Biomedical subjects

Th Hankemeier

Publications and source records attributed to Th Hankemeier.

5 recordsLinked to original sources

PubMed2005

Comprehensive two-dimensional liquid chromatography with on-line Fourier-transform-infrared-spectroscopy detection for the characterization of copolymers.

The on-line coupling of comprehensive two-dimensional liquid chromatography (liquid chromatography x size-exclusion chromatography, LC x SEC) and infrared (IR) spectroscopy has been realized by means of an IR flow cell. The system has been assessed by the functional-group analysis of a series of styrene-methylacrylate (SMA) copolymers with varying styrene content. Ultraviolet (UV) detection was used as a detection technique to verify the detection with IR. The LC x SEC-IR functional-group contour plots (comprehensive chromatograms) obtained for styrene were in agreement with the contour plots constructed from the UV signal. In addition, contour plots can be obtained from non-UV-active groups. One such plot, for the carbonyl-stretching vibration of methylacrylate (MA), is shown. Selective detection of MA proved possible using flow cell IR detection. The combination of the contour plots for styrene and MA allowed a full characterization of the copolymer and it was revealed that the present series of SMA copolymers exhibited homogeneous chemical-composition distributions (CCDs). In addition, commercially available fast-SEC columns have been assessed in this study with respect to their potential to serve as second-dimension separation columns.

Acrylates↗

PubMed2005

Comprehensive two-dimensional liquid chromatography and hyphenated liquid chromatography to study the degradation of poly(bisphenol A)carbonate.

Size exclusion chromatography (SEC), gradient polymer elution chromatography (GPEC) and liquid chromatography at critical conditions (LC-CC) have been developed and applied to observe chemical changes in poly(bisphenol A)carbonate (PC) due to hydrolytic degradation. Especially LC-CC appeared to be very successful to observe differences in functionality of PC as result of hydrolytic degradation. Observed differences due to degradation could be identified by (semi) on-line coupling to matrix assisted laser desorption-ionization time-of-flight mass spectrometry (MALDI-TOF-MS). The differences in functionality could be attributed to the formation of different end-groups, i.e. OH end-groups. In addition, comprehensive two-dimensional liquid chromatography (2D-LC) has been applied successfully to study the hydrolytic degradation of PC. LC-CC x SEC showed that the formation of PC with different end-groups occurred over the whole molecular mass range. This information could not be obtained with the separate liquid chromatographic techniques, thereby illustrating the added value of 2D-LC.

Benzhydryl Compounds↗

PubMed2005

Identification and quantification of (polymeric) hindered-amine light stabilizers in polymers using pyrolysis-gas chromatography-mass spectrometry and liquid chromatography-ultraviolet absorbance detection-evaporative light scattering detection.

Direct analysis of polymers containing polymeric hindered amine light stabilizers (HALS) by using pyrolysis coupled to GC-MS is applied successfully for fast and straightforward identification of these HALS additives. Each of the HALS additives shows different pyrolysis gas chromatograms containing characteristic pyrolysis products. As a result, HALS additives with very similar chemical structures, e.g. Chimassorb 944 and Chimassorb 2020, can be distinguished. A HPLC method with both ultraviolet (UV) and evaporative light scattering detection (ELSD) is developed to quantify the various HALS additives in extracts of polymers. The critical factor of the HPLC method is the use of a basic amine, like n-hexylamine, as a solvent additive to facilitate the elution of HALS additives. The various HALS additives can be distinguished according to retention time and peak shape and by using different detection methods. The suitability of the developed methods is demonstrated by the analytical performance of the HPLC method and the identification and determination of the actual content of HALS additives in polyolefines using pyrolysis GC-MS and HPLC. The HPLC method can also be used for the determination of the specific migration of HALS additives from food contact materials.

Amines↗

PubMed2003

Comparison of on-line flow-cell and off-line solvent-elimination interfaces for size-exclusion chromatography and Fourier-transform infrared spectroscopy in polymer analysis.

Two commercial liquid chromatography-Fourier-transform infrared spectroscopy interfaces (LC-FTIR), viz. a flow cell and a solvent-elimination interface have been assessed for use in size-exclusion chromatography (SEC) with respect to their chromatographic integrity (i.e. peak asymmetry, chromatographic resolution), quantitative and qualitative aspects. A polycarbonate/aliphatic polyester (PC/APE) blend and a polycarbonate-co-polydimethylsiloxane (PC-co-PDMS) copolymer were selected for the assessment. Both samples were successfully and selectively analyzed. The relatively large volume of the flow cell and the inherent deposition characteristics of the solvent-elimination interface led to a comparable decrease in the chromatographic resolution. The separation of oligomers was diminished in comparison with SEC-ultra-violet (UV). However, the peak asymmetry was not significantly affected by either interface. For both interfaces, a linear relationship was obtained for the FTIR response versus the injected concentration. The sensitivity was found to be higher for the solvent-elimination interface. For the current model compounds, the flow-cell interface detection limits are worse. However, the repeatability of flow-cell SEC-FTIR, evaluated by means of four SEC-FTIR analyses of polycarbonate, was considerably better than for solvent-elimination SEC-FTIR. This is probably due to the well-defined optical path length of the sample in the flow cell. By spectral subtraction, it was very well possible to obtain qualitative (functional group) information for compound identification also with flow-cell SEC-FTIR.

Chromatography, Gel↗

PubMed2002

Fourier transform infrared spectroscopy with a sample deposition interface as a quantitative detector in size-exclusion chromatography.

The use of a state-of-the-art commercial solvent-elimination interface for liquid chromatography-infrared spectroscopy is discussed from the perspective of quantitative analysis. The effect of eluent flow-rate is investigated with respect to the homogeneity of the deposit and the trace width along the deposition trace. Low flow-rates (50 microl/min or less) turn out to be favorable for obtaining a good trace and a high sensitivity. The trace width decreased from 2.20 to 1.13 mm when the flow-rate was reduced from 500 to 25 microl/min. Preservation of chromatographic detail during deposition was evaluated at different substrate moving speeds. The additional (extra-column) band broadening that is inherent to nebulizer-deposition interfaces, causes a loss in resolution in size-exclusion chromatography (SEC)-Fourier transform infrared (FTIR) spectroscopy in comparison with SEC-UV. The repeatability of the deposition is evaluated by SEC-FTIR analyses of polystyrene standards (peak molar-masses: 1250-2,950 000 g/mol) and the RSD is found to range from 3.2 to 5.8% in response and from 0.21 to 0.47% in retention time.

Chromatography, Gel↗