PubMed · 11296536
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
L Montano, R Vece. [Physicians and incinerators].. https://pubmed.ncbi.nlm.nih.gov/11296536/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
A laboratory-scale gas-solid fluidized bed separator able to separate fractions of 5.6-50mm was used for separation of shredded municipal bulky waste (SBW) into combustibles and incombustibles. In batch-scale tests, it was found that accumulation of SBW in the bottom of the bed significantly reduced the separation efficiency. In this study, stirring was shown to be effective in preventing this accumulation. Flexible sheet materials such as paper and film plastics also significantly decreased the separation efficiency. In batch-scale tests, an overall efficiency of 90% was obtained when flexible materials such as film plastics and paper were excluded from the feed SBW. In continuous feeding tests, purities of the float and sink fractions attained 95% and 86% efficiencies, respectively, with an overall efficiency of 79%. The effect of feedstock shape on separation efficiency was also investigated. This study revealed that large particles can be properly separated on the basis of density, while the shape of the material significantly influenced behavior in the fluidizing bed.
On-line analysis of trace and bulk gas compounds in the burning chamber of a waste-incineration plant has been performed, with high temporal resolution, by use of a variety of distinctly different measurement techniques. Time-of-flight mass spectrometry was performed with simultaneous use of three ionization techniques-resonance-enhanced multiphoton ionization (REMPI), single-photon ionization (SPI), and electron-impact ionization (EI). Chemical-ionization mass spectrometry (CIMS), Fourier-transform infrared spectrometry (FTIR), and electrochemical methods were also used. Sampling was conducted by means of a newly developed air-cooled stainless steel lance, to cope with the high temperatures and elevated particle concentrations at the sampling location. Nitrogen species were mainly nitrogen monoxide, ammonia, and hydrogen cyanide (HCN), with a small amount (approximately 0.3%) of aromatic nitrogen compounds. NO, NH(3), and HCN are the main contributors to the NO(x)-formation process in the postulated fuel-NO reaction scheme dominant at this location. The NO recycling process thereby plays a major role. Changes in plant operating conditions have a noticeable impact only when the air supply is varied. For example, reduction of oxygen leads to an increase in the HCN fraction of the total nitrogen content and a decrease in the NO fraction, and vice versa.
This work addresses the behavior, fate and/or partitioning of six targeted (Cd, Pb, Cr, Cu, Zn and Ni) heavy metals (HMs) in the incineration of sludges and waste in a bubbling fluidized bed (BFB) of 15 cm i.d. and 5.2m high followed by a filter chamber operated at 750-760 degrees C with a commercial ceramic filter. This paper presents three different things: (1) an in depth review of the published work relating to the problem of partitioning of the HMs in BFBs, (2) some more experimental incineration tests regarding the influence of the temperature of the bed of the BFB and the effect of the chlorine content in the feedstock on the partitioning of the HMs, and (3) the modelling of the partitioning of the HMs in the exit flows: bottom ash, coarse fly ashes, fine fly ash and vapour phase. The partitioning of the HMs is governed by fluid dynamic principles together with the kinetics of the diffusion of the HMs inside the ash particles and the kinetics of the reactions between the HMs and the components of the matrix of the ash. Some thermodynamic predictions do not fit the results from the BFB incinerator well enough because equilibria are not reached in at least three exit ash flows: coarse fly ash, fine fly ash and submicron particles. The residence time of these ash particles in these type of incinerators is very short and most of the HMs have no time to diffuse out of the ash particle. Finally, an examination was made on how in the ceramic hot filter the partition coefficients for the HMs increased, mainly for Cd and Pb, when the Cl-content in the feedstock was increased.