Biomedical subjects

Wolfgang Pompe

Publications and source records attributed to Wolfgang Pompe.

11 recordsLinked to original sources

PubMed2007

Effect of modification of hydroxyapatite/collagen composites with sodium citrate, phosphoserine, phosphoserine/RGD-peptide and calcium carbonate on bone remodelling.

This study describes the early interface reaction of cancellous bone to a nanocrystalline hydroxyapatite cement containing type I collagen (HA/Coll) and its modifications with sodium citrate (CI), calcium carbonate (CA), phosphoserine (P) and phosphoserine plus RGD-peptide (RGD). Cylindrical implants of HA/Coll and its modifications were inserted into the tibia of Wistar rats. We analysed 6 specimens per group at days 2, 4, 7, 14 and 28. CI, P and RGD modifications showed improved material properties (finer microstructure and higher compressive strength) compared to CA and HA/Coll implants. The powder X-ray diffraction (XRD) showed that the addition of P and CI led to an increase of alpha-TCP peaks while the diffraction patterns of the non-modified cement (HA/Coll) were quite similar with that of natural bone. All of the implants healed without adverse reactions. A significantly higher number of TRAP-positive osteoclasts were observed around CI, RGD and P on day 7 compared to CA and HA/Coll. Around CI, P and RGD a significantly delayed increase of ED1-positive mononuclear cells was detected. The amount of direct bone contact after 28 days was significantly higher around CI, P and RGD compared to CA and HA/Coll implants. The addition of CI, P and RGD appears to enhance bone remodelling at the early stages of bone healing, leading to increased bone formation around HA/Coll composite cements.

Animals↗

PubMed2007

Electrostatic interactions modulate the conformation of collagen I.

The pH- and electrolyte-dependent charging of collagen I fibrils was analyzed by streaming potential/streaming current experiments using the Microslit Electrokinetic Setup. Differential scanning calorimetry and circular dichroism spectroscopy were applied in similar electrolyte solutions to characterize the influence of electrostatic interactions on the conformational stability of the protein. The acid base behavior of collagen I was found to be strongly influenced by the ionic strength in KCl as well as in CaCl(2) solutions. An increase of the ionic strength with KCl from 10(-4) M to 10(-2) M shifts the isoelectric point (IEP) of the protein from pH 7.5 to 5.3. However, a similar increase of the ionic strength in CaCl(2) solutions shifts the IEP from 7.5 to above pH 9. Enhanced thermal stability with increasing ionic strength was observed by differential scanning calorimetry in both electrolyte systems. In line with this, circular dichroism spectroscopy results show an increase of the helicity with increasing ionic strength. Better screening of charged residues and the formation of salt bridges are assumed to cause the stabilization of collagen I with increasing ionic strength in both electrolyte systems. Preferential adsorption of hydroxide ions onto intrinsically uncharged sites in KCl solutions and calcium binding to negatively charged carboxylic acid moieties in CaCl(2) solutions are concluded to shift the IEP and influence the conformational stability of the protein.

Amino Acid Sequence↗

PubMed2006

Catalytic oxidation activity of Pt3O4 surfaces and thin films.

The catalytic oxidation activity of platinum particles in automobile catalysts is thought to originate from the presence of highly reactive superficial oxide phases which form under oxygen-rich reaction conditions. Here we study the thermodynamic stability of platinum oxide surfaces and thin films and their reactivities toward oxidation of carbon compounds by means of first-principles atomistic thermodynamics calculations and molecular dynamics simulations based on density functional theory. On the Pt(111) surface the most stable superficial oxide phase is found to be a thin layer of alpha-PtO2, which appears not to be reactive toward either methane dissociation or carbon monoxide oxidation. A PtO-like structure is most stable on the Pt(100) surface at oxygen coverages of one monolayer, while the formation of a coherent and stress-free Pt3O4 film is favored at higher coverages. Bulk Pt3O4 is found to be thermodynamically stable in a region around 900 K at atmospheric pressure. The computed net driving force for the dissociation of methane on the Pt3O4(100) surface is much larger than that on all other metallic and oxide surfaces investigated. Moreover, the enthalpy barrier for the adsorption of CO molecules on oxygen atoms of this surface is as low as 0.34 eV, and desorption of CO2 is observed to occur without any appreciable energy barrier in molecular dynamics simulations. These results, combined, indicate a high catalytic oxidation activity of Pt3O4 phases that can be relevant in the contexts of Pt-based automobile catalysts and gas sensors.

Journal Article↗

PubMed2006

Parallel manipulation of bifunctional DNA molecules on structured surfaces using kinesin-driven microtubules.

We have developed a technique to manipulate bifunctional DNA molecules: One end is thiolated to bind to a patterned gold surface and the other end is biotinylated to bind to a microtubule gliding over a kinesin-coated surface. We found that DNA molecules can be stretched and overstretched between the gold pads and the motile microtubules, and that they can form dynamic networks. This serves as a proof-of-principle that biological machineries can be used in vitro to accomplish the parallel formation of structured DNA templates that will have applications in biophysics and nanoelectronics.

Bacteriophage lambda↗

PubMed2006

In vitro ossification and remodeling of mineralized collagen I scaffolds.

A promising strategy of bone tissue engineering is to repair bone defects by implanting biodegradable scaffolds that can undergo remodeling and be replaced completely by autologous bone tissue. For this purpose, it is necessary to create scaffolds that can be degraded by osteoclasts and enable osteoblasts to build new mineralized bone matrix. In order to achieve this goal a new porous material has been developed using biomimetically mineralized collagen I. These scaffolds were co-cultured with osteoclast-like cells and osteoblasts in order to characterize the capacity of these cells to remodel the material in vitro. It was possible to show the development of biologically active osteoclast- like cells that were able to invade and degrade the scaffold. They degraded the scaffold by internalizing it as intracellular vesicles, thereby making room for osteoblasts to invade and build new bone matrix. In addition, it could be shown that osteoblasts proliferated, differentiated, and produced new mineralized extracellular matrix. Hence, it could be shown that co-culture of osteoclastlike cells and osteoblasts on biomimetically mineralized collagen I is a promising approach for bone tissue engineering. In addition, it can be applied to study the process of bone remodeling in vitro.

Animals↗

PubMed2005

Osteocalcin enhances bone remodeling around hydroxyapatite/collagen composites.

The effect of osteocalcin (OC), an extracellular bone matrix protein, on bone healing around hydroxyapatite/collagen composites was investigated. Cylindrical nanocrystalline hydroxyapatite implants of 2.5-mm diameter containing 2.5% biomimetically mineralized collagen type I were inserted press-fit into the tibial head of adult Wistar rats. To one implant group, 10 mug/g OC was added. Six specimens per group were analyzed at 2, 7, 14, 28, and 56 days. After 14 days, newly formed woven bone had reached the implant surface of the OC implants whereas a broad fibrous interface could still be observed around controls. Woven bone was formed directly around both implant groups after 28 days and had been replaced partially by lamellar bone around the OC implants only. No significant differences in total bone contact were seen between both groups after 56 days. The higher number of phagocytosing cells and osteoclasts characterized immunohistochemically with ED1, cathepsin D, and tartate-resistant alkaline phosphatase around the OC implants at the early stages of bone healing suggests an earlier onset of bone remodeling. The earlier and increased expression of bone-specific matrix proteins and multifunctional adhesion proteins (osteopontin, bone sialoprotein, CD44) at the interface around the OC implants indicates that OC may accelerate bone formation and regeneration. This study supports the observations from in vitro studies that OC activates both osteoclasts and osteoblasts during early bone formation.

Animals↗

PubMed2005

Biomimetic porous scaffolds with high elasticity made from mineralized collagen--an animal study.

Histological investigations of a new hydroxyapatite-collagen composite material were carried out to evaluate its possible suitability as a bone substitute. The three-dimensional scaffolds made from biomimetically mineralized collagen exhibit an interconnecting pore structure and elastic mechanical properties. They were implanted into the subcutaneous tissue and bone defects made in the femur of rats and harvested with the surrounding tissue at 1, 2, 4, 8, and 12 weeks after surgery. The materials implanted in the subcutaneous tissue were covered by fibrous connective tissue with a slight inflammatory response, and many foreign-body giant cells were observed on the surface of the scaffolds. Most of the material implanted in the subcutaneous tissue was resorbed at 8 weeks by phagocytosis. In the bone defects, new bone formation was observed on the surface of the material at 1 week. New bone increased with time, and osteoclasts were seen on the surface of the scaffolds at 2 weeks. Resorption and replacement by new bone of many parts of the materials implanted in the femur were observed by 12 weeks. These responses occurred faster than those of other hydroxyapatite-collagen composites. The results suggested that the new biomimetically mineralized collagen scaffolds were suitable as an implant material for bone-tissue reconstruction.

Animals↗

PubMed2005

Novel catalysts, room temperature, and the importance of oxygen for the synthesis of single-walled carbon nanotubes.

In this letter, we show for the first time the use of metal oxides as catalysts in the synthesis of single-walled carbon nanotubes (SWCNTs) using laser ablation. Further, SWCNTs have been synthesized at low temperature (down to room temperature), where their nucleation cannot be explained via fullerene nucleation. The data point to a nucleation mechanism previously not identified, that places a stable oxidized ring as the root cause for the growth of SWCNTs.

Catalysis↗

PubMed2004

Electronic structure of regular bacterial surface layers.

We report photoemission and near-edge x-ray absorption fine structure measurements of the occupied and unoccupied valence electronic states of the regular surface layer of Bacillus sphaericus, which is widely used as the protein template for the fabrication of metallic nanostructures. The two-dimensional protein crystal shows a semiconductorlike behavior with a gap value of approximately 3.0 eV and the Fermi energy close to the bottom of the lowest unoccupied molecular orbital. We anticipate that these results will open up new possibilities for the electric addressability of biotemplated low-dimensional hybrid structures.

Bacillus↗

PubMed2004

Collagen type I increases bone remodelling around hydroxyapatite implants in the rat tibia.

The early interface reaction of cancellous bone to a nanocrystalline hydroxyapatite (HA) cement containing 3 wt% collagen type I (HA/Coll) with a setting under physiological temperature and pH was observed using immunohistochemical techniques. Pure HA served as a control. Cylinders with a diameter of 2 mm were implanted into the proximal tibia of 72 adult Wistar rats. Histological sections of 6 animals were prepared after 1, 2, 4, 6, 14 and 28 days. First, osteoblast-like cells as well as a marked reaction for osteonectin, osteopontin and its ligand CD44 were observed as early as 2 days after implantation at the interface around HA/Coll implants. Further, reactivity for ED1 and cathepsin D, both markers for phagocytotic cells, appeared earlier and stronger around HA/Coll. In cell counts, a significantly higher average number of ED1- and cathepsin D-positive phagocytotic cells was observed around the HA/Coll implants on days 6 (p < 0.01), 14 and 28 (p < 0.05). The number of osteopontin-positive cells was significantly higher around HA/Coll implants at days 6 and 14 (p < 0.05). Two weeks after the implantation, first islands of newly formed woven bone were observed around the HA/Coll implant, but not around the control implant. The amount of direct bone contact after 28 days averaged 28% around pure HA and 51% around HA/Coll implants (p < 0.05). While both implants displayed a good osteoconductivity, a higher bone remodelling activity was observed around collagen-containing HA implants compared to pure HA implants. It appears that the addition of collagen to HA implants can enhance both phagocytotic and osteogenic processes. This may result in an earlier acceptance and better osseointegration of the HA/Coll implants into the surrounding tissue.

Animals↗

PubMed2004

Single-walled carbon nanotube diameter.

Two different single-walled carbon nanotube (SWNT) growth modes (cap growth mode and circumference growth mode) are shown to exist. General SWNT diameter windows are derivable from catalyst particle size considerations. In addition, an almost complete picture of nanotube diameter dependencies for the cap growth mode is drawn from experiment. The nanotube diameter always scales linear with temperature, but the degree of dependence varies with the catalyst element. The nanotube diameter scales logarithmically with the gas pressure and catalyst composition. Very few or exactly one atom of a catalyst additive is sufficient to induce SWNT diameter changes. The experimental data allow the conclusion that the observed nanotube diameter is based on materials properties of sp2-bonded carbon/graphene sheets, on individual properties of the catalyst elements, and on additional kinetic components from temperature and pressure changes. Indications are found for a specific and maybe decisive role of adsorbate atoms at the surface of a catalyst particle on the nanotube diameter and therefore on the process of nanotube nucleation and growth.

Carbon↗