Biomedical subjects
Publications and source records attributed to Vincent Battista.
This case report presents the conversion of a ring finger metacarpophalangeal joint arthrodesis to arthroplasty, using a pyrocarbon implant. The patient sought a conversion secondary to poor grip strength and inability to perform basic tasks in his job with the Marine Corps. Three months after surgery he had a stable joint and a 50% increase in grip strength.
Several radiologic measurement methods have been described for determining static carpal alignment of the wrist. These include the scapholunate, radiolunate, and capitolunate angles. The triangulation method is an alternative radiologic measurement which we believe is easier to use and more reproducible and reliable than the above mentioned methods. The purpose of this study is to assess the intraobserver reproducibility and interobserver reliability of the triangulation method, scapholunate, radiolunate, and capitolunate angles. Twenty orthopaedic residents and staff at varying levels of training made four radiologic measurements including the scapholunate, radiolunate and capitolunate angles as well as the triangulation method on five different lateral, digitized radiographs of the wrist and forearm in neutral radioulnar deviation. Thirty days after the initial measurements, the participants repeated the four radiologic measurements using the same radiographs. The triangulation method had the best intra-and-interobserver agreement of the four methods tested. This agreement was significantly better than the capitolunate and radiolunate angles. The scapholunate angle had the next best intraobserver reproducibility and interobserver reliability. The triangulation method has the best overall observer agreement when compared to the scapholunate, radiolunate, and capitolunate angles in determining static midcarpal alignment. No comment can be made on the validity of the measurements since there is no radiographic gold standard in determining static carpal alignment.
This article describes a percutaneous fixation technique for a midwaist scaphoid fracture using an antegrade (dorsal) guidewire and a retrograde (volar) cannulated screw placement. This simplified hybrid technique allows for accurate dorsal central wire placement and stable internal fixation with minimal violation of the articular cartilage of the proximal pole of the scaphoid.
Instability is an important cause of failure following total knee arthroplasty. Increasing component constraint may reduce instability, but doing so also can cause increased forces to be transmitted to fixation and implant interfaces, which may lead to premature aseptic loosening. Constraint is defined as the effect of the elements of knee implant design that provides the stability needed to counteract forces about the knee after arthroplasty in the presence of a deficient soft-tissue envelope. Determining the amount of constraint necessary can be challenging. Most primary total knee arthroplasties are performed for knees without substantial deformity or the need for difficult ligament balancing; in these cases, either a posterior-stabilized or a posterior cruciate-retaining design is appropriate. In certain situations, such as patients with prior patellectomies, rheumatoid arthritis, or substantial preoperative deformities, a posterior-stabilized knee may be favored. With their large posts, varus-valgus constrained implants typically are reserved for patients with substantial coronal plane instability, which is difficult to balance with a posterior-stabilized or cruciate-retaining implant alone. Rotating-hinge knee implants usually are recommended for patients with severe deformity or instability that cannot be managed with a varus-valgus implant.
Explore the source record for details and available documents.