Biomedical subjects
Publications and source records attributed to Y R Shen.
We observed that weakly and strongly rubbed polyvinyl-cinnamate surfaces align liquid crystal films perpendicular and parallel to the rubbing direction, respectively. Surface-specific sum-frequency vibrational spectroscopy was used to probe molecular orientations and alignments of the rubbed surfaces and provide a molecular-level understanding of the observation.
Sum-frequency vibrational spectroscopy was used to study interfacial structure of methanol:water mixtures at an octyltrichlorosilane-covered hydrophobic surface. Methanol was found to adsorb preferentially than water at the interface with its methyl group tilted from the surface normal by approximately 35 degrees for all methanol concentrations. Redshift of the methanol symmetric stretch mode, gradual disappearance of the water dangling-OH mode, and blueshifts of the dangling and liquidlike bonded-OH modes were also observed as the methanol concentration increased. They could be understood from the change of the interfacial hydrogen-bonding network associated with the change of surface composition.
We present a comprehensive study on the dynamics of laser-induced molecular reorientation in a dye-doped liquid crystalline (LC) medium that exhibits significant enhancement of the optical Kerr nonlinearity due to guest-host interaction. Using various techniques, we separately characterized the dynamical responses of the relevant molecular species present in the medium following photoexcitation and, thus, were able to follow the transient process in which photoexcitation of the dye molecules exert through guest-host interaction a net torque on the host LC material, leading to the observed enhanced optical Kerr nonlinearity. Experimental results agree quantitatively with the time-dependent theory based on a mean-field model of the guest-host interaction.
We introduce an optical pump/probe method that allows selective measurement of ground-state rotational dynamics of solutes in liquids. It relies on employing two successive pump pulses that are adjusted to create an optical anisotropy due to the orientational distribution of only the ground-state solute molecules. Measurement on a dye-solvent system shows a large difference between the rotational diffusion rates of the ground state and the excited state of the dye molecules due to different solute-solvent interactions.
A phase-sensitive sum-frequency vibrational spectroscopic technique is developed to study interfacial water structure of water/quartz interfaces. Measurements allow deduction of both real and imaginary parts of the surface nonlinear spectral response, revealing an unprecedentedly detailed picture of the net polar orientations of the water species at the interface. The orientations of the icelike and liquidlike species appear to respond very differently to the bulk pH change indicating the existence of different surface sites on quartz with different deprotonation pK values.
Sum-frequency vibrational spectroscopy was used as a novel technique to probe the molecular chirality of thin polymer films. Chiral vibrational spectra of poly(bithienylene-phenylene) were obtained, and the two enantiomers were distinguished by an interference method. Vibration-electronic double resonance was responsible for the observation of unusually strong chiral spectra of the phenylene vibration modes.
We have shown that optically active second-harmonic generation is allowed in a uniaxial fluid medium. A homeotropically aligned chiral smectic-A liquid crystal was used as an example. Phase matching was achievable by angle tuning. Chiral nonlinear susceptibility for the liquid crystal was deduced. The signal dropped precipitously as the sample underwent the transition from smectic-A to isotropic.
The strength of the chiral vibrational peaks in infrared-visible sum-frequency (SF) vibrational spectra from isotropic chiral liquids is proportional to the square of the corresponding antisymmetric Raman element. Under the Born-Oppenheimer adiabatic approximation with nonadiabatic corrections, the antisymmetric Raman tensor is much weaker than the symmetric counterpart, but becomes significantly stronger as the input frequency (or the sum-frequency in SF generation) approaches electronic resonance. We verify the theory with experimental results obtained from infrared-visible doubly resonant sum-frequency generation from an isotropic solution of chiral molecules.
We show theoretically and experimentally that for sum-frequency vibrational spectroscopy near electronic transitions, resonant enhancement of the chiral response can be much stronger than that of the achiral response. The doubly resonant spectrum selectively enhances the vibrational modes through their different electron-vibration couplings. The unusually strong resonant enhancement significantly improves sensitivity of chiral spectroscopy and allows detection of the chiral vibrational spectrum of a molecular monolayer for the first time.
Electrical poling induces polar ordering of molecules in a grating that has been holographically inscribed on a thin film of polymer with azobenzene side chains. The resulting chi2 grating, seen by second-harmonic-generation (SHG) near-field scanning optical microscopy, can have a periodic structure that is significantly different from the topographical image. The far-field linear and SHG diffration patterns correlate well with the grating structures. Poling of the thin-film grating, which presumably has photodriven nonuniform material properties within each period, leads to the more complex structure of the chi2 grating.
We have studied in detail the early dynamics of laser-induced molecular reorientation in a dye-doped liquid crystalline (LC) medium that exhibits a significant enhancement of the optical Kerr nonlinearity due to guest-host interaction. Experimental results agree quantitatively with theory based on a model in which the anisotropic dye excitation helps reorient the LC molecules through a mean-field intermolecular interaction.
Fibrinogen adsorption on polyurethanes with different surface-modifying end groups (SMEs) has been studied with sum-frequency-generation vibrational spectroscopy (SFG). The results show very different protein adsorption properties for different SMEs on the same backbone polymer. Fibrinogen binds weakly on the hydrophilic backbone of a poly(dimethyl siloxane) (PDMS)-modified polyurethane surface but leaves the hydrophobic PDMS part untouched. On sulfonate end-group-modified (SO(3(-) )) polyurethane surfaces, fibrinogen adsorbs well. However, on poly(ethylene oxide) (PEO)-modified surfaces, it adsorbs poorly. The protein-resistant character of PEO is probably due to steric repulsion. This work demonstrates the utility of SFG in the study of protein adsorption on polymeric biomaterials at the molecular level and the ability of SMEs to mediate protein adsorption.
Recently, sum frequency generation (SFG) vibrational spectroscopy has been developed into a powerful technique to study surfaces of polymer materials. This review summarizes the significant achievements in understanding surface molecular chemical structures of polymer materials obtained by SFG. It reviews in situ detection at the molecular level of surface structures of some common polymers in air, surface segregation of small end groups, polymer surface restructuring in water, and step-wise changed polymer blend surfaces. Studies of surface glass transition and surface structures modified by rubbing, plasma deposition, UV light irradiation, oxygen ion and radical irradiation, and wet etching are also discussed. SFG probing of polymer surfaces provides valuable insights into the relations between polymer surface structures and surface properties, which will assist in the design of polymer materials with desired surface properties.
We demonstrate experimentally that visible-visible sum-frequency generation in the bulk of a chiral liquid is observable near electronic resonant transitions. Although the process is electric dipole allowed, it is rather weak because the orientational average over molecules effectively reduces the bulk chiral nonlinearity.
Surface lamellar decoration (SLD), surface enhanced Raman scattering (SERS) and optical second harmonic generation (SHG) experiments have been utilized to study the molecular orientation and conformation changes at a rubbed polyimide alignment-layer surface. This aromatic polyimide containing pendent cyanobiphenyl mesogens was synthesized via a polycondensation of 2,2'-bis(3,4-dicarboxy-phenyl)hexafluoropropane dianhydride (6FDA) with bis[omega-[4-(4-cyanophenyl)phenoxy]hexyl] 4,4'-diamino-2,2'-biphenyldicarboxylate (nCBBP, n = 6), abbreviated as 6FDA--6CBBP. Uniform alignment layers, possessing high pretilt angles ranging from 39 degrees to 43 degrees, have been achieved after mechanical rubbing of the polyimide thin film surface at room temperature and subsequent annealing. This is the first time that high pretilt angles have been detected to possess a negative angle (-theta(c)) with respect to the rubbing direction (i.e., opposite to the rubbing direction), considerably different from the conventional pretilt angle (theta(c)) observed along the rubbing direction. This observation is confirmed using magnetic null and SHG methods. Combined polyethylene (PE) SLD and atomic force microscopy experiments reveal that the azimuthal orientation distribution of the long axis of the edge-on PE lamellar crystals is oriented normal to the rubbing direction, indicating that the PE chains are aligned parallel to the rubbing direction. This SLD technique probes the anisotropic surface orientation of the outermost molecules of the rubbed polyimide layer. The SERS results show that prior to rubbing the surface, both the pendent cyanobiphenyls in the side chains and backbones possess nearly planar chain conformations at the polyimide surface. Mechanical rubbing causes not only tilting of the backbone moieties, such as imide-phenylene structure, but also significant conformational rearrangements of the pendent side chains at the surfaces. The molecular mechanism of this unusual alignment is due to the fact that the pendent cyanobiphenyls forms a uniformly tilted conformation on the rubbed surface, and the polar cyano groups point down toward the layer surface deduced from SHG phase measurements. This conformational rearrangement of the side chains results in the formation of fold-like bent structures on the surface, which directly leads to the long axis of cyanobiphenyls having the -theta(c) pretilt angle with respect to the rubbing direction.
Fast orientational motion of molecules at a surface can affect the sum-frequency vibrational spectra of the surface. Calculation shows that the effect is significant if the molecular orientation varies over a broad range within the vibrational relaxation time. The stretch vibration of the free OH bonds at the vapor/water interface is used to illustrate the importance of the effect.
Surface second harmonic generation was used to obtain approximate orientational distributions of the side chains and the adsorbed liquid crystal (LC) molecules on a rubbed side-chain polyimide surface. Both the side chains and the LC molecules appear to be well aligned in the rubbing direction but tilted away from the surface in the antirubbing direction. The latter yields a negative pretilt angle in a homogeneously aligned LC film sandwiched between two such surfaces. The side chains and the LC molecules, however, have antiparallel orientations at the surface.
Surface melting on the (0001) face of hexagonal ice ( I(h)) was studied by sum-frequency vibrational spectroscopy in the OH stretch frequency range. The degree of orientational order of the dangling OH bonds at the surface was measured as a function of temperature. Disordering sets in around 200 K and increases dramatically with temperature. The results show that the disordered (quasiliquid) layer on ice is structurally different from normal liquid water.