Biomedical subjects

Zhong-Xian Guo

Publications and source records attributed to Zhong-Xian Guo.

5 recordsLinked to original sources

PubMed2005

Determination of glyphosate and phosphate in water by ion chromatography--inductively coupled plasma mass spectrometry detection.

Quantitative determination of trace glyphosate and phosphate in waters was achieved by coupling ion chromatography (IC) separation with inductively coupled plasma mass spectrometry (ICP-MS) detection. The separation of glyphosate and phosphate on a polymer anion-exchange column (Dionex IonPac AS16, 4.0 mm x 250 mm) was obtained by eluting them with 20 mM citric acid at 0.50 mL min(-1), and the analytes were detected directly and selectively by ICP-MS at m/z = 31. Parameters affecting their chromatographic behaviors and ICP-MS characteristics were systematically examined. Based on a 500-microL sample injection volume, the detection limits were 0.7 microgL(-1) for both glyphosate and phosphate, and the calibrations were linear up to 400 microgL(-1). Polyphosphates, aminomethylphosphonic acid (the major metabolite of glyphosate), non-polar and other polar phosphorus-containing pesticides showed different chromatographic behaviors from the analytes of interest and therefore did not interference. The determination was also interference free from the matrix anions (nitrate, nitrite, sulphate, chloride, etc.) and metallic ions. The analysis of certified reference material, drinking water, reservoir water and Newater yielded satisfactory results with spiked recoveries of 97.1-107.0% and relative standard deviations of < or = 7.4% (n = 3). Compared to other reported methods for glyphosate and phosphate, the developed IC-ICP-MS method is sensitive and simple, and does not require any chemical derivatization, sample preconcentration and mobile phase conductivity suppression.

Chromatography, Ion Exchange↗

PubMed2003

Bromate assay in water by inductively coupled plasma mass spectrometry combined with solid-phase extraction cartridges.

Based on selective sorption of bromide, bromoacetic acids (BAA) and bromomethanes on solid-phase extraction (SPE) cartridges, a sensitive and convenient method was developed for the determination of bromate in waters by inductively coupled plasma mass spectrometry (ICP-MS). Dionex OnGuard Ag and reversed-phase (RP) cartridges were tested for retention characteristics for bromide, BAA and bromomethanes. When a sample acidified with nitric acid was passed through an RP cartridge, BAA and bromomethanes were retained, afterwards bromide was absorbed as a precipitate of silver bromide and bromate was unretained when the nearly neutral sample passed a combination of Ag and H cartridges. After SPE pretreatment the recovery of bromate was 96-106%, and bromide remaining in the aqueous phase was found to be less than 0.06 microg L(-1) when the original bromide concentrations were less than 5 mg L(-1). Effectiveness of stacked Ag and H cartridges in removing bromide from chloride-containing samples was also examined. Common cations and other anions did not interfere with bromate determination. The detection limit for bromate is 57 ng L(-1). This method has been applied to analyse waters from various sources, and the recovery of the spiked bromate was in the range of 92-107%.

Journal Article↗

PubMed2003

Speciation analysis of tellurium by solid-phase extraction in the presence of ammonium pyrrolidine dithiocarbamate and inductively coupled plasma mass spectrometry.

Under acidic conditions tellurium(IV) formed a complex with ammonium pyrrolidine dithiocarbamate (APDC). The tellurium(IV) complex was completely retained on a non-polar Isolute silica-based octadecyl (C(18)) sorbent-containing solid-phase extraction (SPE) cartridge, while the uncomplexed Te(VI) passed through the cartridge and remained as a free species in the solution. Only partial Te(IV) was retained on the SPE cartridge for samples without addition of APDC. On the basis of different retention behaviours of the complexed Te(IV) and uncomplexed Te(VI), a simple and highly sensitive method is proposed for the determination of total tellurium and Te(VI) by SPE separation and inductively coupled plasma mass spectrometry (ICP-MS) detection. The Te(IV) concentration was calculated as the difference between total tellurium and Te(VI) concentrations. The detection limit (3 sigma) is 3 ng L(-1) tellurium. Factors affecting the separation and detection of tellurium species were investigated. Coexisting ions did not show significant interferences with the Te(IV)-APDC complex retention and the subsequent ICP-MS detection of Te. The method has been successfully applied to the tellurium speciation analysis in waters with spiked recoveries for Te(IV) and Te(VI) of 86.0-108% and 87.1-97.4%, respectively.

Mass Spectrometry↗

PubMed2002

Flow injection determination of gaseous sulfur dioxide with gas permeation denuder-based online sampling and preconcentration.

A simple and novel flow injection method for the determination of gaseous SO(2) is described based on gas permeation denuder (GPD) online sampling and preconcentration. The GPD is easily prepared with poly(vinylidene) difluoride microporous membrane as gas permeable material and two Perspex blocks with smooth and flat interface and rectangular engraved channels of mirror image. The sample gas is on one side of the membrane and phosphate buffer of pH 7.0 as the absorbing solution is on the other side. Gaseous SO(2) permeates partially through the gas permeable membrane and dissolves in the absorbing solution. After preconcentration for 5.0 or 8.0 min, the solution is injected into the flow of 5.0 x 10(-4) mol L(-1) 5,5'-dithiobis(2,2'-dinitrobenzoic acid) (DTNB) in 0.025 mol L(-1) phosphate buffer. The resulting product formed between DTNB and absorbed SO(2) is spectrophotometrically monitored at 410 nm with a charge coupled device (CCD) fiber optic spectrometer. The calibration graphs for preconcentration of 5.0 and 8.0 min are linear up to 4.0 and 3.2 mg m(-3) with detection limits of 50 and 35 micro g m(-3), respectively. The corresponding analysis speeds are 8.5 and 6 samples h(-1). The method is selective and just suffer from interference of hydrogen sulfide at higher than 1% of SO(2) level (in m/V) with an error >+10%. The assay just uses cheap and common membrane and reagents and shows potential application in the monitoring of atmospheric SO(2).

Journal Article↗

PubMed2002

Antimony speciation by inductively coupled plasma mass spectrometry using solid phase extraction cartridges.

A novel and simple method for inorganic antimony speciation is described based on selective solid phase extraction (SPE) separation of antimony(III) and highly sensitive inductively coupled plasma mass spectrometric (ICP-MS) detection of total antimony and antimony(V) in the aqueous phase of the sample. Non-polar SPE cartridges, such as the Isolute silica-based octyl (C8) sorbent-containing cartridge, selectively retained the Sb(III) complex with ammonium pyrrolidine dithiocarbamate (APDC), while the uncomplexed Sb(V) remained as a free species in the solution and passed through the cartridge. The Sb(III) concentration was calculated as the difference between total antimony and Sb(V) concentrations. The detection limit was 1 ng L(-1) antimony. Factors affecting the separation and detection of antimony species were investigated. Acidification of samples led to partial or complete retention of Sb(V) on C8 cartridge. Foreign ions tending to complex with Sb(III) or APDC did not interfere with the retention behavior of the Sb(III)-APDC complex. This method has been successfully applied to antimony speciation of various types of water samples.

Antimony↗