Biomedical subjects

Toshikazu Nishida

Publications and source records attributed to Toshikazu Nishida.

3 recordsLinked to original sources

PubMed2006

Structural modifications in chronic microwire electrodes for cortical neuroprosthetics: a case study.

Long-term viability of chronic invasive neural probes is a necessary condition for extracting robust control signals directly from neural tissue. Although immune/tissue response is a leading factor in the degradation of single neuron recording, we investigate a second component of signal degradation connected to the structural changes associated with microwire electrodes chronically exposed to extracelluar environments in vivo. Scanning electron microscopy is used to assess the surface modifications to the electrodes after an implantation duration of four weeks in rats. The electrode developed a smooth fracture surface, a reduction of the metal diameter, and pitting in the insulation of the electrode structure. Over the duration of implantation, recording properties of the electrode were marked by a reduction in the peak-to-peak amplitude in neuronal firing.

Action Potentials↗

PubMed2004

Wideband RELAX and wideband CLEAN for aeroacoustic imaging.

Microphone arrays can be used for acoustic source localization and characterization in wind tunnel testing. In this paper, the wideband RELAX (WB-RELAX) and the wideband CLEAN (WB-CLEAN) algorithms are presented for aeroacoustic imaging using an acoustic array. WB-RELAX is a parametric approach that can be used efficiently for point source imaging without the sidelobe problems suffered by the delay-and-sum beamforming approaches. WB-CLEAN does not have sidelobe problems either, but it behaves more like a nonparametric approach and can be used for both point source and distributed source imaging. Moreover, neither of the algorithms suffers from the severe performance degradations encountered by the adaptive beamforming methods when the number of snapshots is small and/or the sources are highly correlated or coherent with each other. A two-step optimization procedure is used to implement the WB-RELAX and WB-CLEAN algorithms efficiently. The performance of WB-RELAX and WB-CLEAN is demonstrated by applying them to measured data obtained at the NASA Langley Quiet Flow Facility using a small aperture directional array (SADA). Somewhat surprisingly, using these approaches, not only were the parameters of the dominant source accurately determined, but a highly correlated multipath of the dominant source was also discovered.

Aircraft↗

PubMed2003

A directional acoustic array using silicon micromachined piezoresistive microphones.

The need for noise source localization and characterization has driven the development of advanced sound field measurement techniques using microphone arrays. Unfortunately, the cost and complexity of these systems currently limit their widespread use. Directional acoustic arrays are commonly used in wind tunnel studies of aeroacoustic sources and may consist of hundreds of condenser microphones. A microelectromechanical system (MEMS)-based directional acoustic array system is presented to demonstrate key technologies to reduce the cost, increase the mobility, and improve the data processing efficiency versus conventional systems. The system uses 16 hybrid-packaged MEMS silicon piezoresistive microphones that are mounted to a printed circuit board. In addition, a high-speed signal processing system was employed to generate the array response in near real time. Dynamic calibrations of the microphone sensor modules indicate an average sensitivity of 831 microV/Pa with matched magnitude (+/-0.6 dB) and phase (+/-1 degree) responses between devices. The array system was characterized in an anechoic chamber using a monopole source as a function of frequency, sound pressure level, and source location. The performance of the MEMS-based array is comparable to conventional array systems and also benefits from significant cost savings.

Journal Article↗