PubMed Health⌕ Search

Biomedical subjects

Y Elgersma

Publications and source records attributed to Y Elgersma.

21 records · Page 2Linked to original sources

DNA binding properties of the integrase proteins of human immunodeficiency viruses types 1 and 2.

Integration of retroviral DNA into the host chromosome requires the integrase protein (IN). We overexpressed the IN proteins of human immunodeficiency viruses types 1 and 2 (HIV-1 and HIV-2) in E. coli and purified them. Both proteins were found to specifically cut two nucleotides off the ends of linear viral DNA, and to integrate viral DNA into target DNA. This demonstrates that HIV IN is the only protein required for integration of HIV DNA. Although the two types of IN proteins have only 53% amino acid sequence similarity, they act with equal efficiency on both type 1 and type 2 viral DNA. Binding of IN to DNA was tested: purified IN does not bind very specifically to viral DNA ends. Nevertheless, only viral DNA ends are cleaved and integrated. We interpret this as follows: in vitro quick aspecific binding to DNA is followed by slow specific cutting and integration. IN can not find viral DNA ends in the presence of an excess of aspecific DNA; in vivo this is not required since the IN protein is in constant proximity of viral DNA in the viral core particle.

Base Sequence↗

Human immunodeficiency virus integrase protein requires a subterminal position of its viral DNA recognition sequence for efficient cleavage.

Retroviral integration requires cis-acting sequences at the termini of linear double-stranded viral DNA and a product of the retroviral pol gene, the integrase protein (IN). IN is required and sufficient for generation of recessed 3' termini of the viral DNA (the first step in proviral integration) and for integration of the recessed DNA species in vitro. Human immunodeficiency virus type 1 (HIV-1) IN, expressed in Escherichia coli, was purified to near homogeneity. The substrate sequence requirements for specific cleavage and integration of retroviral DNA were studied in a physical assay, using purified IN and short duplex oligonucleotides that correspond to the termini of HIV DNA. A few point mutations around the IN cleavage site substantially reduced cleavage; most other mutations did not have a drastic effect, suggesting that the sequence requirements are limited. The terminal 15 bp of the retroviral DNA were demonstrated to be sufficient for recognition by IN. Efficient specific cutting of the retroviral DNA by IN required that the cleavage site, the phosphodiester bond at the 3' side of a conserved CA-3' dinucleotide, be located two nucleotides away from the end of the viral DNA; however, low-efficiency cutting was observed when the cleavage site was located one, three, four, or five nucleotides away from the terminus of the double-stranded viral DNA. Increased cleavage by IN was detected when the nucleotides 3' of the CA-3' dinucleotide were present as single-stranded DNA. IN was found to have a strong preference for promoting integration into double-stranded rather than single-stranded DNA.

Base Sequence↗

Analysis of the junctions between human immunodeficiency virus type 1 proviral DNA and human DNA.

Integrated retroviral DNA is flanked by short direct repeats of the target DNA. The length of these repeats is specific for the provirus that is integrated (H.E. Varmus, in J.A. Shapiro, ed., Mobile Genetic Elements, 1983). For the human immunodeficiency virus type I (HIV-1), the length of the direct repeats in the target DNA was shown to be 5 bp in one case (Muesing et al., Nature [London] 313:450-458, 1985) and 7 bp in another (Starcich et al., Science 227:538-540, 1985). One possible explanation for this discrepancy is that the direct repeats flanking HIV-1 proviruses are variable. To investigate this, we analyzed the junctions between HIV-1 proviral DNA and human DNA from nine individual clones. In each clone the provirus was flanked by a 5-bp direct repeat of human DNA. Analysis of the proviral clone previously described as being flanked by a 7-bp direct repeat of target DNA (Starcich et al., op. cit.) revealed that this clone was flanked by a 5-bp repeat instead. Therefore, we conclude that HIV-1 proviruses are flanked by 5-bp direct repeats of human DNA. The sequences of the 5-bp duplications from the different proviral clones do not have any apparent similarity to each other or to HIV-1 DNA.

Base Sequence↗