PubMed Health⌕ Search

PubMed · 12673766

Optimization-based framework for inferring and testing hypothesized metabolic objective functions.

Abstract

An optimization-based framework is introduced for testing whether experimental flux data are consistent with different hypothesized objective functions. Specifically, we examine whether the maximization of a weighted combination of fluxes can explain a set of observed experimental data. Coefficients of importance (CoIs) are identified that quantify the fraction of the additive contribution of a given flux to a fitness (objective) function with an optimization that can explain the experimental flux data. A high CoI value implies that the experimental flux data are consistent with the hypothesis that the corresponding flux is maximized by the network, whereas a low value implies the converse. This framework (i.e., ObjFind) is applied to both an aerobic and anaerobic set of Escherichia coli flux data derived from isotopomer analysis. Results reveal that the CoIs for both growth conditions are strikingly similar, even though the flux distributions for the two cases are quite different, which is consistent with the presence of a single metabolic objective driving the flux distributions in both cases. Interestingly, the CoI associated with a biomass production flux, complete with energy and reducing power requirements, assumes a value 9 and 15 times higher than the next largest coefficient for the aerobic and anaerobic cases, respectively.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Anthony P Burgard, Costas D Maranas. 2003-06-20. Optimization-based framework for inferring and testing hypothesized metabolic objective functions.. https://doi.org/10.1002/bit.10617

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Degradation of phenol by aerobic granules and isolated yeast Candida tropicalis.

Aerobic granules effectively degrade phenol at high concentrations. This work cultivated aerobic granules that can degrade phenol at a constant rate of 49 mg-phenol/g x VSS/h up to 1,000 mg/L of phenol. Fluorescent staining and confocal laser scanning microscopy (CLSM) tests demonstrated that an active biomass was accumulated at the granule outer layer. A strain with maximum ability to degrade phenol and a high tolerance to phenol toxicity isolated from the granules was identified as Candida tropicalis via 18S rRNA sequencing. This strain degrades phenol at a maximum rate of 390 mg-phenol/g x VSS/h at pH 6 and 30 degrees C, whereas inhibitory effects existed at concentrations >1,000 mg/L. The Haldane kinetic model elucidates the growth and phenol biodegradation kinetics of the C. tropicalis. The fluorescence in situ hybridization (FISH) and CLSM test suggested that the Candida strain was primarily distributed throughout the surface layer of granule; hence, achieving a near constant reaction rate over a wide range of phenol concentration. The mass transfer barrier provided by granule matrix did not determine the reaction rates for the present phenol-degrading granule.

Aerobiosis↗

A new approach for the recovery of precious metals from solution and from leachates derived from electronic scrap.

A new approach is described for the recovery of precious metals (PMs: Au, Pd and Ag) with >99% efficiency from aqueous solution utilising biogas produced during the aerobic growth of Klebsiella pneumoniae. Gold was recovered from electronic scrap leachate ( approximately 95%) by this method, with some selectivity against Cu. The recovered PM solids all contained metal and sulphur as determined by energy dispersive X-ray microanalysis (EDX). X-ray powder diffraction analysis (XRD) showed no crystalline metal sulphur compounds but a crystalline palladium amine was recorded. Silver was recovered as a sulphide (found by EDX), carbonate and oxide (found by XRD). EDX analysis of the Au-precipitate showed mainly gold and sulphur, with some metallic Au(0) detected by XRD. The gold compound was shock-sensitive; upon grinding it detonated to leave a sooty black deposit.

Aerobiosis↗

Engineering promoter regulation.

Systems for easily controlled, conditional induction or repression of gene expression are indispensable tools in fundamental research and industrial-scale biotechnological applications. Both native and rationally designed inducible promoters have been widely used for this purpose. However, inherent regulation modalities or toxic, expensive or inconvenient inducers can impose limitations on their use. Tailored promoters with user-specified regulatory properties would permit sophisticated manipulations of gene expression. Here, we report a generally applicable strategy for the directed evolution of promoter regulation. Specifically, we applied random mutagenesis and a multi-stage flow cytometry screen to isolate mutants of the oxygen-responsive Saccharomyces cerevisiae DAN1 promoter. Two mutants were isolated which were induced under less-stringent anaerobiosis than the wild-type promoter enabling induction of gene expression in yeast fermentations simply by oxygen depletion during cell growth. Moreover, the engineered promoters showed a markedly higher maximal expression than the unmutated DAN1 promoter, under both fastidious anaerobiosis and microaerobisois.

Aerobiosis↗