Biomedical subjects

Yasuo Iida

Publications and source records attributed to Yasuo Iida.

9 recordsLinked to original sources

PubMed2006

FEM calculation of an acoustic field in a sonochemical reactor.

The spatial distribution of the acoustic amplitude in a sonochemical reactor has been numerically calculated using the finite element method (FEM). In the FEM program, the acoustic field in a sonochemical reactor is coupled with the vibration of the reactor's wall. The present calculations have revealed that the thin (thick) glass or stainless steel wall is nearly a free (rigid) boundary and that the glass wall is freer than the stainless steel wall. The influence of the attenuation coefficient of ultrasound on the acoustic field has also been studied in order to see the effect of bubbles on the acoustic field. As the attenuation coefficient increases, the vibration amplitude of the reactor's wall becomes smaller and the acoustic emission from the vibrating wall becomes weaker. The qualitative feature of the spatial pattern of sonochemiluminescence from an aqueous luminol solution has been reproduced by the calculation when the attenuation coefficient is in the range of 0.5-5m(-1). When the attenuation coefficient is less than about 0.05 m(-1), the standing wave pattern of an acoustic field in the liquid is very complex due to the acoustic emission from the vibrating wall. The present calculations have also revealed that some stripes of pressure antinodes have also been disconnected when the radius of the transducer is much smaller than the side length of the vibrating plate. The dependence of the acoustic field on the liquid height is also discussed.

Journal Article↗

PubMed2006

Enhancement of sonochemical reaction rate by addition of micrometer-sized air bubbles.

The sonochemical reaction rate has been enhanced by the introduction of tiny air bubbles. The bubbles including micrometer-sized ones are produced by method of atomization and are introduced into aqueous luminol solution under 141-kHz sonication in order to investigate the enhancement of sonochemical reaction rate by introduction of tiny bubbles through the intensity measurement of sonochemiluminescence (SCL). It is shown that the introduction of tiny bubbles under sonication accomplishes the large SCL intensity compared to the cases of sonication only and liquid flow under sonication. It is also shown that it is important to adjust the configuration of tiny-bubble addition to the sound field. Through the investigations on the intensity and the spatial pattern of luminol-SCL, it has been clarified that tiny bubbles added into the sonicated liquid not only cause the liquid flow but also increase the number of collapsing bubbles active for sonochemical reaction. It is also shown that the tiny-bubble addition enhances the reaction rate of KI oxidation under sonication. Therefore, the present method of introduction of tiny bubbles is effective for enhancement of sonochemical reaction rate.

Journal Article↗

PubMed2006

Fabrication of zinc ferrite nanocrystals by sonochemical emulsification and evaporation: observation of magnetization and its relaxation at low temperature.

A new ultrasound assisted emulsion (consisting of rapeseed oil and aqueous solution of Zn(2+) and Fe(2+) acetates) and evaporation protocol has been developed for the synthesis of zinc ferrite (ZnFe(2)O(4)) nanoparticles with narrow size distribution. The as-synthesized sample consisted of crystalline zinc ferrite particles with an average diameter of approximately 4 nm, whereas the average size of the heat-treated ferrite particles increases to approximately 12 nm. To remove the small amount of oil present on the surface of the as-synthesized ferrite sample, heat treatment was carried out at 350 degrees C for 3 h. The as-synthesized and heat-treated ferrites were characterized by X-ray diffraction (XRD), infrared spectroscopy (IR), TGA/DTA, transmission electron microscopy (TEM), and energy dispersion X-ray spectroscopy (EDS) techniques. Magnetic measurements show that the nanocrystalline ZnFe(2)O(4), prepared through this technique, is either at par with those obtained in other cases or even more improved. Both the as-synthesized and heat-treated samples reveal relaxation of magnetization. Our study also shows that one can tailor the magnetization and relaxation pattern by suitably controlling the particle size of the nanocrystalline ZnFe(2)O(4). The key features of this method are avoiding (a) the cumbersome conditions that exist in the conventional methods, (b) the usage of necessary additive components (stabilizers or surfactants, precipitants), and (c) calcination requirements. In addition, rapeseed oil has replaced organic nonpolar solvents used in earlier studies. As a whole, this simple straightforward sonochemical approach results in a better pure phase system of nanoferrite with improved magnetic properties.

Emulsions↗

PubMed2006

Influence of dissolved-air concentration on spatial distribution of bubbles for sonochemistry.

The pulsation of ultrasonic cavitation bubbles at various dissolved-air concentration in a sonochemical reaction field of standing-wave type is investigated experimentally by laser-light scattering. When a thin light sheet, finer than half the wavelength of sound, is introduced into the cavitation bubbles at an antinode of sound pressure, the scattered light intensity oscillates. The peak-to-trough light intensity is correlated with the number of bubbles that contribute to the sonochemical reaction. It is shown that as the dissolved air concentration becomes higher, the weighted center of the spatial distribution of the peak-to-trough intensity tends to shift towards the liquid surface. At higher concentration of the dissolved air, a great deal of bubbles with size distribution generated due to coalescence between bubbles disturbs sound propagation to change the sound phase easily. A standing wave to trap tiny oscillating bubbles is established only at the side which is nearer to the liquid surface. Also at higher concentration, liquid flow induced by drag motion of bubbles by the action of radiation force becomes apparent and position-unstable region of bubble is enlarged from the side of sound source towards the liquid surface. Therefore, the position of oscillating bubbles active for sonochemical reaction is limited at the side which is nearer to the liquid surface at higher concentration of the dissolved air.

Air↗

PubMed2005

Theoretical study of single-bubble sonochemistry.

Numerical simulations of bubble oscillations in liquid water irradiated by an ultrasonic wave are performed under the experimental condition for single-bubble sonochemistry reported by Didenko and Suslick [Nature (London) 418, 394 (2002)]. The calculated number of OH radicals dissolving into the surrounding liquid from the interior of the bubble agrees sufficiently with the experimental data. OH radicals created inside a bubble at the end of the bubble collapse gradually dissolve into the surrounding liquid during the contraction phase of an ultrasonic wave although about 30% of the total amount of OH radicals that dissolve into the liquid in one acoustic cycle dissolve in 0.1 micros at around the end of the collapse. The calculated results have indicated that the oxidant produced by a bubble is not only OH radical but also O atom and H2O2. It is suggested that an appreciable amount of O atom is produced by bubbles inside a standing-wave-type sonochemical reactor filled with water in which oxygen is dissolved as in the case of air.

Journal Article↗

PubMed2005

Correlation between acoustic cavitation noise and yield enhancement of sonochemical reaction by particle addition.

The mechanism of the effect of particle addition on sonochemical reaction is studied through the measurements of frequency spectrum of sound intensity for evaluating the cavitation noise and the absorbance for the liberation of iodine from an aqueous solution of KI as an index of oxidation reaction by ultrasonic irradiation in the presence or absence of alumina particles. As it is expected that both the acoustic noise and a rise in temperature in the liquid irradiated by intense ultrasound will increase with the number of collapsing bubbles, these are supposed to be the best tools for evaluating the relative number of bubbles. In the present investigation, it has been shown that the addition of particles with appropriate amount and size results in an increase in the absorbance when both the acoustic noise and the rise in the liquid temperature due to cavitation bubbles also increase. This suggests that the enhancement in the yield of sonochemical reaction by appropriate particle addition comes from an increase in the number of cavitation bubbles. The existence of particle in liquid provides a nucleation site for cavitation bubble due to its surface roughness, leading to the decrease in the cavitation threshold responsible for the increase in the number of bubbles when the liquid is irradiated by ultrasound. Thus, from the present investigation, it is clarified that the particle addition has a potential to enhance the yield in the sonochemical reaction.

Chemical Phenomena↗

PubMed2005

Dependence of the characteristics of bubbles on types of sonochemical reactors.

Computer simulations of bubble oscillations in liquid water irradiated by an ultrasonic wave have revealed that the characteristic of bubbles depends on types of sonochemical reactors: a horn-type reactor and a standing-wave type reactor. When the acoustic amplitude is large at 20 kHz, the bubble content is mostly water vapor even at the end of the bubble collapse and the temperature inside a bubble at the collapse is relatively low. On the other hand, when the acoustic amplitude is relatively low, the bubble content is mostly noncondensable gas at the end of the bubble collapse and the bubble temperature is relatively high. In a horn-type sonochemical reactor, the former type of bubbles are dominant because many bubbles exist near the horn-tip where the acoustic amplitude is large, while in a standing-wave type reactor the latter type of bubbles are dominant because the Bjerknes force gathers bubbles at a region where acoustic amplitude is relatively low.

Computer Simulation↗

PubMed2004

Ultrasonic cavitation in microspace.

Ultrasound was irradiated to a micro-1D and -2D space having a characteristic length of 200 microm, and the presence of cavitation was confirmed from video images, and the generation of OH radicals, which was quantitatively evaluated with fluorometry.

Journal Article↗

PubMed2004

Optimum bubble temperature for the sonochemical production of oxidants.

Numerical simulations of bubble oscillations in liquid water irradiated by an ultrasonic wave are performed for various acoustic amplitudes and various ambient pressures. In the numerical simulations, effect of non-equilibrium evaporation and condensation of water vapor at the bubble wall and that of chemical reactions of gases and vapor inside a bubble are taken into account. The oxidants such as OH radicals, O radicals, H(2)O(2) molecules, and O(3) molecules are created from water vapor inside a heated bubble when a bubble collapses strongly. They are dispersed into the liquid and solutes are oxidized by the oxidants, which is called sonochemical reactions. The computer simulations have revealed that there exists the optimum bubble temperature, which is about 5500 K, for the production of the oxidants inside an air bubble because at higher bubble temperature the oxidants are strongly consumed inside a bubble by oxidizing nitrogen. Correspondingly, there exists an optimum acoustic amplitude for the production of the oxidants, which is about 2.2 atm when the ultrasonic frequency is 140 kHz and the ambient pressure is 1 atm. For an oxygen bubble, on the other hand, the amount of the oxidants created inside a bubble becomes nearly independent of the bubble temperature at the collapse above about 6000 K because nitrogen is absent.

Journal Article↗