PubMed Health⌕ Search

Biomedical subjects

Young-Soo Seo

Publications and source records attributed to Young-Soo Seo.

12 recordsLinked to original sources

No intrinsic depletion layer on a polystyrene thin film at a water interface.

Using neutron reflectivity, we found that there is no intrinsic depletion layer at a deuterated polystyrene (dPS) film and deuterium oxide (D(2)O) interface. A spun-cast film is susceptible to contamination on its surface from its surroundings during sample preparation. A contamination layer of hydrogenated organic material will be detected as a reduced scattering length density layer at the interface. We demonstrate that, by careful treatment of the film, contamination would be the primary cause of the reduced scattering length density layer at the interface.

Journal Article↗

Separation of DNA with different configurations on flat and nanopatterned surfaces.

We demonstrate that electrophoresis on a flat Si substrate is an effective method in separation of DNA with different configurations, e.g., linear, supercoiled, and relaxed or DNA of different length, e.g., supercoiled DNA ladder. The surface separation arises from the different number of contacts due to the conformational differences between adsorbed DNA chains. Imposing a Au nanopattern on the Si surface further improves the separation effect. The simulation of electric field on this patterned surface by the finite element method shows that Au nanodots act as local pinning points for DNA segments due to dielectrophoretic force. The results of molecular dynamics simulation showed that the conformational differences between adsorbed polymer chains were amplified on the patterned surface and enhanced separations were achieved, which are consistent with the experimental results.

Computer Simulation↗

Drying of DNA droplets.

The evaporation kinetics of droplets containing DNA was studied, as a function of DNA concentration. Drops containing very low DNA concentrations dried by maintaining a constant base, whereas those with high concentration dried with a constant contact angle. To understand this phenomenon, the distribution of the DNA inside the droplet was measured using confocal microscopy. The results indicated that the DNA was condensed mostly on the surface of the droplets. In the case of high concentration droplets, it formed a shell, whereas isolated islands were found for droplets of low DNA concentrations. Rheologic results indicate the formation of a hydro gel in the low concentration drops, whereas phase separation between the self-assembled DNA structures and the water phase occurred at higher concentration.

Bacteriophage lambda↗

Influence of electric field intensity, ionic strength, and migration distance on the mobility and diffusion in DNA surface electrophoresis.

In order to increase the separation rate of surface electrophoresis while preserving the resolution for large DNA chains, e.g., genomic DNA, the mobility and diffusion of Lambda DNA chains adsorbed on flat silicon substrate under an applied electric field, as a function of migration distance, ionic strength, and field intensity, were studied using laser fluorescence microscope. The mobility was found to follow a power law with the field intensity beyond a certain threshold. The detected DNA peak width was shown to be constant with migration distance, slightly smaller with stronger field intensity, but significantly decreased with higher ionic strength. The molecular dynamics simulation demonstrated that the peak width was strongly related with the conformation of DNA chains adsorbed onto surface. The results also implied that there was no diffusion of DNA during migration on surface. Therefore, the Nernst-Einstein relation is not valid in the surface electrophoresis and the separation rate could be improved without losing resolution by decreasing separation distance, increasing buffer concentration, and field intensity. The results indicate the fast separation of genomic DNA chains by surface electrophoresis is possible.

Bacteriophage lambda↗

Adsorption of myoglobin to Cu(II)-IDA and Ni(II)-IDA functionalized langmuir monolayers: study of the protein layer structure during the adsorption process by neutron and X-ray reflectivity.

The structure and orientation of adsorbed myoglobin as directed by metal-histidine complexation at the liquid-film interface was studied as a function of time using neutron and X-ray reflectivity (NR and XR, respectively). In this system, adsorption is due to the interaction between iminodiacetate (IDA)-chelated divalent metal ions Ni(II) and Cu(II) and histidine moieties at the outer surface of the protein. Adsorption was examined under conditions of constant area per lipid molecule at an initial pressure of 40 mN/m. Adsorption occurred over a time period of about 15 h, allowing detailed characterization of the layer structure throughout the process. The layer thickness and the in-plane averaged segment volume fraction were obtained at roughly 40 min intervals by NR. The binding constant of histidine with Cu(II)-IDA is known to be about four times greater than that of histidine with Ni(II)-IDA. The difference in interaction energy led to significant differences in the structure of the adsorbed layer. For Cu(II)-IDA, the thickness of the adsorbed layer at low protein coverage was < or = 20 A and the thickness increased almost linearly with increasing coverage to 42 A. For Ni(II)-IDA, the thickness at low coverage was approximately 38 A and increased gradually with coverage to 47 A. The in-plane averaged segment volume fraction of the adsorbed layer independently confirmed a thinner layer at low coverage for Cu(II)-IDA. These structural differences at the early stages are discussed in terms of either different preferred orientations for isolated chains in the two cases or more extensive conformational changes upon adsorption in the case of Cu(II)-IDA. Subphase dilution experiments provided additional insight, indicating that the adsorbed layer was not in equilibrium with the bulk solution even at low coverages for both IDA-chelated metal ions. We conclude that the weight of the evidence favors the interpretation based on more extensive conformational changes upon adsorption to Cu(II)-IDA.

Adsorption↗

Supramolecular ordering of tripod dyes at the air/water interface.

Monolayers of 2-(3,4,5-(trisdodecyloxyl)phenyl)[1,3,4]oxadiazole based "tripod" dye, P2G, has been studied at the air/water interface with in situ X-ray reflectivity. Compression of the disordered Langmuir-Blodgett monolayer film induces a transition to a unique ordered phase, representing a supramolecular assembly with a unique spatial distribution and orientation of the molecules. At low pressure, the molecules having face-on orientation are interdigitated by the three arms. After first transition in the pi-A isotherm, the molecular conformation is turned into an edge-on orientation, where the molecules are self-assembled into supramolecular structures.

Journal Article↗

Deviations from liquidlike behavior in molten polymer films at interfaces.

We have performed x-ray specular and diffuse scattering on liquid polymer films and analyzed the spectra as a function of film thickness and molecular weight. The results show that films whose molecular weight is close to the entanglement length behave as simple liquids except that the shortest wavelength is determined by the radius of gyration (R(g)) rather than the monomer-monomer distance. When the molecular weight is higher than the entanglement length, the strong deviations from liquidlike behavior are observed. We find that the long wavelength cutoff vector, q(l,c), scales with film thickness, d as d(-1.1+/-0.1) rather than the usual d(-2) expected for simple liquids. If we assume that these deviations are due to surface pinning of the polymer chains, then our results are consistent with the formalism developed by Fredrickson et al. to explain the capillary wave spectrum that can propagate in a polymer brush.

Journal Article↗

Control of degradation rate and hydrophilicity in electrospun non-woven poly(D,L-lactide) nanofiber scaffolds for biomedical applications.

Typical properties of poly(D,L-lactide) (PLA)-based scaffolds (films and foams), such as long degradation time, mechanical stiffness and hydrophobicity, are sometimes not suitable for biomedical applications. These properties can be substantially altered by electrospinning of PLA blends with miscible poly(lactide-co-glycolide) (PLGA) random copolymers, poly(lactide-b-ethylene glycol-b-lactide) (PLA-b-PEG-b-PLA) triblock copolymers, and a lactide (used as a hydrolytic catalyst). Electrospun scaffolds based on the multi-component PLA blends, comprised of randomly interconnected webs of sub-micron sized fibers, have a bulk density of 0.3-0.4 g/cm3. In this study, the concentration effects of PLA-b-PEG-b-PLA triblock copolymer and lactide on the cell proliferation and the hydrophilicity of electrospun scaffolds were investigated. Based on in vitro degradation study, we found that the electrospun scaffold having PLA (40 wt%), PLGA (LA/GA=50/50, 25 wt%), PLA-b-PEG-b-PLA (20 wt%), and lactide (15 wt%) underwent a rapid weight loss of approximately 65% in 7 weeks. The hydrophobicity of this membrane, as determined by contact angle measurements in a cell buffer solution, decreased by approximately 50% from 105 degrees (of an electrospun PLA scaffold) to 50 degrees. The selection of suitable chemical compositions in conjunction with the non-invasive electrospinning process is useful in the production of a new kind of biodegradable scaffolds suitable for different biomedical applications such as cell storage and delivery as well as prevention of post-surgical adhesion because of their porosity, mechanical flexibility and tunable biodegradability.

3T3 Cells↗

Density-fluctuation-induced swelling of polymer thin films in carbon dioxide.

We report an anomalous swelling of polymer thin films in carbon dioxide (CO(2)) which is associated (in both locus and form) with the density fluctuation ridge that forms along the extension of the coexistence curve of gas and liquid in the P-T phase diagram. Neutron reflectivity results showed that CO(2) could be sorbed to a large extent ( approximately 60%) in thin polymer films even when the bulk miscibility of the polymer with CO(2) is very poor. The anomalous swelling is found to scale with the polymer radius of gyration (R(g)) and extends to a distance approximately 10 R(g).

Journal Article↗

DNA separation at a liquid-solid interface.

We demonstrate that it is possible to separate a broad band of DNA on a solid substrate without topological obstacles. The mobility was found to scale with molecular size (N) as N(-0.25), while the resolution scaled as N(0.75) indicating that diffusivity on this substrate was minimal. By varying the buffer concentration we were able to show that the mobility for a given chain length scaled with the persistent length (p) as p(1/2). This could be shown to be related to the Gaussian conformation of the chains adsorbed on the surface. A two-dimensional corrugated surface of nonporous silica beads was produced using a self-assembling process at the air/water interface. Even though the surface corrugations were comparable to persistence length we show that they do not affect the mobility, indicating that surface friction rather than topological constraints are the predominant mechanism of separation on a surface.

Adsorption↗

Cortisol response to buspirone in extended abstinent alcoholics.

We evaluated cortisol response to buspirone in extended abstinent alcoholic patients to determine 5-HT1A receptor sensitivity in alcoholism. Alcoholic patients were inpatients with an extended abstinent period of at least 3 months. Alcoholics had a significantly lower cortisol level than did the normal controls from 60 min through to 150 min after administration of 30 mg buspirone. Our results show that cortisol response to buspirone was significantly decreased in alcoholic patients compared to normal controls, reflecting decreased 5-HT1A receptor sensitivity.

Adult↗