Biomedical subjects

W Grogger

Publications and source records attributed to W Grogger.

6 recordsLinked to original sources

PubMed2006

Cerenkov losses: a limit for bandgap determination and Kramers-Kronig analysis.

Measuring low energy losses in semiconductors and insulators with high spatial resolution becomes attractive with the increasing availability of modern transmission electron microscopes (TEMs) equipped with monochromators, C(s) correctors and energy filters. In this paper, we demonstrate that Cerenkov losses pose a limit for the interpretation of low energy loss spectra (EELS) in terms of interband transistions and bandgap determination for many materials. If the velocity of a charged particle in a medium exceeds the velocity of light, photons are emitted leading to a corresponding energy loss of a few electronvolt. Since these losses are strong for energies below the onset of interband transitions, they change the apparent loss function of semiconductors and insulators, with the risk of erroneous interpretation of spectra. We measured low energy losses of Si and GaAs with a monochromated TEM demonstrating the effect of sample thickness on Cerenkov losses. Angle resolved EELS and energy filtered diffraction patterns (taken without a monochromator) show the extremely narrow angular distribution of Cerenkov losses. The latter experiment provides a method that allows to decide whether Cerenkov radiation masks the very low loss signal in EELS.

Journal Article↗

PubMed2006

Microstructural characterization of nitrided Timetal 834.

The microstructure of Timetal 834, in as-received condition and after nitriding under glow discharge has been examined by light microscopy and analytical transmission electorn microscopy (TEM) methods (SAED, EDS, EELS and EFTEM). The microstructure of the as-received alloy consists of the alpha phase and a small amount of the beta phase. Silicide precipitates (Zr5Si4) are present both inside the grains and at the grain boundaries. TEM investigations of cross-sectional thin foils allow for detailed analysis of the nitrided layer microstructure. It was found that the nitrided layer exhibits a graded character with continuously varying nitrogen content. The outermost sublayer consists of nanocrystals of delta-TiN. The following sublayers consist mainly of delta'-Ti2N and epsilon-Ti2N grains. The last sublayer, closest to the substrate, is identified as a nitrogen-rich alpha(N) solid solution containing up to 14 at% of nitrogen.

Journal Article↗

PubMed2006

Single crystalline nature of para-sexiphenyl crystallites grown on KCl(100).

This work focuses on studies of the single crystal nature of para-sexiphenyl structures grown on freshly cleaved KCl(100) surfaces. Two different kinds of morphologies, namely terrace like structures and needle like structures, are found by atomic force microscopy as well as by electron microscopy. Regardless of the morphology the individual crystallites show highly regular shapes. The crystalline alignment and the degree of order of the crystallites on the surface are determined by X-ray diffraction. Several epitaxial alignments of para-sexiphenyl on KCl(100) are observed and all of them are perfectly aligned on the surface. The rocking curve widths of the organic crystallites do not exceed 800" which is approximately only the four fold of the substrates' ones. The single crystalline nature of para-sexiphenyl crystallites is proven by transmission electron microscopy, diffraction patterns, dark field imaging and high resolution techniques. Single crystalline terraced mounds reach diameters of several microns and heights of 50 nm. Single crystal needles show heights and breadths of more than 100 nm and lengths of several microns.

Crystallization↗

PubMed2003

Electron energy-loss near-edge structures of 3d transition metal oxides recorded at high-energy resolution.

Near-edge fine structures of the metal L(2,3) and O K-edges in transition metal-oxides have been studied with a transmission electron microscope equipped with a monochromator and a high-resolution imaging filter. This system enables the recording of EELS spectra with an energy resolution of 0.1eV thus providing new near-edge fine structure details which could not be observed previously by EELS in conventional TEM instruments. EELS-spectra from well-defined oxides like titanium oxide (TiO(2)), vanadium oxide (V(2)O(5)), chromium oxide (Cr(2)O(3)), iron oxide (Fe(2)O(3)), cobalt oxide (CoO) and nickel oxide (NiO) have been measured with the new system. These spectra are compared with EELS data obtained from a conventional microscope and the main spectral features are interpreted. Additionally, the use of monochromised TEMs is discussed in view of the natural line widths of K and L(2,3) edges.

Journal Article↗

PubMed2001

Direct evidence for block-by-block growth in high-temperature superconductor ultrathin films.

Charge neutrality and stoichiometry impose severe restrictions on the mechanisms of epitaxial growth of complex oxides. The fundamental question arises of what is the minimum growth unit when sample thickness is reduced beyond the size of the unit cell. We have investigated the growth mechanism of YBa2Cu3O7 cuprate superconductor, using a consistent approach based on the growth of noninteger numbers of YBa2Cu3O7 layers in YBa(2)Cu(3)O(7)/PrBa(2)Cu3O7 superlattices. Ex situ chemical and structural analysis evidence a 2D block-by-block mechanism in which the minimum growth units are complete unit cell blocks, growing coherently over large lateral distances.

Journal Article↗

PubMed2000

Quantitative Energy-filtering Transmission Electron Microscopy in Materials Science.

Energy-filtered transmission electron microscopy (EFTEM) can be used to acquire elemental distribution images at high lateral resolution within short acquisition times. In this article, we present an overview of typical problems from materials science which can be preferentially solved by means of EFTEM. In the first example, we show how secondary phases in a steel specimen can be easily detected by recording jump ratio images of the matrix element under rocking beam illumination. Secondly, we describe how elemental maps can be converted into concentration maps. A Ba-Nd-titanate ceramics serves as a typical materials science example exhibiting three different compounds with varying composition. In order to reduce diffraction and/or thickness variation effects which may be a problem for quantification of crystalline specimens, we calculated atomic ratio maps by dividing two elemental maps and subsequent normalizing by the partial ionization cross-sections (or k-factors). Additionally, the atomic ratio maps are correlated using the scatter diagram technique thus leading to quantitative chemical phase maps. Finally, we show how the near-edge structures (electron energy-loss near edge fine structures, or ELNES) can be used for mapping chemical bonding states thus differentiating between various modifications of an element. In order to distinguish between diamond and non-diamond carbon in diamond coated materials, we have investigated a diamond layer on a substrate with the help of ELNES mapping utilizing the pi*-peak of the C-K ionization edge.

Journal Article↗