PubMed Health⌕ Search

Biomedical subjects

Tiziana Missana

Publications and source records attributed to Tiziana Missana.

5 recordsLinked to original sources

Surface reactions kinetics between nanocrystalline magnetite and uranyl.

Magnetite is the most important end member of iron corrosion products under reducing environment, which is the condition expected in a deep geological high level radioactive waste disposal. Nanocrystalline magnetite was synthesized in the laboratory and its physicochemical properties were analyzed in detail. The kinetics of the adsorption of U(VI) and the kinetics of the actinide reduction to a lower oxidation state, in presence of the oxide, were studied by means of batch sorption techniques and X-ray photoelectron spectroscopy (XPS) analysis. The results showed that the uranium sorption and reduction processes on the magnetite surface have very fast kinetics (hours), the reduction process being triggered by sorption. XPS measurements showed that the speciation of uranium at the surface does not show significant changes with time (from 1 day to 3 months), as well as the quantity of uranium detected at the surface. The surface speciation depended on the initial pH of the contact solution. Considering that the Eh of equilibrium between magnetite and the solution, under our experimental conditions, is slightly positive (50-100 mV), the uranium reduction would also be thermodynamically possible within the liquid phase. However, the kinetics of reduction in the liquid occur at a much slower rate which, in turn, has to depend on the attainment of the magnetite/solution equilibrium. The decrease of uranium in solution, observed after the uranyl adsorption stage, and particularly at acidic pH, is most probably due to the precipitation of U(IV) formed in the solution.

Journal Article↗

Experimental and modeling study of the uranium (VI) sorption on goethite.

Acicular goethite was synthesized in the laboratory and its main physicochemical properties (composition, microstructure, surface area, and surface charge) were analyzed as a previous step to sorption experiments. The stability of the oxide, under the conditions used in sorption studies, was also investigated. The sorption of U(VI) onto goethite was studied under O(2)- and CO(2)-free atmosphere and in a wide range of experimental conditions (pH, ionic strength, radionuclide, and solid concentration), in order to assess the validity of different surface complexation models available for the interpretation of sorption data. Three different models were used to fit the experimental data. The first two models were based on the diffuse double layer concept. The first one (Model 1) considered two different monodentate complexes with the goethite surface and the second (Model 2) a single binuclear bidentate complex. A nonelectrostatic (NE) approach was used as a third model and, in that case, the same species considered in Model 1 were used. The results showed that all the models are able to describe the sorption behavior fairly well as a function of pH, electrolyte concentration, and U(VI) concentration. However, Model 2 fails in the description of the uranium sorption behavior as a function of the sorbent concentration. This demonstrates the importance of checking the validity of any surface complexation model under the widest possible range of experimental conditions.

Journal Article↗

Generation and stability of bentonite colloids at the bentonite/granite interface of a deep geological radioactive waste repository.

The possible mechanisms of colloid generation at the near field/far field interface of a radioactive repository have been investigated by means of novel column experiments simulating the granite/bentonite boundary, both in dynamic and in quasi-static water flow conditions. It has been shown that solid particles and colloids can be detached from the bulk and mobilised by the water flow. The higher the flow rate, the higher the concentration of particles found in the water, according to an erosion process. However, the gel formation and the intrinsic tactoid structure of the clay play an important role in the submicron particle generation even in the compacted clay and in a confined system. In fact, once a bentonite gel is formed, in the regions where the clay is contacted with water, clay colloids can be formed even in quasi-static flow conditions. The potential relevance of these colloids in radionuclide transport has been studied by evaluating their stability in different chemical environments. The coagulation kinetics of natural bentonite colloids was experimentally studied as a function of the ionic strength and pH, by means of time-resolved light scattering techniques. It has been shown that these colloids are very stable in low saline (approximately 1 x 10(-3) M) and alkaline (pH > or = 8) waters.

Aluminum Silicates↗

Simultaneous estimation of effective and apparent diffusion coefficients in compacted bentonite.

Effective diffusion coefficients (D(e)) are usually measured by means of "through-diffusion" experiments in which steady state is reached, and the "time-lag" methods are used to estimate the apparent diffusion coefficient (D(a)). For sorbing radionuclides (as caesium), the time needed to reach steady-state conditions is very large, and the precision in D(a) determinations is not satisfactory. In this paper, a method that allows determining simultaneously effective and apparent diffusion coefficients in compacted bentonite without reaching steady-state conditions is described. Basically, this method consists of an "in-diffusion" experiment in which the concentration profile in the bentonite sample is used to estimate D(a), and the temporal evolution of the solute concentration in the reservoir is used to estimate D(e). This method has several advantages over the typical "through-diffusion" experiments, in particular: (a) experiment duration is significantly shorter, (b) D(a) values are measured with greater precision and (c) it is not necessary to maintain a constant solute concentration in the reservoir. This new method has been used to estimate the effective and apparent diffusion coefficients for caesium in FEBEX bentonite and in order to validate it, the results have been compared with results previously obtained with standard methods. Experimental results have been satisfactorily modelled using a simple model of diffusion in porewater and the measured value of D(e)(Cs) is very similar to D(e)(HTO) in the same bentonite. There is no evidence of "surface diffusion" in FEBEX bentonite for caesium.

Bentonite↗

Study of the contaminant transport into granite microfractures using nuclear ion beam techniques.

Hydrated bentonite is a very plastic material and it is expected to enter in the rock microfractures at the granite/bentonite boundary of a deep geological high-level waste repository. This process is enhanced by the high swelling pressure of the clay. Since bentonite has a very good sorption capability for many radionuclides, the displacement of the clay might lead to a "clay-mediated" contaminant transport into the rock. The aim of this work is to study the contaminant transport into granite microfractures using nuclear ion beam techniques, and to determine to what extent the clay can favour it. To do so, bentonite previously doped with uranium, cesium and europium was put in contact with the surface of granite sheets. Granite sheets contacted with non-doped bentonite and with radionuclide solutions were also prepared as references. This allowed analysing the differences in the diffusion behaviour of the three systems: clay, radionuclides and clay plus radionuclides. A combination of Rutherford backscattering spectrometry (RBS) and other nuclear ion-beam techniques such as particle-induced X-ray emission (PIXE) and microPIXE was used to study the depth and lateral distribution of clay and contaminants inside granite. It was also tried to evaluate not only the diffusion depth and diffusion coefficients but also the different areas of the granite where the diffusants have a preferential access.

Aluminum Silicates↗