PubMed · 10895708
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
M D Cooper. 1999. Keeping the sharper edge.. https://pubmed.ncbi.nlm.nih.gov/10895708/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
AIM: The aim of this study was to compare canal preparations completed with Hedstrom and K-files of ISO size 15 - 40, made of nickel-titanium (Ni-Ti) and stainless steel (SS). METHODOLOGY: Eighty simulated canals with 200 and 30 degrees C curvatures were prepared using the step-back technique and quarter turn/pull instrument manipulation. Middle and apical level canal sections were taken using computed tomography. RESULTS: No significant difference was found between any of the file types at either level with respect to canal curvature (20 degrees or 30 degrees). At the middle level, the stainless steel files caused more enlargement toward the inner part, compared to nickel-titanium files. At the apical level, nickel-titanium canal files caused more enlargement toward the inner part, whereas more outward enlargement was caused by stainless steel instruments. No significant difference could be observed at the middle level (P > 0.05) related to the enlargement toward the outer side of the canal curvature. Transportation at both levels was significantly less (P < 0.001) for the Ni-Ti files than the SS ones. Centring ratios of the file types at the middle level were low, but not significantly different (P > 0.05), whereas at the apical level the centring ratios were significantly higher for the Ni-Ti files (P < 0.001). CONCLUSIONS: Ni-Ti instruments produced preparations with adequate enlargement, less transportation, and a better centring ratio.
The laws of applied mechanics can be used to analyze and predict the behavior of mechanical parts subjected to strain and distortion, such as endodontic instruments. Simple mathematical formulas can be used to represent the impact of torsional and bending inertias on stresses in endodontic instruments being used in root canals. The boundary integral method was applied to two theoretical models with the same diameters but different cross-sections to evaluate quantitatively and qualitatively the stresses produced in orthogonal cross-sections. The results confirmed the mathematical deduction concerning the impact of torsional and bending stresses. The results indicate that clinical protocols based on the torsional and bending properties of endodontic instruments must be strictly followed, and endodontic instrument manufacturers must adopt standardized criteria for describing these properties.
The present work analyzes possible increases in resistance to wear of nickel-titanium endodontic instruments that have undergone a process of ionic implantation. ProFile .04 taper #25 instruments were subjected to ionic implantation with bands of nitrogen ions of 250 KeV, currents in the order of 10 microA/cm2, and doses of 2 x 10(17) ions/ cm2. The instruments were used to make preparations in acrylic endodontic training blocks. Scanning electron microscopic investigations showed that after 60 s of work inside the endodontic training blocks nonionic implanted control instruments showed small modifications in their blades, and their tips showed the first signs of wear. After 240 s the control instruments showed consistent signs of wear and frequent changes to their surfaces. After 240 s of use the ionic-implanted instruments did not present any significant changes in the micromorphology of their surfaces. The implanted instruments did not manifest the typical signs of wear and did not show the surface changes that quickly affect the working life of untreated endodontic instruments manufactured from nickel-titanium.