PubMed Health⌕ Search

Biomedical subjects

Yu A Uspenskii

Publications and source records attributed to Yu A Uspenskii.

3 recordsLinked to original sources

Terbium-based extreme ultraviolet multilayers.

We have fabricated periodic multilayers that comprise either Si/Tb or SiC/Tb bilayers, designed to operate as narrowband reflective coatings near 60 nm wavelength in the extreme ultraviolet (EUV). We find peak reflectance values in excess of 20% near normal incidence. The spectral bandpass of the best Si/Tb multilayer was measured to be 6.5 nm full width at half-maximum (FWHM), while SiC/Tb multilayers have a more broad response, of order 9.4 nm FWHM. Transmission electron microscopy analysis of Si/Tb multilayers reveals polycrystalline Tb layers, amorphous Si layers, and relatively large asymmetric amorphous interlayers. Thermal annealing experiments indicate excellent stability to 100 degrees C (1 h) for Si/Tb. These new multilayer coatings have the potential for use in normal incidence instrumentation in a region of the EUV where efficient narrowband multilayers have not been available until now. In particular, reflective Si/Tb multilayers can be used for solar physics applications where the coatings can be tuned to important emission lines such as O V near 63.0 nm and Mg X near 61.0 nm.

Journal Article↗

Efficient method for the determination of extreme-ultraviolet optical constants in reactive materials: application to scandium and titanium.

The chemical reaction of a sample with atmospheric gases causes a significant error in the determinantion of the complex refractive index n = 1 - delta + ibeta in the extreme-ultraviolet region. The protection of samples removes this effect but hampers the interpretation of measurements. To overcome this difficulty, we derive the exact dependences on film thickness of the reflectivity and transmissivity of a protected film. These dependences greatly simplify the determination of delta and beta when the spectra of several films with different thickness and identical protection are measured. They also allow the verification of the delta(omega) obtained from the Kramers-Kronig relation and even make the Kramers-Kronig method unnecessary in many cases. As a practical application, the optical constants of Sc and Ti are determined at h omega = 18-70 eV and 18-99 eV, respectively. The essential feature of our experimental technique is deposition of a film sample directly on a silicon photodiode that allows easy operation with both thin (approximately 10-nm) and thick (approximately 100-nm) films. The comparison of calculated reflectivities of Si-Sc multilayers with the measured values shows the high accuracy of the determined delta(omega) and beta(omega).

Journal Article↗

Skylab 3600 groove/mm replica grating with a scandium-silicon multilayer coating and high normal-incidence efficiency at 38-nm wavelength.

A Sc-Si multilayer coating was applied to a replica of the 3600 groove/mm grating, developed for the SO82A spectroheliograph that flew on the Skylab mission, for the purpose of enhancing the normal-incidence efficiency in the extreme-ultraviolet region. The efficiency, measured at an angle of incidence of 6 degrees with synchrotron radiation, had a maximum value of 7.2% at a wavelength of 38 nm and was a factor of 3 higher than the efficiency of the gold-coated Skylab grating. The measured efficiency of the Sc-Si grating was in good agreement with the efficiency calculated by use of the modified integral method.

Journal Article↗