Biomedical subjects

Zhong-Sheng Wang

Publications and source records attributed to Zhong-Sheng Wang.

8 recordsLinked to original sources

PubMed2006

Alkyl-functionalized organic dyes for efficient molecular photovoltaics.

We designed and synthesized new alkyl-functionalized organic dyes, MK-1 and MK-2, for dye-sensitized solar cells (DSSCs). Based on the MK-2 dye, a high performance of efficiency (eta, 7.7%; short-circuit current density Jsc = 14.0 mA cm-2, open-circuit voltage Voc = 0.74 V, and fill factor FF = 0.74) was achieved under AM 1.5 G irradiation (100 mW cm-2). Remarkably, the relatively higher Voc for DSSCs based on MK-1 and MK-2 dyes, which have long alkyl chains, were observed among the organic dyes caused by the increasing of the electron lifetime in the conduction band of TiO2. Our molecular design of alkyl-functionalized dyes strongly suggests the promising performance of molecular photovoltaics based on organic dyes.

Journal Article↗

PubMed2006

N3-sensitized TiO2 films: in situ proton exchange toward open-circuit photovoltage enhancement.

Protons of N3, cis-bis(thiocyanato)bis(2,2'-bipyridyl-4,4'-dicarboxylic acid)ruthenium(II), were in situ exchanged on N3-loaded TiO2 films with alkali-metal, tetrabutylammonium, and guanidinium cations. This simple strategy improved the open-circuit photovoltage (V(oc)) significantly, resulting in enhancement of the power conversion efficiency by 10-25%. Electrochemical impedance spectra revealed that the in situ proton exchange of the N3-loaded film suppressed charge recombination between injected electrons and I(3-) ions in the electrolyte, which, together with the negative shift of the conduction band edge for TiO2, may account for the remarkably increased V(oc) upon proton exchange of N3.

Journal Article↗

PubMed2005

Efficient eosin y dye-sensitized solar cell containing Br-/Br3- electrolyte.

We found that Br-/Br3- is more suitable than an I-/I3- couple in dye-sensitized solar cells in terms of higher open-circuit photovoltage (Voc) production and higher overall energy conversion efficiency (eta) if the dye sensitizer has a more positive potential than that of Br-/Br3-. Under simulated AM1.5 one sun, an eosin Y dye-sensitized solar cell containing 0.4 M LiBr + 0.04 M Br2 electrolyte in acetonitrile yielded a short-circuit photocurrent (Jsc) of 4.63 mA cm(-2), Voc of 0.813 V, and fill factor (FF) of 0.693, corresponding to 2.61% of eta. Under the same conditions except for the electrolyte 0.4 M LiI + 0.04 M I2 in acetonitrile instead, the device produced 1.67% of eta (Jsc = 5.15 mA cm(-2), Voc = 0.451 V, FF = 0.721). Replacement of I-/I3- with Br-/Br3- in eosin Y dye-sensitized solar cells yielded a significant increase in Voc offset by slight decreases in Jsc and FF, leading to an increase in eta by 56%. The significant gain in Voc was attributed to the enlarged energy level difference between the redox potential of the electrolyte and the Fermi level of TiO2 and the suppressed charge recombination as well. The rate for charge recombination between bromine and the injected electrons was determined to be first order in bromine.

Journal Article↗

PubMed2005

Oligothiophene-containing coumarin dyes for efficient dye-sensitized solar cells.

We have developed oligothiophene-containing coumarin dyes fully functionalized for dye-sensitized nanocrystalline TiO(2) solar cells (DSSCs). DSSCs based on the dyes gave good performance in terms of incident photon-to-current conversion efficiency (IPCE) in the range of 400-800 nm. A solar energy-to-electricity conversion efficiency (eta) of 7.4% was obtained with a DSSC based on 2-cyano-3-[5'-(1,1,6,6-tetramethyl-10-oxo-2,3,5,6-tetrahydro-1H,4H,10H-11-oxa-3a-aza-benzo[de]anthracen-9-yl)-[2,2']bithiophenyl-5-yl]acrylic acid (NKX-2677) under simulated AM 1.5G irradiation (100 mW cm(-2)) with a mask: short-circuit current density (J(sc)) = 13.5 mA cm(-2); open-circuit voltage (V(oc)) = 0.71 V; fill factor (FF) = 0.77. Transient absorption spectroscopy measurements indicated that electron injection from NKX-2677 to the conduction band of TiO(2) is very rapid (<100 fs), which is much faster than the emission lifetime of the dye (1.0 ns), giving a highly efficient electron injection yield of near unity.

Journal Article↗

PubMed2005

Significant efficiency improvement of the black dye-sensitized solar cell through protonation of TiO2 films.

This paper describes the influence of acid pretreatment ofTiO2 mesoporous films prior to dye sensitization on the performance of dye-sensitized solar cells based on [(C4H9)4N]3[Ru(Htcterpy)(NCS)3] (tcterpy = 4,4',4"-tricarboxy- 2,2',2"-terpyridine), the so-called black dye. The HCl pretreatment caused an increase in overall efficiency by 8%, with a major contribution from photocurrent improvement. It is speculated, from the analysis of incident photon-to-electron conversion efficiency, UV-vis absorption spectra, redox properties of the dye and TiO2, and the impedance spectra of the dye-sensitized solar cells, that photocurrent enhancement is attributed to the increases in electron injection and/or charge collection efficiency besides the improvement of light harvesting efficiency upon HCl pretreatment. Open-circuit photovoltage (V(oc)) remained almost unchanged in the case of significant positive shift of flat band potential for TiO2 upon HCl pretreatment. The suppression of electron transfer from conduction band electrons to the I3- ions in the electrolyte upon HCl pretreatment, reflected by the increased resistance at the TiO2/dye/electrolyte interface and reduced dark current, resulted in a V(oc) gain, which compensated the V(oc) loss due to the positive shift of the flat band. Using the HCl pretreatment approach, 10.5% of overall efficiency with the black dye was obtained under illumination of simulated AM 1.5 solar light (100 mW cm(-2)) using an antireflection film on the cell surface.

Letter↗

PubMed2005

Photophysical and (photo)electrochemical properties of a coumarin dye.

A new coumarin dye, cyano-{5,5-dimethyl-3-[2-(1,1,6,6-tetramethyl-10-oxo-2,3,5,6-tetrahydro-1H,4H,10H-11-oxa-3a-aza-benzo[de]anthracen-9-yl)vinyl]cyclohex-2-enylidene}-acetic acid (NKX-2753), was prepared and characterized with respect to photophysical and electrochemical properties. It was employed as a dye sensitizer in dye-sensitized solar cells and showed efficient photon-to-electron conversion properties. The photocurrent action spectrum exhibited a broad feature with a maximum incident photon-to-electron conversion efficiency (IPCE) of 84% at 540 nm, which is comparable to that for the famous red dye RuL2(NCS)2 (known as N3), where L stands for 2,2'-bipyridyl-4,4'-dicarboxylic acid. The sandwich-type solar cell with NKX-2753, under illumination of full sun (AM1.5, 100 mW cm(-2)), produced 16.1 mA cm(-2) of short-circuit photocurrent, 0.60 V of open-circuit photovoltage, and 0.69 of fill factor, corresponding to 6.7% of overall energy conversion efficiency using 0.1 M LiI, 0.05 M I2, 0.1 M guanidinium thiocyanate, and 0.6 M 1,2-dimethyl-3-n-propyl-imidazolium iodide in dry acetonitrile as redox electrolyte. In comparison with its analogue NKX-2586 (Langmuir 2004, 20, 4205), NKX-2753 with an extra side ring on the alkene chain produced much higher IPCE values at the same conditions. The side ring acted as a spacer to efficiently prevent dye aggregation when adsorbed on the TiO2 surface, resulting in significant improvements of short-circuit photocurrent, open-circuit photovoltage, and fill factor compared with NKX-2586 that aggregated on the TiO2 surface.

Coloring Agents↗

PubMed2004

Genetic structure of the endangered plant Neolitsea sericea (Lauraceae) from the Zhoushan archipelago using RAPD markers.

BACKGROUND AND AIMS: The Zhoushan archipelago is the largest archipelago in China. It separated from the mainland about 9000 years ago due to rising sea levels and climate change. Because of the long-term influences of human activities, the original forest vegetation on the large islands has been badly damaged and its plant diversity reduced. METHODS: Levels and patterns of genetic diversity in 114 individuals from six natural populations and four cultivated populations of the insular endangered plant Neolitsea sericea (Lauraceae) on the Zhoushan archipelago were assessed using random amplified polymorphic DNA (RAPD) markers. KEY RESULTS: A total of 99 discernible loci were obtained for all populations using ten primers, 50.5 % of which were polymorphic [percentage of polymorphic bands (PPB)=50.5 %]. Despite being a woody, long-lived, perennial, outcrossing and insect-pollinated plant, N. sericea exhibited low levels of genetic variation. The cultivated populations (PPB=18.9 %, HE=0.060, S=0.092) were genetically less diverse than the natural populations (PPB=23.1 %, HE=0.082, S=0.123). Based on analysis of molecular variance, a high degree of among-population differentiation was revealed for both natural (0.387) and cultivated populations (0.598). CONCLUSIONS: Removal of plants from the wild for horticulture purposes has eroded the level of genetic variation of N. sericea. Low levels of genetic diversity and a high degree of population differentiation indicate that management strategies should include conservation of natural habitats occupied by all six wild populations, and sampling of germplasm resources from multiple seed sources.

China↗

PubMed2003

[Gene prediction and function research of SARS-CoV(BJ01)].

Through reading the articles, this study points out the shortage of gene prediction and function research about SARS-CoV, and predict it again for developing effective drugs and future vaccines. Using twelve gene prediction methods to predict coronavirus known genes, we select four better methods including Heuristic models, Gene Identification, ZCURVE_CoV and ORF FINDER to predict SARS-CoV(BJ01), and use ATGpr for analyzing probability of initiation codon and Kozak rule, search transcription regulating sequence(TRS) in order to improve the accuracy of predicted genes. Twenty-one probable new genes with more than 50 amino acids have been obtained excluding 13 ORFs which are similar to the genes of NCBI and relative articles. For predicted proteins, we use ProtParam to analyse physical and chemical features; SignalP to analyse signal peptide; BLAST, FASTA to search similar sequences; TMPred, TMHMM, PFAM and HMMTOP to analyse domain and motif in order to improve reliability of gene function prediction. At the same time, we separate the 21 ORFs into four classes using codition of four gene prediction methods, match score, match expection and match length between predicted gene and Coronavirus known gene. In the end, we discuss the results and analyse the reasons.

Computational Biology↗