Biomedical subjects

Yuri Alexeev

Publications and source records attributed to Yuri Alexeev.

5 recordsLinked to original sources

PubMed2006

Ab initio and analytic intermolecular potentials for Ar-CH(3)OH.

Ab initio calculations at the CCSD(T)/aug-cc-pVTZ level of theory were used to characterize the Ar-CH(3)OH intermolecular potential energy surface (PES). Potential energy curves were calculated for four different Ar + CH(3)OH orientations and used to derive an analytic function for the intermolecular PES. A sum of Ar-C, Ar-O, Ar-H(C), and Ar-H(O) two-body potentials gives an excellent fit to these potential energy curves up to 100 kcal mol(-1), and adding an additional r(-n) term to the Buckingham two-body potential results in only a minor improvement in the fit. Three Ar-CH(3)OH van der Waals minima were found from the CCSD(T)/aug-cc-pVTZ//MP2/aug-cc-pVTZ calculations. The structure of the global minimum is in overall good agreement with experiment (X.-C. Tan, L. Sun and R. L. Kuczkowski, J. Mol. Spectrosc., 1995, 171, 248). It is T-shaped with the hydroxyl H-atom syn with respect to Ar. Extrapolated to the complete basis set (CBS) limit, the global minimum has a well depth of 0.72 kcal mol(-1) with basis set superposition error (BSSE) correction. The aug-cc-pVTZ basis set gives a well depth only 0.10 kcal mol(-1) smaller than this value. The well depths of the other two minima are within 0.16 kcal mol(-1) of the global minimum. The analytic Ar-CH(3)OH intermolecular potential also identifies these three minima as the only van der Waals minima and the structures predicted by the analytic potential are similar to the ab initio structures. The analytic potential identifies the same global minimum and the predicted well depths for the minima are within 0.05 kcal mol(-1) of the ab initio values. Combining this Ar-CH(3)OH intermolecular potential with a potential for a OH-terminated alkylthiolate self-assembled monolayer surface (i.e., HO-SAM) provides a potential to model Ar + HO-SAM collisions.

Argon↗

PubMed2006

Ab initio and analytic intermolecular potentials for Ar-CF4.

Ab initio calculations at the CCSD(T) level of theory were performed to characterize the Ar + CF4 intermolecular potential. Potential energy curves were calculated with the aug-cc-pVTZ basis set, and with and without a correction for basis set superposition error (BSSE). Additional calculations were performed with other correlation consistent basis sets to extrapolate the Ar-CF4 potential energy minimum to the complete basis set (CBS) limit. Both the size of the basis set and BSSE have substantial effects on the Ar + CF4 potential. Calculations with the aug-cc-pVTZ basis set, and with a BSSE correction, appear to give a good representation of the BSSE corrected potential at the CBS limit. In addition, MP2 theory is found to give potential energies in very good agreement with those determined by the much higher level CCSD(T) theory. Two model analytic potential energy functions were determined for Ar + CF4. One is a fit to the aug-cc-pVTZ calculations with a BSSE correction. The second was derived by fitting an average BSSE corrected potential, which is an average of the CCSD(T)/aug-cc-pVTZ potentials with and without a BSSE correction. These analytic functions are written as a sum of two-body potentials and excellent fits to the ab initio potentials are obtained by representing each two-body interaction as a Buckingham potential.

Journal Article↗

PubMed2006

Thermochemical properties of HxNO molecules and ions from ab initio electronic structure theory.

Coupled-cluster calculations through noniterative triple excitations were used to compute optimized structures, atomization energies at 0 K, and heats of formation at 0 and 298 K for NH2O, HNOH, NH2O-, NH2OH+, NH3OH+, HNO-, and HON. These molecules are important in the gas-phase oxidation of NH3, as well as its solution-phase chemistry. The O-H, N-H, and N-O bond energies of these molecules are given and compared. The N-H and O-H bond energies are quite low, and, for NH2OH, the O-H bond is weaker than the N-H bond (by 7.5 kcal/mol). The energetics for a variety of ionic chemical processes in the gas phase, including the electron affinities of NH2O and HNO, the proton affinities of NH2O and NH2OH, and the acidities of NH2OH and NH2O, are given. The compounds are weak bases and weak acids in the gas phase. Solvation effects were included at the PCM and COSMO levels. The COSMO model gave better values than the PCM model. The relative values for pKa for NH2O and NH2OH are in good agreement with the experimental values, showing both compounds to be very strong bases in aqueous solution with NH2OH being the stronger base by 1.8 pK units at the COSMO level, compared to the experimental pK difference of 1.1+/-0.3 pK units. We predict that NH2OH+ will not be formed in aqueous solution, because it is a very strong acid. Based on the known acidity of NH3OH+, we predict pKa(NH2OH+)=-5.4 at the COSMO level, which is in good agreement with the experimental estimate of pKa(NH2OH+)=-7+/-2.

Journal Article↗

PubMed2005

Effect of the Ar-Ni(s) potential on the cross section for Ar+CH4/Ni{111} collision-induced desorption and the need for a more accurate CH4/Ni{111} potential.

In a previous paper [L. Sun, P. de Sainte Claire, O. Meroueh, and W. L Hase, J. Chem. Phys. 114, 535 (2001)], a classical trajectory simulation was reported of CH(4) desorption from Ni{111} by Ar-atom collisions. At an incident angle theta(i) of 60 degrees (with respect to the surface normal), the calculated collision-induced desorption (CID) cross sections are in excellent agreement with experiment. However, for smaller incident angles the calculated cross sections are larger than the experimental values and for normal collisions, theta(i)=0 degrees , the calculated cross sections are approximately a factor of 2 larger. This trajectory study used an analytic function for the Ar+Ni(s) intermolecular potential which gives an Ar-Ni{111} potential energy minimum which is an order of magnitude too deep. In the work reported here, the previous trajectory study is repeated with an Ar+Ni(s) analytic intermolecular potential which gives an accurate Ar-Ni{111} potential energy minimum and also has a different surface corrugation than the previous potential. Though there are significant differences between the two Ar+Ni(s) analytic potentials, they have no important effects on the CID dynamics and the cross sections reported here are nearly identical to the previous values. Zero-point energy motions of the surface and the CH(4)-Ni(s) intermolecular modes are considered in the simulation and they are found to have a negligible effect on the CID cross sections. Calculations of the intermolecular potential between CH(4) and a Ni atom, at various levels of theory, suggest that there are substantial approximations in the ab initio calculation used to develop the CH(4)+Ni{111} potential. The implication is that the differences between the trajectory and experimental CID cross sections may arise from an inaccurate CH(4)+Ni{111} potential used in the trajectory simulation.

Journal Article↗

PubMed2004

Component-based integration of chemistry and optimization software.

Typical scientific software designs make rigid assumptions regarding programming language and data structures, frustrating software interoperability and scientific collaboration. Component-based software engineering is an emerging approach to managing the increasing complexity of scientific software. Component technology facilitates code interoperability and reuse. Through the adoption of methodology and tools developed by the Common Component Architecture Forum, we have developed a component architecture for molecular structure optimization. Using the NWChem and Massively Parallel Quantum Chemistry packages, we have produced chemistry components that provide capacity for energy and energy derivative evaluation. We have constructed geometry optimization applications by integrating the Toolkit for Advanced Optimization, Portable Extensible Toolkit for Scientific Computation, and Global Arrays packages, which provide optimization and linear algebra capabilities. We present a brief overview of the component development process and a description of abstract interfaces for chemical optimizations. The components conforming to these abstract interfaces allow the construction of applications using different chemistry and mathematics packages interchangeably. Initial numerical results for the component software demonstrate good performance, and highlight potential research enabled by this platform.

Journal Article↗