PubMed · 13529161
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
1957-10-20. [Round table discussion].. https://pubmed.ncbi.nlm.nih.gov/13529161/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The current study has investigated the influence of esterase activity (80-400units/ml) on the biodegradation of polycarbonate-urethanes (PCNUs) by cholesterol esterase (CE), with a particular interest in studying the influence of different hard segment structures and their contribution to sensitizing the polymer towards enzyme catalyzed hydrolysis. Polycarbonate based polyurethanes were synthesized with varying hard segment content as well as hard segment chemistry based on three different diisocyanates, 1,6-hexane diisocyanate (HDI), 4,4'-methylene bisphenyl diisocyanate (MDI) and 4,4-methylene biscyclohexyl diisocyanate (HMDI). The effect of different chemistry on surface contact angle was measured in order to define the relative chemical nature of the surfaces. The enzyme dose response was found to be lower when hard segment content in the polymer was high. There was a very strong dependence on enzyme concentration for polyurethanes with different hard segment chemistry, despite the fact that the nature of the hydrolysable polycarbonate segment remained the same. The PCNU which showed the most dramatic dependence on enzyme concentration was synthesized with HMDI. At low enzyme concentration (80units/ml) this material was the most stable of the polymers while at elevated CE concentration (400units/ml) the polymer underwent a catastrophic breakdown. The findings suggested that protein binding on the surfaces was saturated even though enzyme degradation did not achieve saturation on any of the surfaces. The role of protein binding in modulating the hydrolytic action of the enzymes at different activity levels highlights a need for further study in this area.
Various aliphatic and aromatic [(75)Se]selenoethers were prepared at the no-carrier-added (n.c.a.) level using a new radiosynthetic pathway, based on the formation of alkyl[(75)Se]selenocyanates as intermediates. Using one-pot model reactions of elemental (75)Se, sodium cyanide and various alkylbromides in ethanol, the preparation of alkyl[(75)Se]selenocyanates was examined and optimized. Purification of these (75)Se-labeled intermediates and subsequent conversion with alkyl and aryl lithium or Grignard compounds in anhydrous diethyl ether yielded radioselenoethers with radiochemical yields of up to 55% (related to (75)Se(0)) within an overall reaction time of 20 min. This is the first method described to obtain n.c.a. arylselenoethers.
The effect of the sodium cyanate-induced carbamylation (carbamoylation) of proteins in erythrocytes was studied using spin labelling and spectrophotometric methods. The experiments were conducted in whole blood and in erythrocytes in phosphate buffer using 25 mmol/L of sodium cyanate. Lipid membrane fluidity was determined using three spin-labelled fatty acids: 5-, 12- and 16-doxylstearic acids (5-DS, 12-DS, 16-DS). Internal viscosity was measured with Tempamine, using also EPR spectroscopy. Osmotic fragility was determined spectrophotometrically. Incubation of whole blood with sodium cyanate led to an increase in lipid membrane fluidity in the deeper region of the lipid layer, indicated by 12- and 16-doxylstearic acid, and a decrease near the surface (5-DS). Statistically significant results were obtained for the internal viscosity and osmotic fragility of erythrocytes. An increase in internal viscosity and increase in osmotic fragility were found in erythrocytes after incubation of whole blood, as well as in erythrocytes incubated with sodium cyanate in buffer. Alterations in internal viscosity were stronger in erythrocytes incubated with sodium cyanate in blood than in erythrocytes in the buffer. On the other hand, higher osmotic fragility was observed for erythrocytes in the buffer.