Biomedical subjects

Yung-Cheng Chang

Publications and source records attributed to Yung-Cheng Chang.

5 recordsLinked to original sources

PubMed2006

10 Gbit/s all-optical non-return to zero-return-to-zero data format conversion based on a backward dark-optical-comb injected semiconductor optical amplifier.

By using a semiconductor optical amplifier backward injected by a dark-optical-comb pulse train at 10 GHz, we demonstrate a 10 Gbit/s all-optical nonreturn-to-zero (NRZ) to return-to-zero (RZ) format conversion of an incoming optical pseudorandom binary sequence (PRBS) data stream. Both the polarity and the wavelength of data are conserved during format conversion. Without any pre-amplification, the extinction ratio of degraded optical NRZ PRBS data is greatly improved from 7.13 to 13.6 dB after NRZ-to-RZ conversion. An ultralow bit-error rate of 10(-12) at a data rate as high as 10 Gbits/s is obtained with a received optical power of -18.3 dBm. The converted RZ PRBS data exhibit a negative power penalty of >3.7 dB compared with the NRZ PRBS data at a bit-error rate of 10(-12).

Journal Article↗

PubMed2005

Injection-locking laser-diode-based OC-192 optical non-return-to-zero-to-return-to-zero OR logic gate.

An OC-192 optical return-to-zero- (RZ-) formatted OR logic gate is experimentally demonstrated and theoretically interpreted for the first time to our knowledge. It is implemented by using a data format converter based on an optically injection-locked Fabry-Perot laser diode (FPLD) modulated in below-threshold condition. By injecting two non-return-to-zero data streams into the FPLD-based OR gate, a peak-power-equalized RZ-formatted OR logic data stream extinction ratio of >8 dB is obtained from the FPLD with optimized rf-modulating and optical injecting powers of 24.7 and >-4 dBm, respectively. The highest data rate of up to 12.5 Gbits/s with a bit error rate (BER) of 10(-13) at a received optical power of >-16 dBm can be achieved by increasing the dc bias current of the FPLD-based RZ-formatted OR logic gate to 8 mA. The OR-gated RZ data stream exhibits a duty cycle (pulse width) of approximately 27% (27 ps) and a 0.5 dB power penalty at a BER of 10(-9) at a data rate of 9.953 Gbits/s.

Journal Article↗

PubMed2005

Suppression of phase and supermode noise in a harmonic mode-locked erbium-doped fiber laser with a semiconductor-optical-amplifier-based high-pass filter.

By operating an intracavity semiconductor-optical-amplifier- (SOA-) based high-pass filter at the nearly transparent current condition, the supermode noise (SMN), the relaxation oscillation, and the single-sideband (SSB) phase noise can be simultaneously suppressed in an actively mode-locked erbium-doped fiber laser (EDFL). The SOA at the nearly transparent condition enhances the SMN suppression ratio of the EDFL from 32 to 76 dB at the cost of the phase noise degrading from -114 to -104.2 dBc/Hz and broadening the pulse width from 36 to 61 ps. With an optical bandpass filter, the SSB phase noise and the SMN suppression ratio can be further improved to -110 dBc/Hz and 81 dB, respectively. The EDFL pulse can be further shortened to 3.1 ps with a time-bandwidth product of 0.63 after compression.

Journal Article↗

PubMed2005

10 Gbit/s tunable dual-wavelength nonreturn-to-zero-to-return-to-zero data-format transformer based on a non-direct-current-biased fabry-perot laser diode.

We demonstrate the conversion of a nonreturn-to-zero (NRZ)-formatted electrical data stream into a wavelength-tunable return-to-zero (RZ)-formatted optical pulse code by externally seeding a synchronously sinusoidal-modulated Fabry-Perot laser diode (FPLD) with optical pseudorandom binary-sequence data at 10 Gbits/s (Gbps). The FPLD without a dc-biased current was modulated by use of a power-amplified sinusoidal wave signal (approximately 25.6 dBm) as an NRZ-to-RZ data-format transformer, which is regeneratively amplified by a closed-loop erbium-doped fiber amplifier. The gain switching and on-off keying operation of the FPLD is initiated under the seeding of self-feedback and external-injection signals. A maximum wavelength tuning range of 30 nm with a side-mode suppression ratio of greater than 36 dB is obtained. The power penalty of the NRZ-to-RZ data-format conversion at 10 Gbps is 1.5 dB.

Journal Article↗

PubMed2003

Piezoelectric-transducer-based optoelectronic frequency synchronizer for control of pulse delay in a femtosecond passively mode-locked Ti:sapphire laser.

We propose a piezoelectric transducer-(PZT-) based optoelectronic frequency synchronizer to control simultaneously change in the repetition rate, the relative pulse delay, and the phase noise of a passively mode-locked femtosecond Ti:sapphire laser with an intracavity saturable Bragg reflector absorber with respect to an electronic frequency reference. An optoelectronic phase-locked-loop-based PZT feedback controller with a proportional, integral, and differential (PID) circuit and a tunable voltage regulator is designed to achieve frequency synchronization, phase-noise suppression, and delay-time tuning. When the controlling voltage is tuned from -2.6 to 2.6 V, the maximum pulse-delay range, tuning slope, and tuning resolution of the laser pulse-train are 11.3 ns, 2.3 ps/mV, and 1.2 ps, respectively. Setting the gain constant of the PID circuit at 10 or larger causes the delay-time tuning function to be linearly proportional to the controlling voltage. In the delay-time tuning mode the uncorrelated single-side-band phase-noise density of the frequency-synchronized laser is approximately -120 dBc/Hz at an offset frequency of 5 kHz, which is only 7 dBc/Hz higher than that of the electrical frequency reference. The proposed system also supports linear,continuous switching,and programmable control of the delay time of Ti:sapphire laser pulses when they are frequency synchronized to external reference clocks.

Journal Article↗