Biomedical subjects

W Nazarov

Publications and source records attributed to W Nazarov.

5 recordsLinked to original sources

PubMed2005

Study of electron-beam propagation through preionized dense foam plasmas.

The transport of an intense electron-beam produced by the Vulcan petawatt laser through dense plasmas has been studied by imaging with high resolution the optical emission due to electron transit through the rear side of coated foam targets. It is observed that the MeV-electron beam undergoes strong filamentation and the filaments organize themselves in a ringlike structure. This behavior has been modeled using particle-in-cell simulations of the laser-plasma interaction as well as of the transport of the electron beam through the preionized plasma. In the simulations the filamentary structures are reproduced and attributed to the Weibel instability.

Journal Article↗

PubMed2002

Inhibition in the propagation of fast electrons in plastic foams by resistive electric fields.

The propagation of relativistic electrons in foam and solid density targets has been studied by means of K-alpha spectroscopy. Experimental results point out the role of self-generated electric fields in propagation and the role of heating of matter induced by the passage of fast electrons. A simple analytical formulation has been given and Spitzer conductivity has been shown to be fairly compatible with experimental results.

Journal Article↗

PubMed2002

Interaction of soft-x-ray thermal radiation with foam-layered targets.

We have studied the interaction of soft-x-ray thermal radiation with foam-layered metal targets. X-ray radiation was produced by focusing a high-energy laser inside a small size hohlraum. An increment in shock pressure, up to a factor of approximately 4 for 50 mg/cm(3) foam density, was observed with the foam layer as compared to bare metal targets. This follows from the propagation of radiation-driven shock wave in the foam and the impedance mismatch at the foam-payload interface.

Journal Article↗

PubMed2001

Use of low-density foams as pressure amplifiers in equation-of-state experiments with laser-driven shock waves.

The applicability of foams to equation of state experiments with laser-produced shocks has been studied. The pressure increase due to impedance mismatch at the payload-foam interface was measured experimentally using sub-ns laser pulses smoothed with phase zone plates. Foams of density in the range 5-900 mg/cm(3) and of thicknesses of 50-150 microm were used. A model has been developed to study pressure amplification and the conditions under which the shock is stationary. Two-step two-material targets, allowing simultaneous measurements of the shock velocities in the two materials, were then used to obtain relative equation of state data. Pressures higher than 100 Mbar were achieved in gold.

Journal Article↗

PubMed2000

Foam-induced smoothing studied through laser-driven shock waves

The influence of foams on the uniformity of laser energy deposition has been studied by measuring laser-driven shock waves breakout from foam-aluminum layered targets. Well characterized laser nonuniformities have been produced first by using phase zone plates to get a smooth beam and then by inserting different opaque grids before the foam. Smoothing has been studied as a function of foam density and grid materials (producing different radiative effects).

Journal Article↗