Wei-Ren Bao | PubMed Health

PubMed2005

Process effects on activated carbon with large specific surface area from corn cob.

The main factors that affect the large specific surface area (SSA) of the activated carbon from agricultural waste corn cobs were studied by chemically activated method with solution of KOH and soap which acted as surfactant. The experiment showed that not only the activation temperature, activation time and the mass ratio of KOH to the carbonized material, but also the activated methods using activator obviously influenced the SSA of activated carbon. The experimental operating conditions were as follows: the carbonized temperature being 450 degrees C and keeping time being 4 h using N2 as protective gas; the activation temperature being 850 degrees C and holding time being 1.2 h; the mass ratio of KOH to carbonized material being 4.0; the time of soaking carbonized material in the solution of KOH and soap being 30 min. Under the optimal conditions, the SSA of activated carbon from corn cobs reached 2700 m2/g. And the addition of the soap as surfactant may shorten the soaking time. The structure of the activated carbon prepared had narrow distribution of pore size and the micro-pores accounted for 78%. The advantages of the method described were easy and feasible.

Carbon↗

PubMed2004

Pyrolytic behavior of waste corn cob.

The powder of the agricultural waste corn cob was pyrolyzed in a tube-typed stainless steel reactor of 200 ml volume under N2 atmosphere. The compositions of the gases and liquid obtained at different pyrolytic temperatures below 600 degrees C at the heating rate of 30 K/min were analyzed. With the increment of the pyrolytic temperature, the yields of the solid and the liquid products were decreased, but the yield of gas products was increased. The liquid products were approximately 34-40.96% (wt%), the gas products were 27-40.96% (wt%) and the solid products 23.6-31.6% (wt%). There were less changes for the yields of these products above 600 degrees C. The gas products were analyzed by gas chromatography (GC) as CO2, CO, H2, CH4, C2H4, C3H6, C3H8, etc. When the temperature was 350-400 degrees C, the gases had CO2 and CO 80-95% (v/v). When the temperature increased continuously, yields of H2, CH4, C2H4, C3H6 and C3H8 gradually increased. The liquid products were identified by GC-MS as phenols, 2-furanmethanol, 2-cyclopentanedione, etc. The Fourier transform infra-red spectrophotometer (FT-IR) analysis of the liquid product showed a strong -OH group absorption peak. Differential thermogravimetric analysis (DTG) showed that thermal decomposition process involves two steps. The heating rate affects not only the activation energy of the decomposition reaction, but also the path of the reaction. With the increment of the heating rate, the maximum rate temperature of the decomposition reaction was shifted to a higher temperature, and the order and activation energy of the total decomposition reaction were decreasing.

China↗