phosphide nanorods via thermal decomposition of continuously delivered metal-phosphine complexes using a syringe pump.

We synthesized uniform-sized nanorods of transition metal phosphides from the thermal decomposition of continuously delivered metal-phosphine complexes using a syringe pump. MnP nanorods with dimensions of 8 nm x 16 nm and 6 nm x 22 nm sized were synthesized by the thermal decomposition of Mn-TOP complex, which was prepared from the reaction of Mn(2)(CO)(10) and tri-n-octylphosphine (TOP), using a syringe pump with constant injection rates of 10 and 20 mL/h, respectively. When Co-TOP complex, which was prepared from the reaction of cobalt acetylacetonate and TOP, was reacted in a mixture solvent composed of octyl ether and hexadecylamine at 300 degrees C using a syringe pump, uniform 2.5 nm x 20 nm sized Co(2)P nanorods were generated. When cobaltocene was employed as a precursor, uniform Co(2)P nanorods with 5 nm x 15 nm were obtained. When Fe-TOP complex was added to trioctylphosphine oxide (TOPO) at 360 degrees C using a syringe pump and then allowed to age at 360 degrees C for 30 min, uniform-sized FeP nanorods with an average dimension of 12 nm x 500 nm were produced. Nickel phosphide (Ni(2)P) nanorods with 4 nm x 8 nm were synthesized successfully by thermally decomposing the Ni-TOP complex, which was synthesized by reacting acetylacetonate [Ni(acac)(2)] and TOP. We measured the magnetic properties of these nanorods, and some of the nanorods exhibited different magnetic characteristics compared to the bulk counterparts.

Journal Article↗