PubMed Health⌕ Search

Biomedical subjects

Yuan-Di Zhao

Publications and source records attributed to Yuan-Di Zhao.

10 recordsLinked to original sources

Optimization of the methods for introduction of amine groups onto the silica nanoparticle surface.

The luminescent silica nanoparticle has attracted the researchers' concentration in bioanalysis recently. Its extensive application is based on the immobilization of various biomolecules such as deoxyribonucleic acid, antibody, and so forth onto the surface. By comparing different introduction methods of amine groups, it was confirmed that the "two-step" route is more preferable by adding tetraethyl orthosilicate and 3-aminopropyl-(triethoxyl)silane in sequence, to attain ideal amine-modified silica nanoparticles. On this basis, carboxyl groups were derived from amine groups on the nanoparticle surface and then were activated by 1-ethyl-3-3-(3-dimethylaminopropyl) carbodiimide hydrochloride and N-hydroxy-succinimide. Finally, mouse monoclonal antihuman CD71 antibody (McAb CD71) and transferrin were effectively linked with the carboxyl groups and successfully labeled the receptors in the membrane of fibroblast cells, respectively.

Amines↗

Preparation of Au coated polystyrene beads and their application in an immunoassay.

A novel immunoassay method based on polystyrene beads coated with Au nanoparticles (Au@PS) is described. Au nanoparticles were prepared by reductive reaction, and then deposited on the surface of polystyrene beads to form Au coatings. Results indicated that the Au coatings had good stability and that human IgG was immobilized at a concentration of 16 microg/g Au@PS. FITC-labeled rabbit-anti-human IgG and FITC-labeled rabbit-anti-goat IgG were employed to react with the human IgG on Au@PS. Fluorescence imaging results showed that the reaction had good immuno-specificity. In addition, further experiments at the single-bead level indicated that the linear range was 0.05-15 microg/ml, and that the FITC signal could be detected even when the target antibody concentration was as low as 0.01 microg/ml. The assay results were compared with an enzyme-linked immunosorbent assay (ELISA), and showed relatively good reliability.

Animals↗

Characterization of the coupling of quantum dots and immunoglobulin antibodies.

Water-soluble quantum dots (QDs) were used to label goat anti-human immunoglobulin antibodies (Abs), and the labeling process was characterized by column purification. The QDs obtained in organic solvent were modified with mercaptoacetic acid (MAA) and became water-soluble. These water-soluble QDs were linked to the antibodies using the coupling reagents ethyl-3-(dimethyl aminopropyl) carbodiimide (EDC) and N-hydroxysuccinimide (NHS). The linking process was shown to be effective by ultra-filter centrifugation and column purification. After comparing the quantities of Abs and water-soluble QDs involved in the linking reaction via column purification, it was found that a molar Abs:QD ratio of >1.2 resulted in most of the water-soluble QDs becoming covalently linked to the Abs. The circular dichroism (CD) spectra of Abs and QD-Ab conjugates were very similar to each other, indicating that the secondary structure of Abs remained largely intact after the conjugation. Finally, antigen (Ag)-antibody (Ab) recognition reactions perfomed on the surface of a glass slide showed that the conjugate retained the activity of Abs. This work lends support to the idea of linking biomolecules to QDs, and thus should aid the application of QDs to the life sciences.

Humans↗

Preparation of silica encapsulated quantum dot encoded beads for multiplex assay and its properties.

Novel -COOH modified polystyrene beads were prepared by sulfonation grafting, and the surface area and pore volume are greatly improved in comparison with the swelling-treated beads. The optimization coating time is 4 h, and the corresponding -COOH content is approximately 2.1 mmol/g. The scanning electron microscope results show that the silica particles deposited on the beads and formed a silica shell that decreases the leakage of quantum dots (QDs) preferably and improves the bar code stability greatly. The anti-photobleaching of silica-coated beads was studied systemically, and the results show that the half-decay time (t1/2) of the coated beads increases to 537 s--seven times longer than that of the uncoated ones. Further DNA probe hybridization experiments indicated that the coding signal and target signal can be detected simultaneously and that the assays based on these probe-conjugated silica/QD/polystyrene beads have good specificity and sensitivity that can detect a concentration as low as 0.01 microg/ml target DNA in denatured calf thymus DNA solution, indicating that it is feasible to use this kind of bead for multiplex analysis.

DNA↗

Continuous wave-based multiphoton excitation fluorescence for capillary electrophoresis.

It was reported that a novel detection method, continuous wave (CW)-based multiphoton excitation (MPE) fluorescence detection with diode laser (DL), has been firstly proposed for capillary electrophoresis (CE). Special design of end-column detection configuration proved to be superior to on-column type, considering the detection sensitivity. Three different kinds of fluorescent tags that were widely used as molecular label in bio-analysis, such as small-molecule dye, fluorescent protein and nano particle or also referred to as quantum dot (QD), have been evaluated as samples for the constructed detection scheme. Quantitative analyses were also performed using rhodamine species as tests, which revealed dynamic linear range over two orders of magnitude, with detection limit down to zeptomole-level. Simultaneous detection of fluorescent dyestuffs with divergent excitation and emission wavelengths in a broad range showed advantage of this scheme over conventional laser-induced fluorescence (LIF) detection. Further investigations on CW-MPE fluorescence detection with diode laser for capillary zone electrophoresis (CZE) and micellar electrokinetic chromatography (MEKC) separations of fluorescein isothiocyanate (FITC) labeled amino acids indicated good prospect of this detection approach in various micro or nano-column liquid phase separation technologies.

Electrophoresis, Capillary↗

Interactions of cytochrome c with DNA at glassy carbon surface.

Cyclic voltammetry (CV) was used to investigate the interactions of Cytochrome c (Cyt c) with deoxyribonucleic acid (DNA) at glassy carbon (GC) electrodes. The results indicate that there are strong interactions between Cyt c and DNA. The binding constant (k(A)) and binding free energy (Delta(r)G) of Cyt c with dsDNA are (1.69+/-0.38) x 10(5) L.mol(-1) and -(29.76+/-0.56) kJ.mol(-1), respectively; and those of Cyt c with ssDNA are (3.35+/-0.50) x 10(5) L.mol(-1) and -(31.49+/-0.37) kJ.mol(-1), respectively. The binding sites are achieved to be 3.3 bp per Cyt c molecule with dsDNA and 4.0 nucleotides (ssDNA) binding one Cyt c molecule. This experiment affords a valid method for investigating the interactions between DNA and proteins by electrochemical techniques.

Animals↗

The interface behavior and biocatalytic activity of superoxide dismutase at carbon nanotube.

The interface behavior and biocatalytic activity of superoxide dismutase (SOD) were studied at carbon nanotube (CNT) surface with cyclic voltammetry (CV). The results show that SOD participates in a rapid exchange with CNT and the process is a single-electron-single-proton process. The electron-transfer coefficient was calculated to be 0.52, the electron-transfer rate constant was 1.4s(-1) and the average surface coverage was measured to be 6.93 x 10(-11)+/-4.2 x 10(-12) mol cm(-2). The bioactive measurements show that SOD keeps its bioactivity at the CNT surface. SOD's remarkable ability to catalyze the dismutation of the superoxide anion (O (2)(-)) has been demonstrated.

Biosensing Techniques↗

Vibrational spectroscopic encoding of polystyrene-based resin beads: converting the encoding peaks into barcodes.

A detailed approach is described for the vibrational spectroscopic encoding of polystyrene-based resin beads by converting the infrared absorption peaks suitable for encoding (encoding peaks) into barcodes. Based on combining the FT-IR measurements and the quantum-chemical computations, the vibrational characteristics of p-tert-butylstyrene monomer, polystyrene and poly(p-tert-butylstyrene) resin beads are analyzed, which are helpful for the selection of encoding peaks. The vibrational spectroscopic encoding of polystyrene-based resin beads could be obtained by converting the wavenumber, intensity and full width at half maximum (FWHM) of the encoding peaks into barcodes automatically through a computer program designed in our laboratory.

Electronic Data Processing↗

Quantum dot optical encoded polystyrene beads for DNA detection.

A novel multiplex analysis technology based on quantum dot (QD) optical encoded beads was studied. Carboxyl functionalized polystyrene beads, about 100 microm in size, were precisely encoded by the various ratios of two types of QDs whose emission wavelengths are 576 and 628 nm, respectively. Then the different encoded beads were covalently immobilized with different probes in the existing of sulfo-NHS and 1-[3-(Dimethylamino) propyl]-3-ethylcarbodiimide methiodide, and the probe density could reach to 3.1 mmol/g. These probe-linked encoded beads were used to detect the target DNA sequences in complex DNA solution by hybridization. Hybridization was visualized using fluorescein isothiocynate-labeled DNA sequences. The results show that the QDs and target signals can be obviously identified from a single-bead-level spectrum. This technology can detect DNA targets effectively with a detection limit of 0.2 microg/mL in complex solution.

Base Sequence↗