Biomedical subjects

Thomas W Hamann

Publications and source records attributed to Thomas W Hamann.

6 recordsLinked to original sources

PubMed2006

Comparison of the self-exchange and interfacial charge-transfer rate constants for methyl- versus tert-butyl-substituted Os(III) polypyridyl complexes.

Differences in the self-exchange and interfacial electron-transfer rate constants have been evaluated for a relatively unhindered Os(III/II) redox system, osmium(III/II) tris(4,4'-di-methyl-2,2'-bipyridyl), [Os(Me2bpy)3]3+/2+, relative to those of a relatively hindered system, osmium(III/II) tris(4,4'-di-tert-butyl-2,2'-bipyridyl), [Os(t-Bu2bpy)3]3+/2+. In contrast to the predicted increase in rate constant by a factor of 2-3 due to the difference in reorganization energy of the two complexes, introduction of the tert-butyl functionality decreased the self-exchange rate constant, as measured by NMR line-broadening techniques, by a factor of approximately 50 as compared to that of the analogous methyl-substituted osmium complex. Steady-state current density versus potential measurements, in conjunction with differential capacitance versus potential measurements, were used to compare the interfacial electron-transfer rate constants at n-type ZnO electrodes of [Os(t-Bu2bpy)3]3+/2+ and [Os(Me2bpy)3]3+/2+. The interfacial electron-transfer rate constant for the reduction of [Os(t-Bu2bpy)3]3+ was 100 times smaller than that for [Os(Me2bpy)3]3+. The results indicate that the tert-butyl group can act as a spacer on an outer-sphere redox couple and significantly decrease the electronic coupling of the electron-transfer reaction in both self-exchange and interfacial electron-transfer processes.

Journal Article↗

PubMed2006

Control of the stability, electron-transfer kinetics, and pH-dependent energetics of Si/H2O interfaces through methyl termination of Si(111) surfaces.

Methyl-terminated, n-type, (111)-oriented Si surfaces were prepared via a two-step chlorination-alkylation method. This surface modification passivated the Si surface toward electrochemical oxidation and thereby allowed measurements of interfacial electron-transfer processes in contact with aqueous solutions. The resulting semiconductor/liquid junctions exhibited interfacial kinetics behavior in accord with the ideal model of a semiconductor/liquid junction. In contrast to the behavior of H-terminated Si(111) surfaces, current density vs. potential measurements of CH(3)-terminated Si(111) surfaces in contact with an electron acceptor having a pH-independent redox potential (methyl viologen(2+/+)) were used to verify that the band edges of the modified Si electrode were fixed with respect to changes in solution pH. The results provide strong evidence that the energetics of chemically modified Si interfaces can be fixed with respect to pH and show that the band-edge energies of Si can be tuned independently of pH-derived variations in the electrochemical potential of the solution redox species.

Letter↗

PubMed2006

A comparison between interfacial electron-transfer rate constants at metallic and graphite electrodes.

The Fermi golden rule formalism has been used to derive the rate constant for interfacial electron transfer from a semimetallic electrode, such as highly ordered pyrolytic graphite (HOPG), to a redox couple in solution. A simple expression is presented that semiquantitatively relates the electron-transfer rate constant at a semimetallic electrode to that at a metallic electrode. The approach allows for the estimation of the value of the rate constant for interfacial charge transfer to nonadsorbing outer-sphere redox species at semimetallic electrodes. Rate constants for interfacial electron transfer for a variety of one-electron redox couples at semimetallic electrodes have been calculated relative to the rate constant of the ferrocenium/ferrocene redox couple at a gold electrode. Good agreement is found, in general, between the calculated and observed rate constants.

Journal Article↗

PubMed2005

Time-resolved EPR study of the photophysics and photochemistry of 1-(3-(methoxycarbonyl)propyl)-1-phenyl[6.6]C61.

Time-resolved (TR) EPR was used to study the photophysics and photochemistry of 1-(3-(methoxycarbonyl)propyl)-1-phenyl[6.6]C61 (M1). The CW TREPR spectra of M1 in the photoexcited triplet state, frozen in a rigid matrix and in liquid solution at room temperature, were compared with those of 3C60. The introduction of the substituent on C60 has a striking effect on the spectra of the triplets, which is attributed to the lifting of the orbital degeneracy by the reduction in symmetry. Fourier transform (FT) EPR was used in an investigation of electron-transfer reactions in liquid solutions mediated by 3M1. Of particular interest was the system of M1/chloranil (CA)/perylene (Pe). Photoexcitation of M1 is found to lead to the formation of the chloranil anion radical and the perylene cation radical. From the chemically induced dynamic electron polarization (CIDEP) patterns in the FTEPR spectra and the dependence of the reaction kinetics on reactant concentrations, it was deduced that CA- is formed by two competing pathways following photoexcitation of M1: (1) direct electron transfer from 3M1 to CA followed by electron transfer from Pe to M1+ and (2) energy transfer from 3M1 to Pe followed by oxidative quenching of 3Pe by CA. In both pathways, M1 acts as a light-energy harvester and mediator of electron-transfer reactions from Pe to CA without itself being consumed in the process, that is, as a photocatalyst. It is found that the functionalization of C60 makes its triplet state a worse electron donor and acceptor, but it has no significant effect on the triplet energy transfer reaction.

Journal Article↗

PubMed2005

Measurement of the dependence of interfacial charge-transfer rate constants on the reorganization energy of redox species at n-ZnO/H2O interfaces.

The interfacial energetic and kinetics behavior of n-ZnO/H2O contacts have been determined for a series of compounds, cobalt trisbipyridine (Co(bpy)3(3+/2+)), ruthenium pentaamine pyridine (Ru(NH3)5 py(3+/2+)), cobalt bis-1,4,7-trithiacyclononane (Co(TTCN)2(3+/2+)), and osmium bis-dimethyl bipyridine bis-imidazole (Os(Me2bpy)2(Im)2(3+/2+)), which have similar formal reduction potentials yet which have reorganization energies that span approximately 1 eV. Differential capacitance vs potential and current density vs potential measurements were used to measure the interfacial electron-transfer rate constants for this series of one-electron outer-sphere redox couples. Each interface displayed a first-order dependence on the concentration of redox acceptor species and a first-order dependence on the concentration of electrons in the conduction band at the semiconductor surface, in accord with expectations for the ideal model of a semiconductor/liquid contact. Rate constants varied from 1 x 10(-19) to 6 x 10(-17) cm4 s(-1). The interfacial electron-transfer rate constant decreased as the reorganization energy, lambda, of the acceptor species increased, and a plot of the logarithm of the electron-transfer rate constant vs (lambda + deltaG(o)')(2)/4lambda k(B)T (where deltaG(o)' is the driving force for interfacial charge transfer) was linear with a slope of approximately -1. The rate constant at optimal exoergicity was found to be approximately 5 x 10(-17) cm4 s(-1) for this system. These results show that interfacial electron-transfer rate constants at semiconductor electrodes are in good agreement with the predictions of a Marcus-type model of interfacial electron-transfer reactions.

Models, Chemical↗

PubMed2005

Measurement of the free-energy dependence of interfacial charge-transfer rate constants using ZnO/H2O semiconductor/liquid contacts.

The dependence of electron-transfer rate constants on the driving force for interfacial charge transfer has been investigated using n-type ZnO electrodes in aqueous solutions. Differential capacitance versus potential and current density versus potential measurements were used to determine the energetics and kinetics, respectively, of the interfacial electron-transfer processes. A series of nonadsorbing, one-electron, outer-sphere redox couples with formal reduction potentials that spanned approximately 900 mV allowed evaluation of both the normal and Marcus inverted regions of interfacial electron-transfer processes. All rate processes were observed to be kinetically first-order in the concentration of surface electrons and first-order in the concentration of dissolved redox acceptors. The band-edge positions of the ZnO were essentially independent of the Nernstian potential of the solution over the range 0.106-1.001 V vs SCE. The rate constant at optimal exoergicity was observed to be approximately 10(-)(16) cm(4) s(-)(1). The rate constant versus driving force dependence at n-type ZnO electrodes exhibited both normal and inverted regions, and the data were well-fit by a parabola generated using classical Marcus theory with a reorganization energy of 0.67 eV. NMR line broadening measurements of the self-exchange rate constants indicated that the redox couples had reorganization energies of 0.64-0.69 eV. The agreement between the reorganization energy of the ions in solution and the reorganization energy for the interfacial electron-transfer processes indicated that the reorganization energy was dominated by the redox species in the electrolyte, as expected from an application of Marcus theory to semiconductor electrodes.

Journal Article↗