Terry Blevins | PubMed Health

PubMed2004

Function block applications in control systems based on IEC 61804.

A variety of fieldbus technologies and digital fieldbus devices have been introduced within the process industries over the last ten years. There has been a gradual acceptance of the fact that a variety of communication technologies are needed to fully address the application requirements of a manufacturing facility. However, engineers responsible for the specification, engineering, and implementation of control systems require that a common interface and functionality be provided in the control system. This capability should be independent of the underlying fieldbus technology or manufacturer of the fieldbus device. The draft IEC 61804 standard defines how a control system can be structured to provide this flexibility in the utilization of fieldbus technology. In this paper, we discuss how a consistent function block capability may be provided for all fieldbus technology utilized in a control system. Examples will be given of how this standard has been applied in modern control systems to give a consistent interface to Foundation Fieldbus and PROFIBUS. Some detail will be presented on the standard means that is defined for manufacturers to describe function block capability of a field device. An analysis is given of the impact and benefit that the IEC 61804 standard will have on the process industry and on manufacturers of control systems.

Journal Article↗

PubMed2003

Practical approach to tuning MPC.

This paper presents the results of a heuristic approach for developing model predictive control (MPC) tuning rules. The tuning has been applied and tested in easy-to-use MPC. Process modeling in this MPC uses normalized input/ output range. As a result there is no need for tuning outputs, a procedure known as adjusting equal concern error. Penalties on moves are set as a function of process dead time as the primary factor, with some correction from process gain. The default calculation delivers robust control, which tolerates up to triple increase in process static gain. If control is too aggressive, further on-line adjustment can be done by set point reference trajectory. Test results show that this tuning is robust for process gain change, however, it is much less efficient in compensating for process dead-time changes. It was found that dead-time mismatch is much better compensated with the model correction filter. Combining the three handles, i.e., penalties on moves, reference trajectory, and model filter, easy and intuitively understandable MPC tuning was achieved. The findings are illustrated by numerous MPC simulated tests.

Computer Simulation↗