PubMed Health⌕ Search

Biomedical subjects

Thomas E Mallouk

Publications and source records attributed to Thomas E Mallouk.

8 recordsLinked to original sources
PubMed2003

Individual single-walled nanotubes and hydrogels made by oxidative exfoliation of carbon nanotube ropes.

Single-walled carbon nanotubes were oxidized by a technique previously developed for the oxidation of graphite to graphite oxide (GO). This process involves treatment with concentrated H(2)SO(4) containing (NH(4))(2)S(2)O(8) and P(2)O(5), followed by H(2)SO(4) and KMnO(4). Oxidation results in complete exfoliation of nanotube ropes to yield individual oxidized tubes that are 40-500 nm long. The C:O:H atomic ratio of vacuum-dried oxidized nanotubes is approximately 2.7:1.0:1.2. XPS and IR spectra show evidence for surface O-H, C=O, and COOH groups. The oxidized nanotubes slowly form viscous hydrogels at unusually low concentration (>or=0.3 wt %), and this behavior is attributed to the formation of a hydrogen-bonded nanotube network. The oxidized tubes bind readily to amine-coated surfaces, on which they adsorb as smooth and dense monolayer films. Thin films of the oxidized nanotubes show ohmic current-voltage behavior, with resistivities in the range of 0.2-0.5 Omega-cm.

Journal Article↗
PubMed2003

Standing wave enhancement of red absorbance and photocurrent in dye-sensitized titanium dioxide photoelectrodes coupled to photonic crystals.

The light harvesting efficiency of dye-sensitized photoelectrodes was enhanced by coupling a TiO(2) photonic crystal layer to a conventional film of TiO(2) nanoparticles. In addition to acting as a dielectric mirror, the inverse opal photonic crystal caused a significant change in dye absorbance which depended on the position of the stop band. Absorbance was suppressed at wavelengths shorter than the stop band maximum and was enhanced at longer wavelengths. This effect arises from the slow group velocity of light in the vicinity of the stop band, and the consequent localization of light intensity in the voids (to the blue) or in the dye-sensitized TiO(2) (to the red) portions of the photonic crystal. By coupling a photonic crystal to a film of TiO(2) nanoparticles, the short circuit photocurrent efficiency across the visible spectrum (400-750 nm) could be increased by about 26%, relative to an ordinary dye-sensitized nanocrystalline TiO(2) photoelectrode.

Journal Article↗
PubMed2002

Nanowires as building blocks for self-assembling logic and memory circuits.

The concept of assembling electronic circuits from metal nanowires is discussed. These nanowires are synthesised electrochemically by using porous membranes as templates. High aspect ratio wires, which range from 15 to 350 nm in diameter and contain "stripes" of different metals, semiconductors, colloid/polymer multilayers, and self-assembling monolayers have been made by this technique. By using the distinct surface chemistry of different stripes, the nanowires can be selectively derivatized and positioned on patterned surfaces. This allows the current-voltage properties of single and crossed nanowire devices to be measured. Nanowire conductors, rectifiers, switches, and photoconductors have been characterized. Techniques are still being developed for assembling sublithographic scale nanowires into cross-point arrays for memory and logic applications.

Journal Article↗
PubMed2002

A high-throughput optical screening method for the optimization of colloidal water oxidation catalysts.

A high-throughput method has been developed for screening and optimization of colloidal water oxidation catalysts. The catalysts are irradiated in parallel by visible light from an overhead projector in solutions containing tris(2,2'-bipyridyl)ruthenium(II) (Ru(bpy)(3)(2+)) and persulfate. The array of reaction solutions is held in a 96-well plate, and absorbance readings are taken intermittently using a bioassay plate reader. The absorbance at 430 nm is indicative of the amount of Ru(bpy)(3)(2+) remaining in solution. The best catalysts give the most persistent absorbance, because the oxygen evolution reaction is kinetically competitive with decomposition of Ru(bpy)(3)(3+). Reagent concentrations were varied using a factorial design-of-experiment approach in order to optimize reaction conditions for a IrO(2).xH(2)O colloidal catalyst. A higher colloid concentration, a lower Ru(bpy)(3)(2+) concentration, and a higher pH buffer doubled the number of turnovers relative to the original conditions. Metal oxide colloids consisting of IrO(2).xH(2)O doped with varying amounts of Pt, Ru, and Os were made using a parallel microwave synthesis technique and were tested both by the parallel screening method and by direct measurement of oxygen evolution. The correlation between the two methods was good, with Ir-Pt-Os oxide compositions showing the highest activity. The effect of adding small amounts of Pt and Os to IrO(2).xH(2)O appears to be predominantly to reduce the particle size of the colloids.

Journal Article↗
PubMed2002

Template synthesis of metal nanowires containing monolayer molecular junctions.

Metal nanowires containing in-wire monolayer junctions of 16-mercaptohexanoic acid were made by replication of the pores of 70 nm diameter polycarbonate track etch membranes. Au was electrochemically deposited halfway through the 6 microm long pores and a self-assembled monolayer (SAM) of 16-mercaptohexadecanoic acid was adsorbed on top. A thin layer of Au was then electrolessly grown to form a metal cap separated from the bottom part of the wire by the SAM. Electron micrographs showed that the bottom and top metal segments were separated by an approximately 2 nm thick organic monolayer. Current-voltage measurements of individual nanowires confirmed that the organic monolayer could be contacted electrically on the top and bottom by the metal nanowire segments without introducing electrical short circuits that penetrate the monolayer. The values of the electrical properties for zero-bias resistance, current density, and breakdown field strength were within the ranges expected for a well-ordered alkanethiol SAM of this thickness.

Journal Article↗
PubMed2002

Exfoliation of layered rutile and perovskite tungstates.

The layered trirutile phases HMWO6 (M = Nb, Ta) and the layered perovskite H2W2O7 (synthesized by acid leaching of Bi2W2O9) were exfoliated into nanoscale colloids by reaction with quaternary ammonium hydroxides.

Journal Article↗
PubMedDate not supplied

Split-pool method for synthesis of solid-state material combinatorial libraries.

The synthesis and analysis of inorganic material combinatorial libraries by the split-pool bead method were demonstrated at the proof-of-concept level. Millimeter-size spherical beads of porous gamma-alumina, a commonly used support material for heterogeneous catalysts, were modified with Al(13)O(4)(OH)(24)(H(2)O)(12)(7+) cations in order to promote irreversible adsorption of the anionic fluorescent dyes Cascade Blue, Lucifer Yellow, and Sulforhodamine 101. The compositions of individual beads were easily determined through three split-pool cycles using a conventional fluorescence plate reader. Small split-pool material libraries were made by adsorbing noble metal salts (H(2)PtCl(6), H(2)IrCl(6), and RhCl(3)) into the beads. Analysis of these beads by micro-X-ray fluorescence showed that quantitative adsorption of metal salts without cross-contamination of beads could be achieved at levels (0.3 wt % metal loading) relevant to heterogeneous catalysis. The method offers the potential for synthesis of rather large libraries of inorganic materials through relatively simple benchtop split-pool chemistry.

Journal Article↗